[PATCH] ARM: kirkwood: Add support for NETGEAR ReadyNAS Duo v2 using DT

[arno@natisbad.org (Arnaud Ebalard)]

Hi Andrew and Jason,

Jason, I have taken your comments into account.

Andrew Lunn <andrew@lunn.ch> writes:

> Hi Arnaud
>
>> +
>> +		thermal at 10078 {
>> +			compatible = "marvell,kirkwood-thermal";
>> +			reg = <0x10078 0x4>;
>> +			status = "okay";
>> +		};
>
> This should not be needed. All 6282 have the thermal sensor, so the
> kirkwood-6282.dtsi will contain this. For 3.9 we submitted the DT
> change too late, so it did not make it in, but for 3.10 it should be
> there.

Understood, will remove it.


>> +void __init netgear_readynas_init(void)
>> +{
>> +	u32 val;
>> +
>> +	kirkwood_ge00_init(&netgear_readynas_ge00_data);
>> +	kirkwood_pcie_init(KW_PCIE0);
>> +
>> +	/* USB 3.0 controller power on */
>> +	mdelay(3000);
>> +	val = readl(GPIO_HIGH_VIRT_BASE + 0x4);
>> +	writel(val & ~(0x1 << 14), GPIO_HIGH_VIRT_BASE + 0x4);
>> +	val = readl(GPIO_HIGH_VIRT_BASE);
>> +	writel(val | (0x1 << 14), GPIO_HIGH_VIRT_BASE);
>
> As Jason said, you can use a fixed regulator, in DT. Something like:
>
>         regulators {
>                 compatible = "simple-bus";
>                 #address-cells = <1>;
>                 #size-cells = <0>;
>
>                 usb_power: regulator at 1 {
>                         compatible = "regulator-fixed";
>                         reg = <1>;
>                         regulator-name = "USB Power";
>                         regulator-min-microvolt = <5000000>;
>                         regulator-max-microvolt = <5000000>;
>                         enable-active-high;
>                         regulator-always-on;
>                         regulator-boot-on;
>                         gpio = <&gpio0 14 0>;
>                 };
>         };

Thanks for providing this to bootstrap with. Tomorrow, I will test if it
works and report results.


> Is the mdelay() really required?

It was in NETGEAR's kernel (heavily patched 2.6.31.8) and thought people
who wrote the code had reasons (documentation) to put it here but I will
check if it is needed.

Thanks for your time,

Cheers,

a+