From mboxrd@z Thu Jan 1 00:00:00 1970 From: khilman@linaro.org (Kevin Hilman) Date: Wed, 29 May 2013 11:34:07 -0700 Subject: [PATCH] ARM: EXYNOS: Update defconfig for Arndale and Origen board In-Reply-To: <51A57D39.8030506@linaro.org> (Tushar Behera's message of "Wed, 29 May 2013 09:29:53 +0530") References: <1368168599-28507-1-git-send-email-tushar.behera@linaro.org> <87sj1qzaov.fsf@linaro.org> <5191AA89.6010901@linaro.org> <20130528231740.GA28879@quad.lixom.net> <51A57D39.8030506@linaro.org> Message-ID: <87mwrd63fk.fsf@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Tushar Behera writes: [...] > The patches are at [1]. There are a total of 6 patches on top of > v3.10-rc3. 3 of them (a, b, d) are queued for 3.10-rc4 and another patch > (c) is just a defconfig hack to get Arndale booting. Remaining 2 patches > (e, f) are required to reset the hub during EHCI initialization. > > a. ARM: exynos: defconfig update > b. ARM: EXYNOS: Update defconfig for Arndale and Origen board > c. [TEMP] ARM: EXYNOS: Set low-level UART port to 2 > d. ARM: dts: Enabling samsung-usb2phy driver for exynos5250 > e. usb: ehci-s5p: add the HSIC port initialization > f. ARM: dts: Add USB gpio entries for Arndale board > > I am not sure whether such kind of board-specific patches (e, f) are > appreciated in the drivers. But that is all we need to get USB and > Ethernet to work on v3.10-rc3 kernel. I confirm that using v3.10-rc3 + these patches, the wired network is working on Arndale. Thanks, Kevin