From mboxrd@z Thu Jan 1 00:00:00 1970 From: gregory.clement@free-electrons.com (Gregory CLEMENT) Date: Tue, 23 May 2017 16:24:53 +0200 Subject: [PATCH 2/2] arm64: marvell: dts: add second 1G port on the Armada 8040 DB In-Reply-To: <1494890913-8360-3-git-send-email-mw@semihalf.com> (Marcin Wojtas's message of "Tue, 16 May 2017 01:28:33 +0200") References: <1494890913-8360-1-git-send-email-mw@semihalf.com> <1494890913-8360-3-git-send-email-mw@semihalf.com> Message-ID: <87zie3wszu.fsf@free-electrons.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Marcin, On mar., mai 16 2017, Marcin Wojtas wrote: > Armada 8040 DB is equipped with 4 (2x 10G SFI + 2x 1G RGMII) > ethernet ports of which only one was hitherto enabled. > Because currently mvpp2 driver is capable of supporting only > 1G RGMII/SGMII, enable second port from CP slave HW block. > Applied on mvebu/dt64 Thanks, Gregory > Signed-off-by: Marcin Wojtas > --- > arch/arm64/boot/dts/marvell/armada-8040-db.dts | 16 ++++++++++++++++ > 1 file changed, 16 insertions(+) > > diff --git a/arch/arm64/boot/dts/marvell/armada-8040-db.dts b/arch/arm64/boot/dts/marvell/armada-8040-db.dts > index dc0d084..3cde649 100644 > --- a/arch/arm64/boot/dts/marvell/armada-8040-db.dts > +++ b/arch/arm64/boot/dts/marvell/armada-8040-db.dts > @@ -169,6 +169,22 @@ > status = "okay"; > }; > > +&cps_mdio { > + phy0: ethernet-phy at 0 { > + reg = <0>; > + }; > +}; > + > +&cps_ethernet { > + status = "okay"; > +}; > + > +&cps_eth1 { > + status = "okay"; > + phy = <&phy0>; > + phy-mode = "rgmii-id"; > +}; > + > &ap_sdhci0 { > status = "okay"; > bus-width = <4>; > -- > 1.8.3.1 > -- Gregory Clement, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com