Re: [PATCH v2 3/3] arm64: dts: ti: Add support for J742S2 EVM board

[Andrew Davis <afd@ti.com>]

On 7/30/24 2:13 AM, Manorit Chawdhry wrote:
> J742S2 EVM board is designed for TI J742S2 SoC. It supports the following
> interfaces:
> * 16 GB DDR4 RAM
> * x2 Gigabit Ethernet interfaces capable of working in Switch and MAC mode
> * x1 Input Audio Jack, x1 Output Audio Jack
> * x1 USB2.0 Hub with two Type A host and x1 USB 3.1 Type-C Port
> * x1 4L PCIe connector
> * x1 UHS-1 capable micro-SD card slot
> * 512 Mbit OSPI flash, 1 Gbit Octal NAND flash, 512 Mbit QSPI flash,
>    UFS flash.
> * x6 UART through UART-USB bridge
> * XDS110 for onboard JTAG debug using USB
> * Temperature sensors, user push buttons and LEDs
> * x1 GESI expander, x2 Display connector
> * x1 15-pin CSI header
> * x6 MCAN instances
> 
> Link: https://www.ti.com/lit/ug/sprujd8/sprujd8.pdf (EVM user guide)
> Link: https://www.ti.com/lit/zip/SPAC001 (Schematics)
> Signed-off-by: Manorit Chawdhry <m-chawdhry@ti.com>
> ---
>   arch/arm64/boot/dts/ti/Makefile                  |    3 +
>   arch/arm64/boot/dts/ti/k3-j742s2-evm.dts         |   26 +
>   arch/arm64/boot/dts/ti/k3-j784s4-evm-common.dtsi | 1436 +++++++++++++++++++++

Seems git is not seeing that this is a copy.
When you do format-patch try using "-C".

Andrew