messages from 2011-02-01 10:51:07 to 2011-02-02 16:04:08 UTC [more...]
[patch 0/5] Genesi Efika MX/SB support improvements
2011-02-02 16:04 UTC (11+ messages)
` [patch 1/5] Introduce EFIKA_COMMON
` [patch 2/5] efikamx: add usb h1 support
` [patch 3/5] efikamx: add mc13892 support / implement power off
` [patch 4/5] efika: enable cpufreq
` [patch 5/5] mx51: add support for efika smartbook
ARM unaligned MMIO access with attribute((packed))
2011-02-02 16:00 UTC
[PATCH v1 0/4] davinci: Add SPI support for da8xx platforms
2011-02-02 15:37 UTC (17+ messages)
` [PATCH v1 1/4] davinci: da8xx/omap-l1: add support for SPI
` [PATCH v1 2/4] davinci: add spi devices support for MityDSP-L138/MityARM-1808 platform
` [PATCH v1 3/4] davinci: add spi devices support for da850/omap-l138/am18x evm
` [PATCH v1 4/4] davinci: add spi devices support for da830/omap-l137/am17x evm
[PATCHv8 00/12] Contiguous Memory Allocator
2011-02-02 14:58 UTC (4+ messages)
` [PATCHv8 07/12] mm: cma: Contiguous Memory Allocator added
[PATCH] omap: use fncpy to copy the PM code functions to SRAM
2011-02-02 14:45 UTC
[PATCH v2] ARM: kexec: selective MMU identity mapping
2011-02-02 14:43 UTC
[PATCH] EDB93xx: Add support for CS4271 CODEC on EDB93xx boards
2011-02-02 13:26 UTC (9+ messages)
` [alsa-devel] "
[PATCH] ARM: S3C64XX: Staticise non-exported GPIO to interrupt functions
2011-02-02 13:22 UTC
[PATCH 0/2] ARM: mxs: add flexcan support
2011-02-02 12:50 UTC (3+ messages)
` [PATCH 1/2] ARM: mxs: adjust flexcan clock definition
` [PATCH 2/2] ARM: mxs: dynamically register flexcan devices for mx28
[PATCH v6 0/6] OMAP: McSPI: Hwmod adaptation + runtime conversion
2011-02-02 12:22 UTC (7+ messages)
` [PATCH v6 1/6] OMAP2420: hwmod data: Add McSPI
` [PATCH v6 2/6] OMAP2430: "
` [PATCH v6 3/6] OMAP3: "
` [PATCH v6 4/6] OMAP4: "
` [PATCH v6 5/6] OMAP: devices: Modify McSPI device to adapt to hwmod framework
` [PATCH v6 6/6] OMAP: runtime: McSPI driver runtime conversion
[PATCH v4 0/4] Introduce hardware spinlock framework
2011-02-02 12:11 UTC (11+ messages)
` [PATCH v4 1/4] drivers: hwspinlock: add framework
[PATCH v1 0/9] pruss mfd drivers
2011-02-02 12:08 UTC (17+ messages)
` [PATCH v1 1/9] mfd: pruss mfd driver
` [PATCH v1 2/9] da850: pruss board specific additions
` [PATCH v1 3/9] da850: pruss platform "
` [PATCH v1 4/9] can: pruss CAN driver
` [PATCH v1 5/9] da850: pruss CAN board specific additions
` [PATCH v1 6/9] da850: pruss CAN platform "
` [PATCH v1 7/9] mfd: pruss CAN private data
` [PATCH v1 8/9] da850: pruss CAN board specific changes for gpios
` [PATCH v1 9/9] da850: pruss CAN platform "
[PATCH v5 0/4] Introduce hardware spinlock framework
2011-02-02 12:04 UTC (5+ messages)
` [PATCH v5 1/4] drivers: hwspinlock: add framework
` [PATCH v5 2/4] drivers: hwspinlock: add OMAP implementation
` [PATCH v5 3/4] OMAP4: hwmod data: Add hwspinlock
` [PATCH v5 4/4] omap: add hwspinlock device
[PATCHv4 00/13] ARM: add initial support for Picochip picoXcell SoC
2011-02-02 12:03 UTC (14+ messages)
` [PATCHv4 01/13] picoxcell: add support for picoXcell
` [PATCHv4 02/13] picoxcell: add support for AXI bus snoopers
` [PATCHv4 03/13] picoxcell: add support for the system timers
` [PATCHv4 04/13] picoxcell: add a pin muxing infrastructure
` [PATCHv4 05/13] picoxcell: add gpio infrastructure
` [PATCHv4 06/13] picoxcell: add support for system clks
` [PATCHv4 07/13] picoxcell: add common SoC devices
` [PATCHv4 08/13] picoxcell: add cpufreq support
` [PATCHv4 09/13] picoxcell: add support for pm
` [PATCHv4 10/13] picoxcell: add chained GPIO IRQ handlers
` [PATCHv4 11/13] picoxcell: add support for pc3x2 devices
` [PATCHv4 12/13] picoxcell: add support for pc3x3 devices
` [PATCHv4 13/13] picoxcell: add support for the PC7302 development board
[PATCH] OMAP1: Fix non-working LCD on OMAP310
2011-02-02 11:13 UTC
[PATCH] RFC: ux500: add PMU resources
2011-02-02 9:52 UTC (2+ messages)
[PATCH] mmci: restrict DMA usage to large, even multiblock transfers
2011-02-02 9:39 UTC (11+ messages)
[PATCH 0/6] omap4: prcm: Few dpll, clockdomain and powerdomain updates
2011-02-02 9:24 UTC (13+ messages)
` [PATCH 1/6] omap4: powerdomain: Add supported INACTIVE power state
` [PATCH 2/6] omap4: prcm: Fix the CPUx clockdomain offsets
` [PATCH 3/6] omap4: powerdomain: Use intended PWRSTS_* flags instead of values
[to be tested] [PATCH] at91: switch to CLKDEV_LOOKUP
2011-02-02 6:27 UTC
FW: [PATCH v2 4/6] arm/dt: probe for platforms via the device tree
2011-02-02 6:21 UTC
[PATCH] omap4: Fix ULPI PHY init for ES1.0 SDP (Re: 4430SDP boot failure)
2011-02-02 6:05 UTC (4+ messages)
[PATCH v2] OMAP: hwmod: Do not expect an entry in clkdev for opt_clks
2011-02-02 5:55 UTC
fixes to the p2v series
2011-02-02 5:00 UTC
[PATCH v2 0/6] Basic ARM device support
2011-02-02 4:16 UTC (4+ messages)
` [PATCH v2 2/6] arm/dt: Allow CONFIG_OF on ARM
advice needed on how best to fix kirkwood kexec
2011-02-02 4:11 UTC (2+ messages)
[PATCH] ARM: map ATAGs when not in first 1MB of RAM
2011-02-02 3:26 UTC (2+ messages)
Locking in the clk API, part 2: clk_prepare/clk_unprepare
2011-02-02 2:31 UTC (26+ messages)
Unable to ioremap a SZ_64M region
2011-02-02 1:15 UTC
[PATCHv5] OMAP3: Devkit8000: Change lcd power pin
2011-02-02 0:04 UTC (3+ messages)
[PATCH] arm: mach-omap2: board-rm680: fix rm680_vemmc regulator constraints
2011-02-01 23:52 UTC (3+ messages)
[PATCH] arm: mach-omap2: mux: free allocated memory on error exit
2011-02-01 23:52 UTC (2+ messages)
[PATCH] mmci: calculate remaining bytes at error correctly
2011-02-01 23:40 UTC (6+ messages)
[RFC PATCH 0/5] arm/dt: register devices from device tree
2011-02-01 22:42 UTC (3+ messages)
` [RFC PATCH 3/5] of: add clock providers
[PATCH] OMAP2+: remove unused UART base addresses from omap_globals
2011-02-01 22:24 UTC (2+ messages)
[PATCH] arm: mach-omap2: potential NULL dereference
2011-02-01 22:22 UTC (4+ messages)
` [PATCH v2] "
[PATCH v2 2/2] OMAP3: beagle xm: enable upto 800MHz OPP
2011-02-01 22:01 UTC (2+ messages)
[PATCH 0/2] OMAP3: Beagle: enable 800MHz for xm
2011-02-01 22:01 UTC (3+ messages)
` [PATCH 1/2] omap3|4: opp: make omapx_opp_init non-static
iMX31 MBX registers Porting problem
2011-02-01 21:29 UTC (7+ messages)
[PATCH 1/2 v1] davinci: support disabling modem status interrupts on SOC UARTS
2011-02-01 20:53 UTC (3+ messages)
[PATCH] ARM: pxa: Properly configure PWM period for palm27x
2011-02-01 18:18 UTC
[PATCH] arm: Improve MMC performance on Versatile Express
2011-02-01 17:25 UTC (7+ messages)
[PATCH] arm: Improve MMC performance on Versatile Express
2011-02-01 17:25 UTC (14+ messages)
[PATCH v2] i.MX51 Framebuffer support
2011-02-01 16:47 UTC (10+ messages)
` [PATCH 3/9] Add a mfd IPUv3 driver
[PATCH] ARM: add PrimeCell generic DMA to MMCI/PL180
2011-02-01 14:15 UTC (12+ messages)
[PATCH] mmci: make sure DMA transfers wait for FIFO drain
2011-02-01 14:11 UTC (3+ messages)
[PATCH v2 00/28] Updates for Tegra support in 2.6.39
2011-02-01 13:03 UTC (3+ messages)
` [PATCH v2 02/28] ARM: gic: Add functions to save and restore gic state
[PATCH 0/4] davinci: Add SPI support for da8xx platforms
2011-02-01 13:01 UTC (14+ messages)
` [PATCH 1/4] davinci: da8xx/omap-l1: add support for SPI
` [PATCH 2/4] davinci: add spi devices support for MityDSP-L138/MityARM-1808 platform
` [PATCH 3/4] davinci: add spi devices support for da850/omap-l138/am18x evm
` [PATCH 4/4] davinci: add spi devices support for da830/omap-l137/am17x evm
[PATCH] mmci: don't try DMA on anything <= fifosize
2011-02-01 12:21 UTC
i.MX ehci phy init cleanup
2011-02-01 11:18 UTC (6+ messages)
` [PATCH 1/5] ARM i.MX ehci: factor out soc specific functions
` [PATCH 2/5] ARM i.MX ehci: do ehci init in board "
` [PATCH 3/5] USB ehci-mxc: make ahb clock optional on all i.MX SoCs
` [PATCH 4/5] ARM i.MX51/53: register usb phy clock as usb_phy
` [PATCH 5/5] USB ehci-mxc: make phy clock optional on all i.MX SoCs
[patch 1/1] t5325: add audio support
2011-02-01 10:51 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).