messages from 2011-06-27 23:36:26 to 2011-06-29 09:00:32 UTC [more...]
[PATCH] MTD: pxa3xx_nand: enable multiple chip select support
2011-06-29 9:00 UTC (17+ messages)
` [PATCH V3 0/9] pxa3xx_nand: add two "
` [PATCH 1/9] MTD: pxa3xx_nand: convert all printk into dev_*
` [PATCH 2/9] MTD: pxa3xx_nand: enable multiple chip select support
` [PATCH 3/9] ARM: aspenite: fix nand platform data
` [PATCH 4/9] ARM: cm-x300: "
` [PATCH 5/9] ARM: colibri-pxa3xx: "
` [PATCH 6/9] ARM: littleton: "
` [PATCH 7/9] ARM: mxm8x10: "
` [PATCH 8/9] ARM: raumfeld: "
` [PATCH 9/9] ARM: zylonite: "
[next][bug] rcu_dyntick_kick_cpu() kills ARM SMP
2011-06-29 8:58 UTC (3+ messages)
[RFC] implement a generic PWM framework - once again
2011-06-29 8:50 UTC (11+ messages)
` [PATCH 1/2] PWM: add pwm framework support
` [PATCH 2/2] pwm: Add a i.MX23/28 pwm driver
[PATCH v7 0/3] add the GPMI controller driver for IMX23/IMX28
2011-06-29 8:24 UTC (5+ messages)
` [PATCH v7 1/3] MTD : add the common code for GPMI-NFC controller driver
` [PATCH v7 2/3] MTD : add support for imx23 and imx28
` [PATCH v7 3/3] MTD : add GPMI-NFC driver in the config and Makefile
[PATCH V4 0/3] add the GPMI-NFC support for imx23/imx28
2011-06-29 8:21 UTC (7+ messages)
` [PATCH V4 1/3] ARM: mxs: add "
` [PATCH V4 2/3] ARM: mxs: add GPMI-NFC device for imx23
` [PATCH V4 3/3] ARM: mxs: add GPMI-NFC device for imx28
[PATCH] omap: cleanup NAND platform data
2011-06-29 8:12 UTC (4+ messages)
[PATCH 0/2] RFC: gpio: driver-local pin configuration
2011-06-29 7:39 UTC (8+ messages)
[PATCH] arm: mxs: include asm/processor.h for cpu_relax()
2011-06-29 7:10 UTC (2+ messages)
[RFC 0/8] Introducing a generic AMP/IPC framework
2011-06-29 6:30 UTC (25+ messages)
` [RFC 5/8] remoteproc: add davinci implementation
` [RFC 6/8] davinci: da850: add remoteproc dsp device
` [RFC 1/8] drivers: add generic remoteproc framework
` [RFC 7/8] drivers: introduce rpmsg, a remote-processor messaging bus
[PATCH] ARM: mx53: Fix some interrupts marked as reserved
2011-06-29 6:27 UTC (2+ messages)
[PATCH] ARM: exynos4: fix secondary CPU boot
2011-06-29 5:52 UTC (13+ messages)
[PATCH 0/7] ARM: EXYNOS4: Update PM
2011-06-29 4:58 UTC (6+ messages)
` [PATCH 4/7] ARM: EXYNOS4: Support early wakeup while entering sleep mode
[PATCH] [CPUFREQ] S3C6410: Add some lower frequencies for 800MHz base clock operation
2011-06-29 3:26 UTC
[RFC PATCH 0/4] ARM: make mach/hardware.h optional
2011-06-29 2:41 UTC (10+ messages)
` [PATCH 1/4] microblaze: move pci flag functions into asm-generic
` [PATCH 2/4] ARM: remove unnecessary mach/hardware.h includes
` [PATCH 3/4] ARM: pci: make pcibios_assign_all_busses use pci_has_flag
` [PATCH 4/4] ARM: convert PCI defines to variables
[PATCH v2 1/2] OMAP: 4430SDP: Register the card detect GPIO properly
2011-06-29 2:14 UTC (2+ messages)
` [PATCH v2 2/2] OMAP: HSMMC: Fix GPIO muxing
[PATCH] OMAP: HSMMC: Fix GPIO muxing
2011-06-29 1:26 UTC (4+ messages)
[PATCHv2] omap2+: pm: cpufreq: Fix loops_per_jiffy calculation
2011-06-28 23:59 UTC (14+ messages)
[PATCH 0/1 repost] mmc, ARM: Add zboot from eSD support for SuperH Mobile ARM
2011-06-28 23:10 UTC (2+ messages)
` [PATCH] "
IRQS off tracer - is it useful or not?
2011-06-28 23:08 UTC (2+ messages)
Problem with GDB when debugging IRQ handlers
2011-06-28 22:26 UTC (21+ messages)
[PATCH] ARM: mach-s3c24a0: delete
2011-06-28 21:53 UTC (9+ messages)
[RFC 0/2] ARM: Tegra: Device Tree: Audio
2011-06-28 21:39 UTC (10+ messages)
` [RFC 2/2] ARM:Tegra: Device Tree Support: Initialize audio card gpio's from the device tree
[PATCH 0/5] remove spi-s3c24xx-gpio driver
2011-06-28 21:24 UTC (7+ messages)
` [PATCH 1/5] mach-jive: convert to spi_gpio
` [PATCH 2/5] mach-qt2410: "
` [PATCH 3/5] mach-gta2: remove unused spi-gpio.h include
` [PATCH 4/5] spi: remove obsolete spi-s3c24xx-gpio driver
` [PATCH 5/5] mach-s3c2410: remove unused spi-gpio.h file
[PATCH v5 0/1] pruss mfd drivers
2011-06-28 21:01 UTC (3+ messages)
` [PATCH v5 1/1] drivers:staging:pruss: add pruss staging mfd driver
Git pull request: 64-bit atomic user helper
2011-06-28 20:41 UTC (4+ messages)
[PATCH] omap: iommu: fix pte attributes for super section
2011-06-28 19:46 UTC (3+ messages)
[PATCH] USB: ehci: use packed, aligned(4) instead of removing the packed attribute
2011-06-28 18:51 UTC (5+ messages)
[PATCH 0/3] Add generic idle notifiers
2011-06-28 18:28 UTC (7+ messages)
` [PATCH 1/3] Move x86_64 idle notifiers to generic
` [PATCH 2/3] ARM: Call idle notifiers
` [PATCH 3/3] ARM: Move leds idle start/stop calls to "
[PATCH] AT91: add AT91SAM9X5 dummy configuration variable
2011-06-28 16:03 UTC (6+ messages)
[PATCH V2 0/3] Add drivers/pwm and drivers/pwm/st_pwm.c
2011-06-28 15:13 UTC (5+ messages)
[PATCH V2] davinci: da850: move input frequency to board specific files
2011-06-28 15:10 UTC (4+ messages)
` [PATCH] davinci: da850: add a .set_rate method to ref_clk
` [PATCH v2] "
[RFC PATCH] MTD: atmel_nand: optimize read/write buffer functions
2011-06-28 14:59 UTC (4+ messages)
[PATCH] omap1: select GENERIC_IRQ_CHIP for TI OMAP1
2011-06-28 14:56 UTC (2+ messages)
[PATCH] OMAP1: enable GENERIC_IRQ_CHIP
2011-06-28 14:54 UTC (3+ messages)
[PATCH] ARM: automatically select OMAP3_PMU if we try to use perf on OMAP3
2011-06-28 13:57 UTC (2+ messages)
[PATCH 1/4] ARM: mx53: Add support for missing UARTs
2011-06-28 13:37 UTC (3+ messages)
[PATCH 1/4] davinci: psc.h: clean up indentation done using spaces
2011-06-28 13:24 UTC (5+ messages)
[PATCH] arm: fix regression in ixp4xx clocksource
2011-06-28 13:10 UTC (3+ messages)
[PATCH 1/3] dmaengine: at_hdmac: replace spin_lock* with irqsave variants
2011-06-28 11:17 UTC (4+ messages)
` [PATCH 2/3] dmaengine: at_hdmac: improve power management routines
` [PATCH 3/3] dmaengine: at_hdmac: add slave config operation
[PATCH v3 00/40] ARM: mm: Add generic macros for declaring various CPU structs
2011-06-28 10:53 UTC (2+ messages)
[PATCH 0/1] Add Thread Support for the Context ID Register of ARM v6 & v7 Architectures
2011-06-28 10:29 UTC (5+ messages)
` [PATCH 1/1] "
[PATCH v8 00/12] use nonblock mmc requests to minimize latency
2011-06-28 9:54 UTC (15+ messages)
` [PATCH v8 01/12] mmc: core: add non-blocking mmc request function
` [PATCH v8 02/12] omap_hsmmc: add support for pre_req and post_req
` [PATCH v8 03/12] mmci: implement pre_req() and post_req()
` [PATCH v8 04/12] mmc: mmc_test: add debugfs file to list all tests
` [PATCH v8 05/12] mmc: mmc_test: add test for non-blocking transfers
` [PATCH v8 06/12] mmc: mmc_test: test to measure how sg_len affect performance
` [PATCH v8 07/12] mmc: block: add member in mmc queue struct to hold request data
` [PATCH v8 08/12] mmc: block: add a block request prepare function
` [PATCH v8 09/12] mmc: block: move error code in issue_rw_rq to a separate function
` [PATCH v8 10/12] mmc: queue: add a second mmc queue request member
` [PATCH v8 11/12] mmc: core: add random fault injection
` [PATCH v8 12/12] mmc: block: add handling for two parallel block requests in issue_rw_rq
[PATCH 4/4] mmci: fixup sg buffer handling in pio_write
2011-06-28 7:57 UTC
[PATCH 3/4] mmci: sync DATAEND irq with dma|pio transfer done
2011-06-28 7:57 UTC
[PATCH 2/4] mmci: adjust calculation of f_min
2011-06-28 7:57 UTC
[PATCH 1/4] mmci: use StartBitErr to detect bad connections
2011-06-28 7:57 UTC
[PATCH 0/4] MMCI patches for 3.1
2011-06-28 7:57 UTC
[PATCH 1/1] MXC: iomux-v3: correct NO_PAD_CTRL definition
2011-06-28 7:24 UTC (3+ messages)
[PATCH v6 00/11] mmc: use nonblock mmc requests to minimize latency
2011-06-28 6:22 UTC (5+ messages)
[PATCH] OMAP: 4430SDP: Register the card detect GPIO properly
2011-06-28 5:56 UTC
[PATCH v2] ARM: CSR: Adding CSR SiRFprimaII board support
2011-06-28 3:32 UTC
[PATCH 1/2] gpio-vbus: support disabling D+ pullup on suspend
2011-06-28 2:41 UTC (5+ messages)
[PATCH v2] NET: AX88796: Tighten up Kconfig dependencies
2011-06-28 1:38 UTC (3+ messages)
[PATCH 0/8] Fix module-mode enable sequence on OMAP4
2011-06-27 23:36 UTC (9+ messages)
` [PATCH 1/8] OMAP2+: clockdomain: Add an api to read idle mode
` [PATCH 2/8] OMAP2+: clockdomain: Add SoC support for clkdm_is_idle
` [PATCH 3/8] OMAP2+: PM: Initialise sleep_switch to a non-valid value
` [PATCH 4/8] OMAP2+: PM: idle clkdms only if already in idle
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox