messages from 2011-10-18 15:26:08 to 2011-10-20 12:10:54 UTC [more...]
[PATCH v2 0/5] Device tree support for regulators
2011-10-20 12:10 UTC (20+ messages)
` [PATCH v2 3/5] regulator: helper routine to extract regulator_init_data
[GIT PULL] genirq support for GIC PPIs
2011-10-20 12:05 UTC (3+ messages)
[PATCH] ARM: mxs: Use CLKDEV_INIT for creating clk_lookup instance
2011-10-20 12:03 UTC (2+ messages)
Question about: linux-linaro-2.6.38.7 booting the ubuntu 10.10 filesystem
2011-10-20 12:02 UTC (7+ messages)
[PATCH] mach-kirkwood: Add support for D-Link DNS-325
2011-10-20 11:53 UTC (2+ messages)
` [PATCH V2] "
[PATCH] ARM: tcc8k: Use CLKDEV_INIT for creating clk_lookup instance
2011-10-20 11:51 UTC
[PATCH] ARM: mx5: Use CLKDEV_INIT for creating clk_lookup instance
2011-10-20 11:49 UTC
[PATCH] ARM: lpc32xx: Use CLKDEV_INIT for creating clk_lookup instance
2011-10-20 11:48 UTC
[PATCH] ARM: imx: Use CLKDEV_INIT for creating clk_lookup instance
2011-10-20 11:47 UTC
[PATCH] ARM: ep93xx: Use CLKDEV_INIT for creating clk_lookup instance
2011-10-20 11:46 UTC
[PATCH] ARM: davinci: Use CLKDEV_INIT for creating clk_lookup
2011-10-20 11:44 UTC
Build error while adding debug LL support for new board
2011-10-20 11:39 UTC (2+ messages)
select consuming too much cpu time when changing from kernel 2.6.29 to 2.6.34
2011-10-20 11:37 UTC (2+ messages)
[PATCH] arm: fix handling of nr_cpus
2011-10-20 11:25 UTC (6+ messages)
[PATCH] AT91: Add a driver for the ADC
2011-10-20 9:52 UTC (14+ messages)
` [PATCH 1/3] ARM: AT91: Add platform data for the ADCs
` [PATCH 2/3] ARM: AT91: IIO: Add AT91 ADC driver
` [PATCH 3/3] ARM: AT91: Add the ADC to the sam9g20ek board
[PATCH v7 20/21] OMAP2+: UART: Avoid uart idling on suspend for no_console_suspend usecase
2011-10-20 9:47 UTC (9+ messages)
` [PATCH v7 21/21] OMAP2+: UART: Do not gate uart clocks if used for debug_prints
pinctrl_config APIs, and other pinmux questions
2011-10-20 9:32 UTC (9+ messages)
[PATCH v2] UART: add CSR SiRFprimaII SoC on-chip uart drivers
2011-10-20 8:37 UTC (7+ messages)
[PATCH v4 0/4] genirq: handling GIC per-cpu interrupts
2011-10-20 8:21 UTC (5+ messages)
Possible regression in kexec on ARM ARMv6 and ARMv7 cores
2011-10-20 8:08 UTC (3+ messages)
[RFC] clocktree representation in the devicetree
2011-10-20 7:28 UTC (7+ messages)
CMA v16 and DMA-mapping v13 patch series
2011-10-20 6:01 UTC
parallel load of modules on an ARM multicore
2011-10-20 4:04 UTC (3+ messages)
[PATCH V2] AT91: dt: at91sam9g45 family and board device tree files
2011-10-20 2:06 UTC (7+ messages)
[PATCH 0/3] ARM 4Kstacks: introduction
2011-10-20 1:55 UTC (18+ messages)
` [PATCH 1/3] ARM 4Kstacks: Add support for 4K kernel stacks to ARM
` [PATCH 2/3] ARM: Add static kernel function stack size analyzer, for ARM
` [PATCH 3/3] ARM 4Kstacks: Decrease poll and select stack usage, when using 4K stacks
[patch] ARM: smpboot: Enable interrupts after marking CPU online/active
2011-10-20 0:32 UTC (10+ messages)
[RESEND PATCH] PM / Clocks: Remove redundant NULL checks before kfree()
2011-10-19 23:55 UTC
Getting random Kernel Crash with v3.1-rc8 kernel
2011-10-19 21:25 UTC (2+ messages)
[PATCH v2 0/5] ARM: Add support for the SPMP8000 SoC and Letcool board v2
2011-10-19 20:29 UTC
[RFC] [PATCH] ARM: tegra: emc: device tree bindings
2011-10-19 20:17 UTC (17+ messages)
Add support for the SPMP8000 SoC and Letcool board
2011-10-19 19:15 UTC (7+ messages)
` [PATCH v2 1/5] ARM: SPMP8000: Add machine base files
` [PATCH v2 2/5] ARM: SPMP8000: Add clk support
` [PATCH v2 3/5] ARM: SPMP8000: Add clocksource and clockevent drivers
` [PATCH v2 4/5] ARM: SPMP8000: Add SPMP8000 SoC and Letcool board dts descriptions
` [PATCH v2 5/5] ARM: SPMP8000: Add Kconfig and Makefile entries
[PATCH] arm/dt: Fix ventana SDHCI power-gpios
2011-10-19 16:53 UTC
[PATCH] ARM: OMAP3: cm-t35: fix mux mode for DSS pins
2011-10-19 16:46 UTC
[PATCH 0/6] ux500: Export SoC information and some platform clean-up
2011-10-19 14:45 UTC (5+ messages)
` [PATCH 6/6] mach-ux500: remove intermediary add_platform_device* functions
[PATCH 0/4] ARM: OMAP3: cm-t35/cm-t3730 fixes
2011-10-19 14:01 UTC (9+ messages)
` [PATCH 1/4] ARM: OMAP3: cm-t35: add regulator supply for ads7846
` [PATCH 2/4] ARM: OMAP3: cm-t35: fix DSS regulator supply
` [PATCH 3/4] ARM: OMAP3: cm-t35: fix audio
` [PATCH 3/4 v2] "
` [PATCH 4/4] arm: omap3: cm-t35: add reset for sb-t35 usb hub
` [PATCH 4/4 v2] ARM: OMAP3: "
[PATCH] CPUIdle: Reevaluate C-states under CPU load to favor deeper C-states
2011-10-19 13:11 UTC (2+ messages)
[patch 1/1] iMX: Fix module build
2011-10-19 12:27 UTC (2+ messages)
[PATCH] PM / Clocks: Remove redundant NULL checks before kfree()
2011-10-19 10:24 UTC
[PATCH v2] ARM: mxs: Add initial support for Bluegiga APX4 Development Kit
2011-10-19 10:16 UTC
[PATCH] ARM: kprobes: Fix build error in test code
2011-10-19 9:47 UTC
[PATCH] tty/serial: atmel_serial: bootconsole removed from auto-enumerates
2011-10-19 9:36 UTC
[PATCH] ARM: mach-mxs: fix machines' initializers order
2011-10-19 7:08 UTC (2+ messages)
[GIT PULL] i.MX cleanup patches
2011-10-19 7:07 UTC
[ resend PATCH 1/1] ARM: i.MX28: shift frac value in _CLK_SET_RATE
2011-10-19 6:54 UTC (2+ messages)
Warning at kernel/mutex.c
2011-10-19 6:54 UTC (8+ messages)
[PATCH] mxcuart: add polled io methods
2011-10-19 3:52 UTC (5+ messages)
` [PATCH] imx: add polled io uart methods
[PATCH v2] virtio: Add platform bus driver for memory mapped virtio device
2011-10-19 2:57 UTC (6+ messages)
` [PATCH v3] "
[RFC/PATCH v3 0/7] ARM11 MPCore: preemption/task migration cache coherency fixups
2011-10-19 1:09 UTC (14+ messages)
` [RFC/PATCH v4 "
` [RFC/PATCH v4 4/7] ARM: ARM11 MPCore: clean_dcache_area is not preempt safe
` [RFC/PATCH v4 6/7] ARM: ARM11 MPCore: DMA_CACHE_RWFO operations are "
` [RFC/PATCH v4 7/7] ARM: ARM11 MPCore: cpu_v6_set_pte_ext is "
[PATCH] [3.3] ARM: tegra: use APB DMA for accessing APB devices
2011-10-18 20:15 UTC (7+ messages)
[PATCH] ARM: OMAP: Add support for AM35xx UART4/ttyO3
2011-10-18 18:47 UTC
[PATCH] [3.3] [RESEND] ARM: tegra: fuse: use apbio dma for register access
2011-10-18 18:46 UTC (2+ messages)
[PATCH] ARM: OMAP: Fix early init definitions
2011-10-18 18:43 UTC
[PATCH] [3.3] ARM: tegra: emc: max rate based on emc table
2011-10-18 18:26 UTC (3+ messages)
[PATCHv16 0/9] Contiguous Memory Allocator
2011-10-18 18:00 UTC (6+ messages)
` [PATCH 2/9] mm: alloc_contig_freed_pages() added
[PATCH 0/8 v3] ARM: DMA-mapping framework redesign
2011-10-18 17:19 UTC (9+ messages)
` [PATCH 1/8] ARM: dma-mapping: remove offset parameter to prepare for generic dma_ops
` [PATCH 2/8] ARM: dma-mapping: use asm-generic/dma-mapping-common.h
` [PATCH 3/8] ARM: dma-mapping: implement dma sg methods on top of any generic dma ops
` [PATCH 4/8] ARM: dma-mapping: move all dma bounce code to separate dma ops structure
` [PATCH 5/8] ARM: dma-mapping: remove redundant code and cleanup
` [PATCH 6/8] common: dma-mapping: change alloc/free_coherent method to more generic alloc/free_attrs
` [PATCH 7/8] ARM: dma-mapping: use alloc, mmap, free from dma_ops
` [PATCH 8/8] ARM: dma-mapping: add support for IOMMU mapper
[PATCH v7 15/21] OMAP2+: UART: Make the RX_TIMEOUT for DMA configurable for each UART
2011-10-18 15:35 UTC (5+ messages)
` [PATCH v7 16/21] OMAP2+: UART: Remove custom activate funcs and use generic funcs
` [PATCH v7 17/21] OMAP2+: UART: Remove omap_uart_can_sleep and add pm_qos
` [PATCH v7 18/21] OMAP2+: UART: remove temporary variable used to count uart instance
` [PATCH v7 19/21] OMAP2+: UART: Use custom activate func for console uart
[PATCH v7 14/21] OMAP2+: UART: Allow UART parameters to be configured from board file
2011-10-18 15:34 UTC
[PATCH v7 00/21] OMAP2+: UART: Runtime adaptation + cleanup
2011-10-18 15:26 UTC (2+ messages)
` [PATCH v7 13/21] OMAP2+: UART: Remove old and unused clocks handling funcs
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).