messages from 2026-06-16 20:27:19 to 2026-06-17 03:31:06 UTC [more...]
[PATCH net] net: airoha: Fix TX scheduler queue mask loop upper bound
2026-06-17 3:20 UTC
[PATCH v3] dmaengine: sun6i-dma: Fix memory leak in sun6i_dma_terminate_all
2026-06-17 2:34 UTC
[PATCH v4 0/2] pwm: Add Nuvoton MA35D1 PWM controller support
2026-06-17 2:59 UTC (3+ messages)
` [PATCH v4 1/2] dt-bindings: pwm: Add Nuvoton MA35D1 PWM controller
` [PATCH v4 2/2] pwm: Add Nuvoton MA35D1 PWM controller support
[PATCH 1/3] PCI: rcar-gen4: Configure AXIINTC if iMSI-RX not used
2026-06-17 2:59 UTC (3+ messages)
` [PATCH 2/3] irqchip/gic-v3: Add Renesas R-Car Gen4 erratum workaround
` [PATCH 3/3] arm64: dts: renesas: r8a779g0: Add GICv3 ITS and update PCIe nodes
[PATCH] net: airoha: Fix off-by-one error in HTB rate-limit channel removal
2026-06-17 2:51 UTC
[PATCH] KVM: arm64: nv: Translate vEL2 PSTATE to EL1 in kvm_hyp_handle_mops()
2026-06-17 2:52 UTC (3+ messages)
[PATCH] ARM: smp: Always separate IPI labels from counters
2026-06-17 2:30 UTC
[PATCH v2] dmaengine: sun6i-dma: Fix memory leak in sun6i_dma_terminate_all
2026-06-17 2:28 UTC (3+ messages)
[PATCH v2 00/11] ASoC: fsl: Use guard() for mutex & spin locks
2026-06-17 2:25 UTC (4+ messages)
` [PATCH v2 01/11] ASoC: fsl_asrc: Use guard() for "
[PATCH 0/5] ARM: Basic support for Amazon ford tablet (MT8127)
2026-06-17 2:20 UTC (6+ messages)
` [PATCH 1/5] ARM: dts: mediatek: mt8127: Fix indentation error
` [PATCH 2/5] ARM: dts: mediatek: mt8127: Add watchdog support
` [PATCH 3/5] ARM: dts: mediatek: Add basic support for Amazon ford board
` [PATCH 4/5] dt-bindings: arm: mediatek: Add MT8127 Amazon ford
` [PATCH 5/5] dt-bindings: watchdog: mediatek: Add MT8127
[PATCH v3] clk: mvebu: ap-cpu: fix missing clk_put() in ap_cpu_clock_probe()
2026-06-17 1:41 UTC
[PATCH v2 0/3] Bluetooth: btmtksdio: teardown fixes
2026-06-17 0:56 UTC (5+ messages)
` [PATCH v2 1/3] Bluetooth: btmtksdio: correct btmtksdio_txrx_work() loop timeout check
` [PATCH v2 3/3] Bluetooth: btmtksdio: call cancel_work_sync() outside of host lock scope
[PATCH v6 00/20] dma-mapping: Use DMA_ATTR_CC_SHARED through direct, pool and swiotlb paths
2026-06-17 0:50 UTC (3+ messages)
` [PATCH v6 03/20] dma-direct: use DMA_ATTR_CC_SHARED in alloc/free paths
[PATCH v4] soc: aspeed: lpc-snoop: Fix usercopy overflow in snoop_file_read
2026-06-17 0:44 UTC (3+ messages)
` [PATCH v6] "
[PATCH] net: stmmac: loongson1: Use dev_err_probe()
2026-06-16 23:42 UTC (2+ messages)
[PATCH] PCI: meson: Fix PERST# timing by asserting reset before LTSSM enable
2026-06-16 23:36 UTC (4+ messages)
[PATCH v2] [net] net: airoha: Fix QoS counter configuration for Tx-fwd channels
2026-06-16 22:11 UTC (2+ messages)
[PATCH] net: airoha: Fix QoS counter configuration for Tx-fwd channels
2026-06-16 22:11 UTC (2+ messages)
[PATCH v3 0/3] arm64: cross-CPU NMI via SDEI
2026-06-16 21:38 UTC (3+ messages)
` [PATCH v3 3/3] arm64: escalate smp_send_stop() to an SDEI NMI as a last resort
[PATCH] firmware: arm_ffa: Fix NULL dereference in ffa_partition_info_get()
2026-06-16 21:14 UTC (3+ messages)
[arm-platforms:kvm-arm64/nv3 37/37] arch/arm64/kvm/sys_regs.c:222:30: error: expected ';' after expression
2026-06-16 20:36 UTC
[PATCH RFC v4 00/12] ZTE zx297520v3 clock bindings and driver
2026-06-16 20:26 UTC (10+ messages)
` [PATCH RFC v4 04/12] clk: zte: Add Clock registration infrastructure
` [PATCH RFC v4 05/12] clk: zte: Add zx PLL support infrastructure
` [PATCH RFC v4 06/12] clk: zte: Add regmap based clocks
` [PATCH RFC v4 07/12] clk: zte: Introduce a driver for zx297520v3 top clocks
` [PATCH RFC v4 08/12] clk: zte: Introduce a driver for zx297520v3 matrix clocks
` [PATCH RFC v4 09/12] clk: zte: Introduce a driver for zx297520v3 LSP clocks
` [PATCH RFC v4 10/12] reset: zte: Add a zx297520v3 reset driver
` [PATCH RFC v4 11/12] ARM: dts: zte: Declare zx297520v3 clock device nodes
` [PATCH RFC v4 12/12] ARM: dts: zte: Add a syscon-reboot for zx297520v3 boards
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox