messages from 2026-07-27 19:42:22 to 2026-07-27 21:10:52 UTC [more...]
[RFC v2 PATCH 0/16] Optimize this_cpu_*() ops for non-x86 (ARM64 for this series)
2026-07-27 21:10 UTC (5+ messages)
[PATCH v2 0/4] arm: ras: Add DT frontend support for ARM RAS
2026-07-27 20:51 UTC (3+ messages)
` [PATCH v2 1/4] dt-bindings: arm: ras: Introduce bindings for ARM RAS error sources
[PATCH 0/3] Bluetooth: fix short read errors in usb_control_msg()
2026-07-27 20:50 UTC (2+ messages)
[PATCH v2 0/5] Add support for Broadcom BCM2712 IOMMU driver (Raspberry Pi 5)
2026-07-27 20:44 UTC (6+ messages)
` [PATCH v2 1/5] generic_pt: allow missing sw bit in DMA_INCOHERENT case
` [PATCH v2 2/5] dt-bindings: iommu: Add Broadcom BCM2712 IOMMU
` [PATCH v2 3/5] iommu/generic_pt: Add Broadcom BCM2712 page table format
` [PATCH v2 4/5] iommu: Add Broadcom BCM2712 IOMMU driver
` [PATCH v2 5/5] arm64: dts: broadcom: bcm2712: Add GPU IOMMU and IOMMU cache nodes
[PATCH v2 03/64] dmaengine: apple-admac: use dma_chan BH callback
2026-07-27 20:39 UTC (18+ messages)
` [PATCH v2 04/64] dmaengine: at_xdmac: move irq bottom half to dma_chan BH
` [PATCH v2 08/64] dmaengine: imx-dma: flip per-chan tasklet "
` [PATCH v2 13/64] dmaengine: mxs-dma: use dma_chan BH scheduling
` [PATCH v2 17/64] dmaengine: ste_dma40: convert per-channel tasklet to dma_chan BH
` [PATCH v2 19/64] dmaengine: xilinx-dma: use dma_chan BH instead of tasklets
` [PATCH v2 20/64] dmaengine: xilinx-dpdma: kill vchan BH on remove
` [PATCH v2 21/64] dmaengine: zynqmp-dma: switch completion tasklet to dma_chan BH
` [PATCH v2 33/64] dmaengine: sun6i: kill vchan BH on teardown
` [PATCH v2 34/64] dmaengine: mtk-cqdma: "
` [PATCH v2 43/64] dmaengine: pxa_dma: "
` [PATCH v2 44/64] dmaengine: mtk-hsdma: "
` [PATCH v2 45/64] dmaengine: mtk-uart-apdma: "
` [PATCH v2 46/64] dmaengine: imx-sdma: "
` [PATCH v2 48/64] dmaengine: owl-dma: "
` [PATCH v2 51/64] dmaengine: bcm2835: "
` [PATCH v2 54/64] dmaengine: st_fdma: use dma_chan_kill_bh
` [PATCH v2 62/64] dmaengine: hidma: defer callbacks via channel BH
[PATCH] ARM: dts: BCM5301X: AC9: set WAN MAC from nvram
2026-07-27 20:26 UTC
[PATCH] ARM: dts: BCM5301X: SR400AC: set WAN MAC from nvram
2026-07-27 20:28 UTC
[PATCH] ARM: dts: BCM5301X: DIR-890L: set WAN MAC from nvram
2026-07-27 20:27 UTC
[PATCH v7 0/5] arm64: dts: imx8mp-skov: add new 7" variant
2026-07-27 20:18 UTC (5+ messages)
` [PATCH v7 1/5] arm64: dts: freescale: imx8mp: fix sort order
` [PATCH v7 2/5] dt-bindings: arm: fsl: add base compatible for Skov i.MX8MP revC
[GIT PULL] Broadcom devicetree fixes for 7.2
2026-07-27 20:12 UTC
[PATCH v1 0/4] firmware/clk: arm_scpi hardening (leak, OPP bounds, cpufreq)
2026-07-27 20:06 UTC (8+ messages)
` [PATCH v1 3/4] clk: scpi: bound-check DVFS index in scpi_dvfs_recalc_rate
` [PATCH v1 2/4] firmware: arm_scpi: reject DVFS OPP count above MAX_DVFS_OPPS
` [PATCH v1 4/4] clk: scpi: register scpi-cpufreq once and clear on failure
[PATCH v6 1/7] arm64: dts: imx8mp: Add DT label to SPBA5 bus
2026-07-27 19:52 UTC (7+ messages)
` [PATCH v6 2/7] arm64: dts: imx8mm: imx8mp: Add LVDS DTOs for Data Modul i.MX8M Mini and Plus eDM SBC
` [PATCH v6 3/7] arm64: dts: imx8mm: imx8mp: Add legacy board "
` [PATCH v6 4/7] arm64: dts: imx8mm: imx8mp: Add HDMI "
` [PATCH v6 5/7] arm64: dts: imx8mm: imx8mp: Add CM "
` [PATCH v6 6/7] arm64: dts: imx8mm: imx8mp: Add FIO1 "
` [PATCH v6 7/7] arm64: dts: imx8mm: imx8mp: Add FIO1-Audio "
[v8 PATCH] arm64: mm: show direct mapping use in /proc/meminfo
2026-07-27 19:50 UTC (4+ messages)
[PATCH] pinctrl: samsung: exynos: replace irq_of_parse_and_map with modern APIs
2026-07-27 19:48 UTC
[PATCH net-next] net: phylink: add phylink_pcs_loopback() method for PCS loopback support
2026-07-27 19:46 UTC (3+ messages)
` [PATCH net-next v2] "
[PATCH] mailbox: bcm2835: use platform_get_irq and simplify probe
2026-07-27 19:46 UTC
[PATCH] mailbox: sun6i: modernize probe and convert to fully managed
2026-07-27 19:42 UTC
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox