messages from 2026-10-16 18:59:12 to 2026-10-16 22:37:15 UTC [more...]
[PATCH v2] ARM: rockchip: smp: enable secondary rk3066a/rk3188 CPUs
2026-10-16 22:36 UTC (2+ messages)
[RFC PATCH 0/2] cpu/hotplug: use cpu_enabled_mask for SMT bringup
2026-10-16 21:53 UTC (3+ messages)
` [RFC PATCH 1/2] cpu/hotplug: Skip disabled CPUs in cpuhp_smt_enable
[PATCH v2 00/11] coresight: trbe: Refactor buffer handling and add trigger support
2026-10-16 21:11 UTC (12+ messages)
` [PATCH v2 01/11] coresight: trbe: Remove misleading comment
` [PATCH v2 02/11] coresight: trbe: Refactor next buffer computation
` [PATCH v2 03/11] coresight: trbe: Track trigger count support per CPU
` [PATCH v2 04/11] coresight: trbe: Use trigger mode for buffer maintenance
` [PATCH v2 05/11] coresight: trbe: Leave headroom for stop-on-trigger mode
` [PATCH v2 06/11] coresight: trbe: Save and restore trigger counter
` [PATCH v2 07/11] coresight: trbe: Add KUnit tests for compute normal buffer
` [PATCH v2 08/11] perf cs-etm: Reset decoder on COLLISION flag
` [PATCH v2 09/11] perf cs-etm: Reset per-thread decoder on CPU migration
` [PATCH v2 10/11] perf cs-etm: Reset decoder on AUX offset discontinuity
` [PATCH v2 11/11] perf cs-etm: Set watermark for AUX trace
[net-next,PATCH 1/2] dt-bindings: net: enetc-mdio: Document optional MDC clock
2026-10-16 20:59 UTC (5+ messages)
` [net-next,PATCH 2/2] enetc: Make eMDIO MDC rate configurable from DT
[PATCH v2] ARM: dts: imx27-eukrea: Remove invalid spi-cpol
2026-10-16 20:48 UTC
[PATCH v1 1/1] arm64: dts: imx8mm-var-dart-sonata: Add OV5640 camera support
2026-10-16 20:20 UTC (4+ messages)
[PATCH 00/14] ARM: dts: imx: cleanup some CHECK_DTBS warnings
2026-10-16 20:10 UTC (15+ messages)
` [PATCH 01/14] ARM: dts: imx6q-dms-ba16: remove undocumented property fsl,receive-dpll-mode
` [PATCH 02/14] ARM: dts: imx50-amazon-yoshi: remove undocument property min-frequency
` [PATCH 03/14] ARM: dts: imx6dl-b155v2: add touchscreen size properties
` [PATCH 04/14] ARM: dts: imx6q-gw5400-a: fix SPI NOR flash vendor prefix
` [PATCH 05/14] ARM: dts: imx6dl-prtmvt: remove redundant panel compatible fallback
` [PATCH 06/14] ARM: dts: imx53-smd: change compatible string to dlg,da9053-aa
` [PATCH 07/14] ARM: dts: imx6qdl-savageboard: remove undocument avic,tm097tdh02
` [PATCH 08/14] ARM: dts: imx6qdl-apalis: remove disabled node "panel-lvds"
` [PATCH 09/14] ARM: dts: imx6ul-tx6ul: remove front compatible string karo,imx6ul-tx6ul-sgtl5000
` [PATCH 10/14] ARM: dts: imx6qdl-tx6-mb7: remove redundant pixelclk-active for simple panel
` [PATCH 11/14] ARM: dts: imx6q-h100: rename port to port@0 for mipi_csi
` [PATCH 12/14] ARM: dts: imx6qdl-sabrelite: fix typo vync-active
` [PATCH 13/14] ARM: dts: imx6q-novena: use interrupts replace irq-gpio
` [PATCH 14/14] ARM: dts: imx6sx-sdb-mqs: remove empty pinctrl-0
[PATCH] PCI: iproc-msi: Bound events handled per IRQ
2026-10-16 20:10 UTC (2+ messages)
[PATCH 0/4] arm64, riscv: release shadow stacks on failed fork
2026-10-16 19:46 UTC (5+ messages)
` [PATCH 1/4] arm64/gcs: release GCS "
` [PATCH 2/4] riscv/shstk: release shadow stack "
` [PATCH 3/4] selftests/arm64: GCS must not leak on a failed clone3
` [PATCH 4/4] selftests/riscv: shadow stack "
[PATCH net] net: stmmac: fix rx checksum offload with extended descriptors
2026-10-16 19:40 UTC
[PATCH net-next] net/stmmac/dwxgmac: Extend MTL/DMA support to 16 queues
2026-10-16 19:38 UTC
[PATCH v11 0/3] Add RP1 PWM controller support
2026-10-16 19:32 UTC (4+ messages)
` [PATCH v10 3/3] arm64: dts: broadcom: rpi-5: Add RP1 PWM node
[PATCH v5 1/2] dt-bindings: phy: Document ST STM32MP25 USB2-FEMTO PHY
2026-10-16 19:27 UTC (2+ messages)
[PATCH v14 00/32] Introduce SCMI Telemetry support
2026-10-16 18:55 UTC (4+ messages)
` [PATCH v14 12/32] firmware: arm_scmi: Add Telemetry TDCF areas parsing support
` [PATCH v14 28/32] firmware: arm_scmi: Add System Telemetry driver
` [PATCH v14 32/32] kselftest/arm64: Add SCMI Telemetry UAPI compliance testcases
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox