[PATCH] OMAP3: l3: fix for "irq 10: nobody cared" message

[omar.ramirez@ti.com (Ramirez Luna, Omar)]

Hi,

On Mon, Mar 28, 2011 at 12:38 AM, Santosh Shilimkar
<santosh.shilimkar@ti.com> wrote:
>> If an error occurs in the L3 on any other initiator than MPU,
>> the interrupt goes unhandled given that the 'base' register
>> was calculated with the initialized err_base value (which
>> coincidentally points to MPU) and not with the actual source
>> of the error.
>>
>> Signed-off-by: Omar Ramirez Luna <omar.ramirez@ti.com>
>
> Patch looks good. Did you observe this with DSP initiator??

Yes, when loading a base image for the DSP, I got an: In-band Error
Error seen by IVA_SS  at address 0; after this fix.

I was planning to remove the duplicated "Error" print too.

> Acked-by: Santosh Shilimkar <santosh.shilimkar@ti.com>

Thanks, I'll add it in my next version when I make the changes
affecting only these lines.

Regards,

Omar