From: tomeu.vizoso@collabora.com (Tomeu Vizoso)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v6 22/22] of/platform: Defer probes of registered devices
Date: Thu, 22 Oct 2015 15:04:59 +0200	[thread overview]
Message-ID: <CAAObsKAfufBe_SycibUN3ZsE3fOkBfUjZRx1SWEMwVtM6t7inQ@mail.gmail.com> (raw)
In-Reply-To: <1445467912.701.90.camel@freescale.com>
On 22 October 2015 at 00:51, Scott Wood <scottwood@freescale.com> wrote:
> On Wed, 2015-10-21 at 08:44 -0500, Rob Herring wrote:
>> On Wed, Oct 21, 2015 at 12:54 AM, Scott Wood <scottwood@freescale.com>
>> wrote:
>> > On Mon, 2015-09-21 at 16:03 +0200, Tomeu Vizoso wrote:
>> > > Instead of trying to match and probe platform and AMBA devices right
>> > > after each is registered, delay their probes until device_initcall_sync.
>> > >
>> > > This means that devices will start probing once all built-in drivers
>> > > have registered, and after all platform and AMBA devices from the DT
>> > > have been registered already.
>> > >
>> > > This allows us to prevent deferred probes by probing dependencies on
>> > > demand.
>> > >
>> > > Signed-off-by: Tomeu Vizoso <tomeu.vizoso@collabora.com>
>> > > ---
>> > >
>> > > Changes in v4:
>> > > - Also defer probes of AMBA devices registered from the DT as they can
>> > >   also request resources.
>> > >
>> > >  drivers/of/platform.c | 11 ++++++++---
>> > >  1 file changed, 8 insertions(+), 3 deletions(-)
>> >
>> > This breaks arch/powerpc/sysdev/fsl_pci.c.  The PCI bus is an OF platform
>> > device, and it must be probed before pcibios_init() which is a
>> > subsys_initcall(), or else the PCI bus never gets scanned.
>>
>> Thanks for the report. This is probably getting dropped, but it could
>> be disabled for PPC.
>
> I don't think that adding another arbitrary arch difference would be the
> right solution.
I think Rob meant temporarily disable it while things get fixed. At
least, I don't see any reason why PPC wouldn't benefit from this
series.
Regards,
Tomeu
>> Any plans to fix this and make PCI hosts hotplugable? For the scanning
>> part, generally the host controller drivers are responsible for
>> scanning their bus now.
>
> Scanning from the host controller driver seems like a reasonable goal, though
>
> it'd take a bit of digging to extract whatever other things fsl_pci may
> depend on from the common PPC PCI code, in particular the various things that
>
> pcibios_resource_survey() does after all PCI buses have been scanned.
>
> There's also check_swiotlb_enabled(), another subsys_initcall, which frees
> the swiotlb memory if ppc_swiotlb_enable hasn't been set.  The PCI host
> controller probe sets ppc_swiotlb_enable if it wasn't able to create an
> inbound mapping for all RAM.  Even if we were to change that to a later
> initcall, there's nothing later than late_initcall that we could use.
>
> -Scott
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo at vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/
next prev parent reply	other threads:[~2015-10-22 13:04 UTC|newest]
Thread overview: 70+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-09-21 14:02 [PATCH v6 0/22] On-demand device probing Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 01/22] driver core: handle -EPROBE_DEFER from bus_type.match() Tomeu Vizoso
2015-10-22  1:00   ` Rafael J. Wysocki
2015-09-21 14:02 ` [PATCH v6 02/22] ARM: amba: Move reading of periphid to amba_match() Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 03/22] of/platform: Point to struct device from device node Tomeu Vizoso
2015-09-22  0:39   ` Rob Herring
2015-09-22  6:45     ` Tomeu Vizoso
2015-10-22  1:02   ` Rafael J. Wysocki
2015-10-22 13:01     ` Tomeu Vizoso
2015-10-24 13:57       ` Rafael J. Wysocki
2015-10-27 14:48         ` Tomeu Vizoso
2015-10-27 15:43           ` Rafael J. Wysocki
2015-10-27 21:24             ` Rob Herring
2015-09-21 14:02 ` [PATCH v6 04/22] of: add function to allow probing a device from a OF node Tomeu Vizoso
2015-10-22  1:06   ` Rafael J. Wysocki
2015-10-22 13:03     ` Tomeu Vizoso
2015-10-22 23:54       ` Mark Brown
2015-10-24 14:28         ` Rafael J. Wysocki
2015-10-24 13:55       ` Rafael J. Wysocki
2015-10-24 20:09         ` Rob Herring
2015-10-26  0:13           ` Mark Brown
2015-10-26  0:15             ` Dmitry Torokhov
2015-10-26  2:48             ` Rafael J. Wysocki
2015-10-26  3:09               ` Mark Brown
2015-10-26  8:16   ` Geert Uytterhoeven
2015-10-27 14:46     ` Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 05/22] gpio: Probe GPIO drivers on demand Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 06/22] gpio: Probe pinctrl devices " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 07/22] regulator: core: Remove regulator_list Tomeu Vizoso
2015-09-21 19:38   ` Mark Brown
2015-09-22  7:21     ` Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 08/22] regulator: core: Probe regulators on demand Tomeu Vizoso
2015-09-21 19:39   ` Mark Brown
2015-09-21 14:02 ` [PATCH v6 09/22] drm: Probe panels " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 10/22] drm/tegra: Probe dpaux devices " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 11/22] i2c: core: Probe i2c adapters and " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 12/22] pwm: Probe PWM chip " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 13/22] backlight: Probe backlight " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 14/22] usb: phy: Probe phy " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 15/22] clk: Probe clk providers " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 16/22] pinctrl: Probe pinctrl devices " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 17/22] phy: core: Probe phy providers " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 18/22] dma: of: Probe DMA controllers " Tomeu Vizoso
2015-09-21 14:02 ` [PATCH v6 19/22] power-supply: Probe power supplies " Tomeu Vizoso
2015-09-21 14:03 ` [PATCH v6 20/22] driver core: Allow deferring probes until late init Tomeu Vizoso
2015-09-26 18:15   ` Rob Herring
2015-09-29  8:05     ` Tomeu Vizoso
2015-09-29 16:58       ` Rob Herring
2015-09-21 14:03 ` [PATCH v6 21/22] driver core: Start processing deferred probes earlier Tomeu Vizoso
2015-10-05 23:52   ` Frank Rowand
2015-10-06  2:49     ` Rob Herring
2015-10-06 10:45       ` Mark Brown
2015-09-21 14:03 ` [PATCH v6 22/22] of/platform: Defer probes of registered devices Tomeu Vizoso
2015-10-21  5:54   ` Scott Wood
2015-10-21 13:44     ` Rob Herring
2015-10-21 22:51       ` Scott Wood
2015-10-22 13:04         ` Tomeu Vizoso [this message]
2015-10-22 21:27           ` Scott Wood
2015-10-24 13:51             ` Rafael J. Wysocki
2015-10-28 14:40             ` Tomeu Vizoso
2015-10-29  4:17               ` Rob Herring
2015-10-29 16:06               ` Scott Wood
2015-10-22  0:34     ` Michael Ellerman
2015-09-26 18:17 ` [PATCH v6 0/22] On-demand device probing Rob Herring
2015-09-26 19:22   ` Greg Kroah-Hartman
2015-09-30 10:09     ` Tomeu Vizoso
2015-09-30 10:23       ` Greg Kroah-Hartman
2015-09-29  8:08   ` Tomeu Vizoso
2015-10-13 19:57   ` Tomeu Vizoso
2015-10-13 21:21     ` Rob Herring
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox
  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):
  git send-email \
    --in-reply-to=CAAObsKAfufBe_SycibUN3ZsE3fOkBfUjZRx1SWEMwVtM6t7inQ@mail.gmail.com \
    --to=tomeu.vizoso@collabora.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    /path/to/YOUR_REPLY
  https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
  Be sure your reply has a Subject: header at the top and a blank line
  before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).