From: zonque@gmail.com (Daniel Mack)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 3/4] MTD: pxa3xx_nand: enable multiple chip select support
Date: Tue, 12 Jul 2011 14:05:24 +0200 [thread overview]
Message-ID: <CACTFLANbbb4BO8Uvt9L050ambuzf9tYWPdPAj5ca2qkXJbpozw@mail.gmail.com> (raw)
In-Reply-To: <CALZhoSQasw14-o6UEHYjUNFq-okXGiokciYhwCDjnnNiVie-LQ@mail.gmail.com>
On Tue, Jul 12, 2011 at 12:29 PM, Lei Wen <adrian.wenl@gmail.com> wrote:
> Hi Daniel,
>
> On Tue, Jul 12, 2011 at 5:57 PM, Daniel Mack <zonque@gmail.com> wrote:
>> On Tue, Jul 12, 2011 at 11:40 AM, Lei Wen <adrian.wenl@gmail.com> wrote:
>>> I retest with suspend&resume on my board, each time that board would
>>> reset the timing in the
>>> begining of pxa3xx_cmdfunc as expected. So this should be ok as it is
>>> the same behavior
>>> with original code.
>>
>> Ok, just to be sure - as there have been quite some iterations fot
>> this now - can you send me a link to your most current version of this
>> patch again, please? Just to avoid confusion which version we're
>> talking about.
>>
>>
>
> Please refer to V6 patch set I just send out.
I did. With all 4 patches applied, the system doesn't wake up again,
as I posted as reply to this particular patch. With only the first 3
applied, we see the following messages after resume:
[ 1297.173920] pxa3xx-nand pxa3xx-nand: Wait time out!!!
[ 1297.373887] pxa3xx-nand pxa3xx-nand: Wait time out!!!
[ 1297.379014] UBIFS error (pid 1245): ubifs_read_node: bad node type
(255 but expected 2)
[ 1297.388521] UBIFS error (pid 1245): ubifs_read_node: bad node at
LEB 435:102784, LEB mapping status 1
[ 1297.593895] pxa3xx-nand pxa3xx-nand: Wait time out!!!
[ 1297.793884] pxa3xx-nand pxa3xx-nand: Wait time out!!!
[ 1297.994294] pxa3xx-nand pxa3xx-nand: Wait time out!!!
Daniel
next prev parent reply other threads:[~2011-07-12 12:05 UTC|newest]
Thread overview: 81+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-07-08 16:00 [PATCH] MTD: pxa3xx_nand: enable multiple chip select support Lei Wen
2011-06-22 11:39 ` Daniel Mack
2011-07-08 17:38 ` Lei Wen
2011-06-22 13:06 ` Daniel Mack
2011-06-23 6:22 ` Lei Wen
2011-07-08 16:09 ` Igor Grinberg
2011-07-08 15:26 ` Lei Wen
2011-06-23 10:44 ` Igor Grinberg
2011-06-25 11:17 ` Lei Wen
2011-06-25 12:32 ` Daniel Mack
2011-06-25 12:51 ` Lei Wen
2011-06-27 13:22 ` Igor Grinberg
2011-06-28 7:32 ` Artem Bityutskiy
2011-06-28 15:12 ` Lei Wen
2011-06-29 3:51 ` [PATCH V3 0/9] pxa3xx_nand: add two " Lei Wen
2011-06-29 9:00 ` Igor Grinberg
2011-06-29 10:20 ` Artem Bityutskiy
2011-07-04 9:27 ` Lei Wen
2011-07-04 9:25 ` [PATCH V4 0/4] " Lei Wen
2011-07-08 3:34 ` [PATCH V5 0/3] " Lei Wen
2011-07-12 10:28 ` [PATCH V6 0/4] " Lei Wen
2011-07-12 14:35 ` [PATCH V7 " Lei Wen
2011-07-15 3:44 ` [PATCH V8 " Lei Wen
2011-07-20 4:51 ` Artem Bityutskiy
2011-07-15 3:44 ` [PATCH V8 1/4] MTD: pxa3xx_nand: enhance suspend and resume routine Lei Wen
2011-07-15 3:44 ` [PATCH V8 2/4] MTD: pxa3xx_nand: convert all printk into dev_* Lei Wen
2011-07-15 3:44 ` [PATCH V8 3/4] MTD: pxa3xx_nand: sperate each chip individual info Lei Wen
2011-07-15 3:44 ` [PATCH V8 4/4] MTD: pxa3xx_nand: enable multiple chip select support Lei Wen
2011-07-12 14:35 ` [PATCH V7 1/4] MTD: pxa3xx_nand: enhance suspend and resume routine Lei Wen
2011-07-13 10:53 ` Sergei Shtylyov
2011-07-12 14:35 ` [PATCH V7 2/4] MTD: pxa3xx_nand: convert all printk into dev_* Lei Wen
2011-07-13 10:57 ` Sergei Shtylyov
2011-07-13 12:41 ` Lei Wen
2011-07-13 14:35 ` Sergei Shtylyov
2011-07-12 14:35 ` [PATCH V7 3/4] MTD: pxa3xx_nand: sperate each chip individual info Lei Wen
2011-07-12 14:35 ` [PATCH V7 4/4] MTD: pxa3xx_nand: enable multiple chip select support Lei Wen
2011-07-12 10:28 ` [PATCH V6 1/4] MTD: pxa3xx_nand: convert all printk into dev_* Lei Wen
2011-07-12 10:28 ` [PATCH V6 2/4] MTD: pxa3xx_nand: sperate each chip individual info Lei Wen
2011-07-12 10:28 ` [PATCH V6 3/4] MTD: pxa3xx_nand: enable multiple chip select support Lei Wen
2011-07-12 10:28 ` [PATCH V6 4/4] MTD: pxa3xx_nand: enhance suspend and resume routine Lei Wen
2011-07-12 11:39 ` Daniel Mack
2011-07-12 12:02 ` Daniel Mack
2011-07-12 15:56 ` Igor Grinberg
2011-07-12 17:35 ` Daniel Mack
2011-07-08 3:34 ` [PATCH 1/3] MTD: pxa3xx_nand: convert all printk into dev_* Lei Wen
2011-07-08 3:34 ` [PATCH 2/3] MTD: pxa3xx_nand: sperate each chip individual info Lei Wen
2011-07-08 3:34 ` [PATCH 3/3] MTD: pxa3xx_nand: enable multiple chip select support Lei Wen
2011-07-04 9:25 ` [PATCH 1/4] MTD: pxa3xx_nand: convert all printk into dev_* Lei Wen
2011-07-04 9:25 ` [PATCH 2/4] MTD: pxa3xx_nand: sperate each chip individual info Lei Wen
2011-07-06 7:29 ` Igor Grinberg
2011-07-04 9:25 ` [PATCH 3/4] MTD: pxa3xx_nand: enable multiple chip select support Lei Wen
2011-07-06 6:53 ` Artem Bityutskiy
2011-07-06 6:54 ` Lei Wen
2011-07-06 7:07 ` Artem Bityutskiy
2011-07-06 7:41 ` Igor Grinberg
2011-07-07 6:26 ` Lei Wen
2011-07-07 8:59 ` Igor Grinberg
2011-07-07 9:06 ` Lei Wen
2011-07-07 11:23 ` Igor Grinberg
2011-07-11 14:49 ` Daniel Mack
2011-07-11 18:19 ` Igor Grinberg
2011-07-11 18:53 ` Daniel Mack
2011-07-11 19:25 ` Igor Grinberg
2011-07-12 9:40 ` Lei Wen
2011-07-12 9:57 ` Daniel Mack
2011-07-12 10:29 ` Lei Wen
2011-07-12 12:05 ` Daniel Mack [this message]
2011-07-12 12:48 ` Daniel Mack
2011-07-12 15:49 ` Igor Grinberg
2011-07-04 9:25 ` [PATCH 4/4] ARM: mmp/pxa: fix nand platform data Lei Wen
2011-06-29 3:51 ` [PATCH 1/9] MTD: pxa3xx_nand: convert all printk into dev_* Lei Wen
2011-06-29 3:51 ` [PATCH 2/9] MTD: pxa3xx_nand: enable multiple chip select support Lei Wen
2011-06-29 7:11 ` Artem Bityutskiy
2011-06-29 7:16 ` Lei Wen
2011-06-29 3:51 ` [PATCH 3/9] ARM: aspenite: fix nand platform data Lei Wen
2011-06-29 3:51 ` [PATCH 4/9] ARM: cm-x300: " Lei Wen
2011-06-29 3:51 ` [PATCH 5/9] ARM: colibri-pxa3xx: " Lei Wen
2011-06-29 3:51 ` [PATCH 6/9] ARM: littleton: " Lei Wen
2011-06-29 3:51 ` [PATCH 7/9] ARM: mxm8x10: " Lei Wen
2011-06-29 3:51 ` [PATCH 8/9] ARM: raumfeld: " Lei Wen
2011-06-29 3:51 ` [PATCH 9/9] ARM: zylonite: " Lei Wen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=CACTFLANbbb4BO8Uvt9L050ambuzf9tYWPdPAj5ca2qkXJbpozw@mail.gmail.com \
--to=zonque@gmail.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).