linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: geert@linux-m68k.org (Geert Uytterhoeven)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 05/15] ARM64: dts: Add R-Car Salvator-x M3-N support
Date: Fri, 16 Feb 2018 10:36:23 +0100	[thread overview]
Message-ID: <CAMuHMdXQQqRTir-3wgorh_QX060K_CyQNStA46Ph+hnrikqCaw@mail.gmail.com> (raw)
In-Reply-To: <1518515162-23663-6-git-send-email-jacopo+renesas@jmondi.org>

Hi Jacopo,

On Tue, Feb 13, 2018 at 10:45 AM, Jacopo Mondi
<jacopo+renesas@jmondi.org> wrote:
> Add initial support for R-Car M3-N Salvator-x and r8a77965 SoC in
> device tree with cpg-mssr, reset and clock nodes.
>
> Add place-holder device nodes for all nodes referred by
> "salvator-common.dtsi"
>
> Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>

> --- /dev/null
> +++ b/arch/arm64/boot/dts/renesas/r8a77965.dtsi

> +               gic: interrupt-controller at f1010000 {
> +                       compatible = "arm,gic-400";
> +                       #interrupt-cells = <3>;
> +                       #address-cells = <0>;
> +                       interrupt-controller;
> +                       reg = <0x0 0xf1010000 0 0x1000>,
> +                             <0x0 0xf1020000 0 0x20000>,
> +                             <0x0 0xf1040000 0 0x20000>,
> +                             <0x0 0xf1060000 0 0x20000>;
> +                       interrupts = <GIC_PPI 9
> +                                       (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_HIGH)>;

Given you have 2 CPU cores, it should say GIC_CPU_MASK_SIMPLE(2).

> +                       clocks = <&cpg CPG_MOD 408>;
> +                       clock-names = "clk";
> +                       power-domains = <&sysc R8A77965_PD_ALWAYS_ON>;
> +                       resets = <&cpg 408>;
> +               };
> +
> +               timer {
> +                       compatible = "arm,armv8-timer";
> +                       interrupts = <GIC_PPI 13
> +                                       (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
> +                                    <GIC_PPI 14
> +                                       (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
> +                                    <GIC_PPI 11
> +                                       (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
> +                                    <GIC_PPI 10
> +                                       (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>;

This one is correct.

Gr{oetje,eeting}s,

                        Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert at linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds

  parent reply	other threads:[~2018-02-16  9:36 UTC|newest]

Thread overview: 47+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-02-13  9:45 [PATCH 00/15] R-Car M3-N initial support Jacopo Mondi
2018-02-13  9:45 ` [PATCH 02/15] clk: renesas: cpg-msr: Add support for R-Car M3-N Jacopo Mondi
2018-02-13 11:48   ` Kieran Bingham
2018-02-14 11:03   ` Geert Uytterhoeven
2018-02-15 15:31   ` Simon Horman
2018-02-16  9:03     ` Geert Uytterhoeven
2018-02-19  2:53   ` Rob Herring
2018-02-13  9:46 ` [PATCH 14/15] pinctrl: sh-pfc: r8a77965: Add EtherAVB groups/functions Jacopo Mondi
2018-02-14 14:47   ` Geert Uytterhoeven
2018-02-13  9:46 ` [PATCH 15/15] ARM64: dts: r8a77965: Add EtherAVB device node Jacopo Mondi
2018-02-14 14:48   ` Geert Uytterhoeven
     [not found] ` <1518515162-23663-2-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 10:01   ` [PATCH 01/15] Documentation: devicetree: R-Car M3-N SoC DT bindings Simon Horman
2018-02-19  2:52     ` Rob Herring
2018-02-19  9:19       ` Simon Horman
2018-02-14 10:36   ` Geert Uytterhoeven
     [not found] ` <1518515162-23663-4-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 12:48   ` [PATCH 03/15] soc: renesas: Add R-Car M3-N support Geert Uytterhoeven
2018-02-15 15:34     ` Simon Horman
2018-02-20 10:10     ` jacopo mondi
     [not found] ` <1518515162-23663-5-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 13:37   ` [PATCH 04/15] pinctrl: sh-pfc: Initial " Geert Uytterhoeven
2018-02-14 13:53     ` jacopo mondi
2018-02-14 14:25       ` Geert Uytterhoeven
2018-02-19  2:57   ` Rob Herring
     [not found] ` <1518515162-23663-6-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 13:58   ` [PATCH 05/15] ARM64: dts: Add R-Car Salvator-x " Geert Uytterhoeven
2018-02-14 21:22     ` Philippe Ombredanne
2018-02-15 15:38     ` Simon Horman
2018-02-16  9:20   ` Geert Uytterhoeven
2018-02-16  9:36   ` Geert Uytterhoeven [this message]
     [not found] ` <1518515162-23663-7-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 13:59   ` [PATCH 06/15] Documentation: devicetree: dma: Add r8a77965 dmac Geert Uytterhoeven
2018-02-15 15:39   ` Simon Horman
2018-02-15 15:56     ` Simon Horman
2018-02-16  9:01       ` Geert Uytterhoeven
2018-02-16 13:40         ` Simon Horman
2018-02-19  2:58       ` Rob Herring
     [not found] ` <1518515162-23663-12-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 14:05   ` [PATCH 11/15] gpio: rcar: Add R-Car M3-N compatible string Geert Uytterhoeven
2018-02-20 13:35     ` jacopo mondi
2018-02-20 13:40       ` Geert Uytterhoeven
     [not found] ` <1518515162-23663-8-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 14:08   ` [PATCH 07/15] ARM64: dts: r8a77965: Add dmac device nods Geert Uytterhoeven
     [not found] ` <1518515162-23663-13-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 14:10   ` [PATCH 12/15] ARM64: dts: r8a77965: Add GPIO nodes Geert Uytterhoeven
     [not found] ` <1518515162-23663-11-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 14:13   ` [PATCH 10/15] ARM64: dts: r8a77965: Add SCIF device nodes Geert Uytterhoeven
     [not found] ` <1518515162-23663-10-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 14:42   ` [PATCH 09/15] pinctrl: sh-pfc: r8a77965: Add SCIFs groups/functions Geert Uytterhoeven
     [not found] ` <1518515162-23663-14-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 14:06   ` [PATCH 13/15] Documentation: devicetree: ravb: Add r8a77965 Geert Uytterhoeven
2018-02-14 15:02   ` Sergei Shtylyov
2018-02-15 15:45   ` Simon Horman
2018-02-19  3:01     ` Rob Herring
     [not found] ` <1518515162-23663-9-git-send-email-jacopo+renesas@jmondi.org>
2018-02-14 14:03   ` [PATCH 08/15] Documentation: devicetree: renesas, sci: " Geert Uytterhoeven
2018-02-15 15:47   ` [PATCH 08/15] Documentation: devicetree: renesas,sci: " Simon Horman
2018-02-19  2:59     ` Rob Herring

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=CAMuHMdXQQqRTir-3wgorh_QX060K_CyQNStA46Ph+hnrikqCaw@mail.gmail.com \
    --to=geert@linux-m68k.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).