[PATCH] mmc: mediatek: make sure clock is enabled when executing ops->card_busy()

[ulf.hansson@linaro.org (Ulf Hansson)]

On 28 January 2016 at 20:31, Chaotian Jing <chaotian.jing@mediatek.com> wrote:
> add pm_runtime_get_sync() before access MSDC_PS register

This isn't need as the mmc core does that when claiming the host, see
below commit.

>From that point there have been some additional fixup, as there were
actually some paths when to core invoked some of the host_ops
callbacks, without claiming the host. Although that should also have
been fixed now.

commit 9250aea76bfcbf4c2a7868e5566281bf2bb7af27
mmc: core: Enable runtime PM management of host devices

Kind regards
Uffe

>
> Signed-off-by: Chaotian Jing <chaotian.jing@mediatek.com>
> ---
>  drivers/mmc/host/mtk-sd.c | 12 +++++++-----
>  1 file changed, 7 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/mmc/host/mtk-sd.c b/drivers/mmc/host/mtk-sd.c
> index 82a97ac..a56b16d 100644
> --- a/drivers/mmc/host/mtk-sd.c
> +++ b/drivers/mmc/host/mtk-sd.c
> @@ -1054,13 +1054,15 @@ static int msdc_ops_switch_volt(struct mmc_host *mmc, struct mmc_ios *ios)
>  static int msdc_card_busy(struct mmc_host *mmc)
>  {
>         struct msdc_host *host = mmc_priv(mmc);
> -       u32 status = readl(host->base + MSDC_PS);
> +       u32 status;
>
> -       /* check if any pin between dat[0:3] is low */
> -       if (((status >> 16) & 0xf) != 0xf)
> -               return 1;
> +       pm_runtime_get_sync(host->dev);
> +       status = readl(host->base + MSDC_PS);
> +       pm_runtime_mark_last_busy(host->dev);
> +       pm_runtime_put_autosuspend(host->dev);
>
> -       return 0;
> +       /* check if any pin between dat[0:3] is low */
> +       return !!(((status >> 16) & 0xf) != 0xf);
>  }
>
>  static void msdc_request_timeout(struct work_struct *work)
> --
> 1.8.1.1.dirty
>