[PATCH net-next v2 1/9] net: stmmac: qcom-ethqos: remove of_get_phy_mode()

["Russell King (Oracle)" <rmk+kernel@armlinux.org.uk>]

devm_stmmac_probe_config_dt() already gets the PHY mode from firmware,
which is stored in plat_dat->phy_interface. Therefore, we don't need to
get it a second time in qcom_ethqos_probe(). Use
plat_dat->phy_interface to initialise ethqos->phy_mode.

Reviewed-by: Michal Kubiak <michal.kubiak@intel.com>
Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
---
 drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
index eafe637540b6..0e4da216f942 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
@@ -794,9 +794,7 @@ static int qcom_ethqos_probe(struct platform_device *pdev)
 	if (!ethqos)
 		return -ENOMEM;
 
-	ret = of_get_phy_mode(np, &ethqos->phy_mode);
-	if (ret)
-		return dev_err_probe(dev, ret, "Failed to get phy mode\n");
+	ethqos->phy_mode = plat_dat->phy_interface;
 	switch (ethqos->phy_mode) {
 	case PHY_INTERFACE_MODE_RGMII:
 	case PHY_INTERFACE_MODE_RGMII_ID:
-- 
2.30.2