[PATCH] ARM: dts: am43x-epos-evm: Reduce i2c0 bus speed for tps65218

[PATCH] ARM: dts: am43x-epos-evm: Reduce i2c0 bus speed for tps65218

[Kevin Hilman]

From: Dave Gerlach <d-gerlach@ti.com>

Based on the latest timing specifications for the TPS65218 from the data
sheet, http://www.ti.com/lit/ds/symlink/tps65218.pdf, document SLDS206
from November 2014, we must change the i2c bus speed to better fit within
the minimum high SCL time required for proper i2c transfer.

When running at 400khz, measurements show that SCL spends
0.8125 uS/1.666 uS high/low which violates the requirement for minimum
high period of SCL provided in datasheet Table 7.6 which is 1 uS.
Switching to 100khz gives us 5 uS/5 uS high/low which both fall above
the minimum given values for 100 khz, 4.0 uS/4.7 uS high/low.

Without this patch occasionally a voltage set operation from the kernel
will appear to have worked but the actual voltage reflected on the PMIC
will not have updated, causing problems especially with cpufreq that may
update to a higher OPP without actually raising the voltage on DCDC2,
leading to a hang.

Signed-off-by: Dave Gerlach <d-gerlach@ti.com>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>
---
 arch/arm/boot/dts/am43x-epos-evm.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/am43x-epos-evm.dts b/arch/arm/boot/dts/am43x-epos-evm.dts
index aae0af10a5b1..2aa75abf85a9 100644
--- a/arch/arm/boot/dts/am43x-epos-evm.dts
+++ b/arch/arm/boot/dts/am43x-epos-evm.dts
@@ -582,7 +582,7 @@ &i2c0 {
 	status = "okay";
 	pinctrl-names = "default";
 	pinctrl-0 = <&i2c0_pins>;
-	clock-frequency = <400000>;
+	clock-frequency = <100000>;
 
 	tps65218: tps65218@24 {
 		reg = <0x24>;
-- 
2.31.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

Re: [PATCH] ARM: dts: am43x-epos-evm: Reduce i2c0 bus speed for tps65218

[Tony Lindgren]

* Kevin Hilman <khilman@baylibre.com> [210716 19:07]:
> From: Dave Gerlach <d-gerlach@ti.com>
> Without this patch occasionally a voltage set operation from the kernel
> will appear to have worked but the actual voltage reflected on the PMIC
> will not have updated, causing problems especially with cpufreq that may
> update to a higher OPP without actually raising the voltage on DCDC2,
> leading to a hang.

Applying into fixes thanks.

Tony

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel