Re: [PATCH v3 0/9] coresight: change some driver' spinlock type to raw_spinlock_t

[Yeoreum Yun <yeoreum.yun@arm.com>]

Hi Suzuki,

> > > >
> > > > > Notably missing is the same changes for the etm3x driver. The ETMv3.x
> > > > > and PTM1.x are supported by this driver, and these trace source
> > > > > variants are also supported in perf in the cs_etm.c code.
> > > >
> > > > But I wonder etmv3 needs to change. Because its spinlock is used only
> > > > via sysfs enable/disable path.
> > > > So, I think it doesn't need to change the lock type.
> > >
> > > ETM3 can be used in perf mode, similar to the ETM4x.
> > >
> > > So, you need to fix it as well.
> >
> > Yes. But etmv3's etmdata->spinlock doesn't used in perf path
> > its usage is only in sysfs interface path.
> > That's why I think it could skip too.
>
> Ok, which I think is a problem, since the sysfs mode could overwrite the
> "config" while perf is preparing the config from the event parsing.
> And we would need it there. So, for the time being, we can accept this
> series, pending other review comments and address this issue separately

Agree. also it has the same problem in etm4.
I have a patchset for etm3/etm4 for this. but it's based on this series.
So, after this patch is mereged. I'll send related patch.
Thanks.