From: Mark Rutland <mark.rutland@arm.com>
To: Jarkko Sakkinen <jarkko@kernel.org>
Cc: linux-kernel@vger.kernel.org,
Catalin Marinas <catalin.marinas@arm.com>,
Will Deacon <will@kernel.org>,
anil.s.keshavamurthy@intel.com, aou@eecs.berkeley.edu,
davem@davemloft.net, linux-arm-kernel@lists.infradead.org,
mhiramat@kernel.org, naveen.n.rao@linux.ibm.com,
palmer@dabbelt.com, paul.walmsley@sifive.com
Subject: Re: [PATCH v2 1/4] arm64: patching: always use fixmap
Date: Wed, 3 Apr 2024 17:51:44 +0100 [thread overview]
Message-ID: <Zg2JIFNy8IgwIyUV@FVFF77S0Q05N> (raw)
In-Reply-To: <D0AMI3962WW0.3JKFCSUXVSSVL@kernel.org>
On Wed, Apr 03, 2024 at 07:20:31PM +0300, Jarkko Sakkinen wrote:
> On Wed Apr 3, 2024 at 6:01 PM EEST, Mark Rutland wrote:
> > For historical reasons, patch_map() won't bother to fixmap non-image
> > addresses when CONFIG_STRICT_MODULE_RWX=n, matching the behaviour prior
> > to the introduction of CONFIG_STRICT_MODULE_RWX. However, as arm64
> > doesn't select CONFIG_ARCH_OPTIONAL_KERNEL_RWX, CONFIG_MODULES implies
> > CONFIG_STRICT_MODULE_RWX, so any kernel built with module support will
> > use the fixmap for any non-image address.
>
> Not familiar with the config flag but I'd guess it is essentially
> w^x enforcement right for the sections?
Essentially, yes.
> > Historically we only used patch_map() for the kernel image and modules,
> > but these days its also used by BPF and KPROBES to write to read-only
> > pages of executable text. Currently these both depend on CONFIG_MODULES,
> > but we'd like to change that in subsequent patches, which will require
> > using the fixmap regardless of CONFIG_STRICT_MODULE_RWX.
> >
> > This patch changes patch_map() to always use the fixmap, and simplifies
> > the logic:
> >
> > * Use is_image_text() directly in the if-else, rather than using a
> > temporary boolean variable.
> >
> > * Use offset_in_page() to get the offset within the mapping.
> >
> > * Remove uintaddr and cast the address directly when using
> > is_image_text().
> >
> > For kernels built with CONFIG_MODULES=y, there should be no functional
> > change as a result of this patch.
> >
> > For kernels built with CONFIG_MODULES=n, patch_map() will use the fixmap
> > for non-image addresses, but there are no extant users with non-image
> > addresses when CONFIG_MODULES=n, and hence there should be no functional
> > change as a result of this patch alone.
> >
> > Signed-off-by: Mark Rutland <mark.rutland@arm.com>
> > Cc: Catalin Marinas <catalin.marinas@arm.com>
> > Cc: Will Deacon <will@kernel.org>
> > ---
> > arch/arm64/kernel/patching.c | 10 +++-------
> > 1 file changed, 3 insertions(+), 7 deletions(-)
> >
> > Catalin, Will, this is a prerequisite for the final two patches in the
> > series. Are you happy for this go via the tracing tree?
> >
> > Mark.
> >
> > diff --git a/arch/arm64/kernel/patching.c b/arch/arm64/kernel/patching.c
> > index 2555349303684..f0f3a2a82ca5a 100644
> > --- a/arch/arm64/kernel/patching.c
> > +++ b/arch/arm64/kernel/patching.c
> > @@ -30,20 +30,16 @@ static bool is_image_text(unsigned long addr)
> >
> > static void __kprobes *patch_map(void *addr, int fixmap)
> > {
> > - unsigned long uintaddr = (uintptr_t) addr;
> > - bool image = is_image_text(uintaddr);
> > struct page *page;
> >
> > - if (image)
> > + if (is_image_text((unsigned long)addr))
> > page = phys_to_page(__pa_symbol(addr));
> > - else if (IS_ENABLED(CONFIG_STRICT_MODULE_RWX))
> > - page = vmalloc_to_page(addr);
> > else
> > - return addr;
> > + page = vmalloc_to_page(addr);
> >
> > BUG_ON(!page);
> > return (void *)set_fixmap_offset(fixmap, page_to_phys(page) +
> > - (uintaddr & ~PAGE_MASK));
> > + offset_in_page(addr));
>
> nit: could be a single line but i guess it is up to the taste (and
> subsystem maintainer). I.e. checkpatch will allow it at least.
>
> I don't mind it too much just mentioning for completeness.
At that point it goes to 93 chars long, and I stuck with the existing line
wrapping at 80 chars. I'd rather have a temporary 'phys_addr_t phys' variable
and do:
phys = page_to_phys(page) + offset_in_page(addr);
return (void *)set_fixmap(fixmap, phys);
... but I'll leave this as-is for now.
> > }
> >
> > static void __kprobes patch_unmap(int fixmap)
>
> If my assumption about the config flag holds this makes sense:
>
> Reviewed-by: Jarkko Sakkinen <jarkko@kernel.rg>
Thanks! I assume that should be "kernel.org", with an 'o' ;)
Mark.
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2024-04-03 16:52 UTC|newest]
Thread overview: 20+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-04-03 15:01 [PATCH v2 0/4] kprobes: permit use without modules Mark Rutland
2024-04-03 15:01 ` [PATCH v2 1/4] arm64: patching: always use fixmap Mark Rutland
2024-04-03 16:20 ` Jarkko Sakkinen
2024-04-03 16:51 ` Mark Rutland [this message]
2024-04-04 14:48 ` Jarkko Sakkinen
2024-04-03 17:52 ` Catalin Marinas
2024-04-03 23:44 ` Masami Hiramatsu
2024-04-03 15:01 ` [PATCH v2 2/4] kprobes/treewide: Add kprobes_ prefix to insn alloc/free functions Mark Rutland
2024-04-03 16:39 ` Jarkko Sakkinen
2024-04-03 15:01 ` [PATCH v2 3/4] kprobes/treewide: Explicitly override " Mark Rutland
2024-04-03 16:40 ` Jarkko Sakkinen
2024-04-03 15:01 ` [PATCH v2 4/4] kprobes: Remove core dependency on modules Mark Rutland
2024-04-03 16:41 ` Jarkko Sakkinen
2024-04-04 8:15 ` Jarkko Sakkinen
2024-04-04 15:18 ` Jarkko Sakkinen
2024-04-04 16:10 ` Masami Hiramatsu
2024-04-04 16:47 ` Mark Rutland
2024-04-05 3:13 ` Masami Hiramatsu
2024-04-13 20:16 ` Jarkko Sakkinen
2024-04-11 22:54 ` Jarkko Sakkinen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=Zg2JIFNy8IgwIyUV@FVFF77S0Q05N \
--to=mark.rutland@arm.com \
--cc=anil.s.keshavamurthy@intel.com \
--cc=aou@eecs.berkeley.edu \
--cc=catalin.marinas@arm.com \
--cc=davem@davemloft.net \
--cc=jarkko@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=mhiramat@kernel.org \
--cc=naveen.n.rao@linux.ibm.com \
--cc=palmer@dabbelt.com \
--cc=paul.walmsley@sifive.com \
--cc=will@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox