Re: arm64: dts: ls1028a-rdb: Add iio-hwmon compatibility table

[Frank Li <Frank.li@nxp.com>]

On Mon, Sep 09, 2024 at 05:36:07PM +0100, Martyn Welch wrote:
> The ls1028ardb uses the TI ina220 power monitor. This device has an IIO and
> hwmon drivers, but can't be used with both at the same time.

> To enable us
> to utilise the iio framework, but also access power information via the
> hwmon framework, add an iio-hwmon map. This allows the IIO driver to be
> used for the ina220, with the iio-hwmon driver mapping the data from the
> IIO framework into hwmon.

Can you simply said:

Add an iio-hwmon map to utilise the iio framework and access power
information via the hwmon framework at the same time.

Frank
>
> Signed-off-by: Martyn Welch <martyn.welch@collabora.com>
> ---
>  arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts | 9 ++++++++-
>  1 file changed, 8 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts b/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts
> index ecd2c1e..b062de5 100644
> --- a/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts
> +++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts
> @@ -94,6 +94,12 @@ simple-audio-card,codec {
>  			system-clock-frequency = <25000000>;
>  		};
>  	};
> +
> +	iio-hwmon {
> +		compatible = "iio-hwmon";
> +		io-channels = <&ina220 0>, <&ina220 1>,
> +			<&ina220 2>, <&ina220 3>;
> +	};
>  };
>
>  &can0 {
> @@ -222,8 +228,9 @@ i2c@2 {
>  			#size-cells = <0>;
>  			reg = <0x02>;
>
> -			current-monitor@40 {
> +			ina220: current-monitor@40 {
>  				compatible = "ti,ina220";
> +				#io-channel-cells = <1>;
>  				reg = <0x40>;
>  				shunt-resistor = <500>;
>  			};