Re: [PATCH] pinctrl: meson: fix G12A ao pull registers base address

[Neil Armstrong <narmstrong@baylibre.com>]

Hi Xingyu,


On 03/12/2018 04:05, Xingyu Chen wrote:
> Since Meson G12A SoC, Introduce new ao registers AO_RTI_PULL_UP_EN_REG
> and AO_GPIO_O.
> 
> These bits of controlling output level are remapped to the new register
> AO_GPIO_O, and the AO_GPIO_O_EN_N support only controlling output enable.
> 
> These bits of controlling pull enable are remapped to the new register
> AO_RTI_PULL_UP_EN_REG, and the AO_RTI_PULL_UP_REG support only controlling
> pull type(up/down).
> 
> The new layout of ao gpio/pull registers is as follows:
> - AO_GPIO_O_EN_N        [offset: 0x9 << 2]
> - AO_GPIO_I             [offset: 0xa << 2]
> - AO_RTI_PULL_UP_REG    [offset: 0xb << 2]
> - AO_RTI_PULL_UP_EN_REG [offset: 0xc << 2]
> - AO_GPIO_O             [offset: 0xd << 2]
> 
> From above, we can see ao GPIO registers region has been separated by the
> ao pull registers. In order to ensure the continuity of the region on
> software, the ao GPIO and ao pull registers use the same base address, but
> can be identified by the offset.
> 
> Fixes: 29ae0952e85f ("pinctrl: meson-g12a: add pinctrl driver support")
> Signed-off-by: Xingyu Chen <xingyu.chen@amlogic.com>
> Signed-off-by: Jianxin Pan <jianxin.pan@amlogic.com>
> ---
>  drivers/pinctrl/meson/pinctrl-meson.c | 22 ++++++++++++----------
>  1 file changed, 12 insertions(+), 10 deletions(-)
> 
> diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c
> index 53d449076dee..7ff40cd7a0cb 100644
> --- a/drivers/pinctrl/meson/pinctrl-meson.c
> +++ b/drivers/pinctrl/meson/pinctrl-meson.c
> @@ -31,6 +31,9 @@
>   * In some cases the register ranges for pull enable and pull
>   * direction are the same and thus there are only 3 register ranges.
>   *
> + * Since Meson G12A SoC, the ao register ranges for gpio, pull enable
> + * and pull direction are the same, so there are only 2 register ranges.
> + *
>   * For the pull and GPIO configuration every bank uses a contiguous
>   * set of bits in the register sets described above; the same register
>   * can be shared by more banks with different offsets.
> @@ -487,23 +490,22 @@ static int meson_pinctrl_parse_dt(struct meson_pinctrl *pc,
>  		return PTR_ERR(pc->reg_mux);
>  	}
>  
> -	pc->reg_pull = meson_map_resource(pc, gpio_np, "pull");
> -	if (IS_ERR(pc->reg_pull)) {
> -		dev_err(pc->dev, "pull registers not found\n");
> -		return PTR_ERR(pc->reg_pull);
> +	pc->reg_gpio = meson_map_resource(pc, gpio_np, "gpio");
> +	if (IS_ERR(pc->reg_gpio)) {
> +		dev_err(pc->dev, "gpio registers not found\n");
> +		return PTR_ERR(pc->reg_gpio);
>  	}
>  
> +	pc->reg_pull = meson_map_resource(pc, gpio_np, "pull");
> +	/* Use gpio region if pull one is not present */
> +	if (IS_ERR(pc->reg_pull))
> +		pc->reg_pull = pc->reg_gpio;
> +
>  	pc->reg_pullen = meson_map_resource(pc, gpio_np, "pull-enable");
>  	/* Use pull region if pull-enable one is not present */
>  	if (IS_ERR(pc->reg_pullen))
>  		pc->reg_pullen = pc->reg_pull;
>  
> -	pc->reg_gpio = meson_map_resource(pc, gpio_np, "gpio");
> -	if (IS_ERR(pc->reg_gpio)) {
> -		dev_err(pc->dev, "gpio registers not found\n");
> -		return PTR_ERR(pc->reg_gpio);
> -	}
> -
>  	return 0;
>  }
>  
> 
Doesn't it need an update of the bindings ?

Neil


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel