Re: [RFC PATCH v5 2/4] PCI: rockchip: Set Target Link Speed before retraining

[Geraldo Nascimento <geraldogabriel@gmail.com>]

On Fri, Jun 13, 2025 at 02:03:50PM -0300, Geraldo Nascimento wrote:
> Current code may fail Gen2 retraining if Target Link Speed
> is set to 2.5 GT/s in Link Control and Status Register 2.
> Set it to 5.0 GT/s accordingly.
> 
> Signed-off-by: Geraldo Nascimento <geraldogabriel@gmail.com>
> ---
>  drivers/pci/controller/pcie-rockchip-host.c | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/drivers/pci/controller/pcie-rockchip-host.c b/drivers/pci/controller/pcie-rockchip-host.c
> index 8489d51e01ca..467e3fc377f7 100644
> --- a/drivers/pci/controller/pcie-rockchip-host.c
> +++ b/drivers/pci/controller/pcie-rockchip-host.c
> @@ -341,6 +341,10 @@ static int rockchip_pcie_host_init_port(struct rockchip_pcie *rockchip)
>  		 * Enable retrain for gen2. This should be configured only after
>  		 * gen1 finished.
>  		 */
> +		status = rockchip_pcie_read(rockchip, PCIE_RC_CONFIG_CR + PCI_EXP_LNKCTL2);
> +		status &= ~PCI_EXP_LNKCTL2_TLS;
> +		status |= PCI_EXP_LNKCTL2_TLS_5_0GT;
> +		rockchip_pcie_write(rockchip, status, PCIE_RC_CONFIG_CR + PCI_EXP_LNKCTL2);
>  		rockchip_pcie_write(rockchip, status, PCIE_RC_CONFIG_CR + PCI_EXP_LNKCTL2);

Hi,

I see rockchip_pcie_write() was added twice, in this patch and also in
1/4.

I'll send v6 with correction after I get some reviews.

Thank you,
Geraldo Nascimento

>  		status = rockchip_pcie_read(rockchip, PCIE_RC_CONFIG_CR + PCI_EXP_LNKCTL);
>  		status |= PCI_EXP_LNKCTL_RL;
> -- 
> 2.49.0
>