[PATCH] PCI: stm32: clean up some error handling in probe()

[Dan Carpenter <dan.carpenter@linaro.org>]

Smatch complains that the other error paths use gotos to clean up and
these two don't.  Generally, the implication with that warning is that
the error handly has been ommitted.  In this case, the error handling is
fine, but we can avoid a bit of code duplication by using gotos to clean
up.

Signed-off-by: Dan Carpenter <dan.carpenter@linaro.org>
---
 drivers/pci/controller/dwc/pcie-stm32.c | 10 ++++------
 1 file changed, 4 insertions(+), 6 deletions(-)

diff --git a/drivers/pci/controller/dwc/pcie-stm32.c b/drivers/pci/controller/dwc/pcie-stm32.c
index 964fa6f674c8..96a5fb893af4 100644
--- a/drivers/pci/controller/dwc/pcie-stm32.c
+++ b/drivers/pci/controller/dwc/pcie-stm32.c
@@ -287,18 +287,16 @@ static int stm32_pcie_probe(struct platform_device *pdev)
 
 	ret = pm_runtime_set_active(dev);
 	if (ret < 0) {
-		clk_disable_unprepare(stm32_pcie->clk);
-		stm32_remove_pcie_port(stm32_pcie);
-		return dev_err_probe(dev, ret, "Failed to activate runtime PM\n");
+		dev_err_probe(dev, ret, "Failed to activate runtime PM\n");
+		goto err_disable_clk;
 	}
 
 	pm_runtime_no_callbacks(dev);
 
 	ret = devm_pm_runtime_enable(dev);
 	if (ret < 0) {
-		clk_disable_unprepare(stm32_pcie->clk);
-		stm32_remove_pcie_port(stm32_pcie);
-		return dev_err_probe(dev, ret, "Failed to enable runtime PM\n");
+		dev_err_probe(dev, ret, "Failed to enable runtime PM\n");
+		goto err_disable_clk;
 	}
 
 	ret = dw_pcie_host_init(&stm32_pcie->pci.pp);
-- 
2.47.2