Re: [PATCH] ARM: dts: imx6ull-engicam-microgea-rmm: fix report-rate-hz value

[Shawn Guo <shawnguo2@yeah.net>]

On Sat, Sep 13, 2025 at 11:16:31AM +0200, Dario Binacchi wrote:
> The 'report-rate-hz' property for the edt-ft5x06 driver was added and
> handled in the Linux kernel by me with patches [1] and [2] for this
> specific board.
> 
> The v1 upstream version, which was the one applied to the customer's
> kernel, used the 'report-rate' property, which was written directly to
> the controller register. During review, the 'hz' suffix was added,
> changing its handling so that writing the value directly to the register
> was no longer possible for the M06 controller.
> 
> Once the patches were accepted in mainline, I did not reapply them to
> the customer's kernel, and when upstreaming the DTS for this board, I
> forgot to correct the 'report-rate-hz' property value.
> 
> The property must be set to 60 because this board uses the M06 controller,
> which expects the report rate in units of 10 Hz, meaning the actual value
> written to the register is 6.
> 
> [1] 625f829586ea ("dt-bindings: input: touchscreen: edt-ft5x06: add report-rate-hz")
> [2] 5bcee83a406c ("Input: edt-ft5x06 - set report rate by dts property")
> Fixes: ffea3cac94ba ("ARM: dts: imx6ul: support Engicam MicroGEA RMM board")
> Co-developed-by: Michael Trimarchi <michael@amarulasolutions.com>
> Signed-off-by: Michael Trimarchi <michael@amarulasolutions.com>
> Signed-off-by: Dario Binacchi <dario.binacchi@amarulasolutions.com>

Applied, thanks!