Re: [PATCH v7 0/2] PCI: Configure Root Port MPS during host probing

[Niklas Cassel <cassel@kernel.org>]

On Sun, Jan 18, 2026 at 09:26:45PM +0800, Hans Zhang wrote:
> On 2025/12/31 10:58, Ricardo Pardini wrote:
> > On 27/11/2025 18:09, Hans Zhang wrote:
> > > Current PCIe initialization exhibits a key optimization gap: Root Ports
> > > may operate with non-optimal Maximum Payload Size (MPS) settings. While
> > > downstream device configuration is handled during bus enumeration, Root
> > > Port MPS values inherited from firmware or hardware defaults often fail
> > > to utilize the full capabilities supported by controller hardware. This
> > > results in suboptimal data transfer efficiency throughout the PCIe
> > > hierarchy.
> > > 
> > > This patch series addresses this by:
> > > 
> > > 1. Core PCI enhancement (Patch 1):
> > > - Proactively configures Root Port MPS during host controller probing
> > > - Sets initial MPS to hardware maximum (128 << dev->pcie_mpss)
> > > - Conditional on PCIe bus tuning being enabled (PCIE_BUS_TUNE_OFF unset)
> > >    and not in PCIE_BUS_PEER2PEER mode (which requires default 128 bytes)
> > > - Maintains backward compatibility via PCIE_BUS_TUNE_OFF check
> > > - Preserves standard MPS negotiation during downstream enumeration
> > > 
> > > 2. Driver cleanup (Patch 2):
> > > - Removes redundant MPS configuration from Meson PCIe controller driver
> > > - Functionality is now centralized in PCI core
> > > - Simplifies driver maintenance long-term
> > > 
> > > ---
> > > Changes in v7:
> > > - Exclude PCIE_BUS_PEER2PEER mode from Root Port MPS configuration
> > > - Remove redundant check for upstream bridge (Root Ports don't have one)
> > > - Improve commit message and code comments as per Bjorn.
> > Hi Hans,
> > 
> > I've tested on an Odroid-HC4 with a SATA SSD (via an ASM1061) by
> > applying your v7 on v6.19-rc3 + Bjorn's 20251103221930.1831376-1-
> > helgaas@kernel.org ("PCI: meson: Remove meson_pcie_link_up() timeout,
> > message, speed check" which is required to get the meson PCIe to work at
> > all since 6.18). With that setup I get:
> > 
> > # hdparm --direct -t /dev/sda
> >   Timing O_DIRECT disk reads: 832 MB in  3.00 seconds = 277.33 MB/sec
> > 
> > I've an identical machine, with a similar disk (even slightly faster, on
> > paper), running plain 6.12.y and there I get:
> > 
> > # hdparm --direct -t /dev/sda
> >   Timing O_DIRECT disk reads: 764 MB in  3.00 seconds = 254.26 MB/sec
> > 
> > I repeated those a few times, not very scientific, I know; but anyway:
> > 
> > Tested-by: Ricardo Pardini <ricardo@pardini.net> # on Odroid-HC4
> > 
> > I've also feedback from another user running with this series with
> > success on a different meson PCIe machine, will ask them to TB as well;
> > they had reported a significant drop in performance since v6.18 without
> > this.
> Hi,
> 
> Thank you very much for your test. Let's wait for Bjorn's reply.

Probably too late for the 6.20 / 7.0 merge window...

But.. it would be nice with some kind of feedback from Bjorn.

Is there any chance that this gets applied for 6.21/7.1 or is there
any fundamental objection against this series?


Kind regards,
Niklas