Re: [PATCH 2/2] drm/mediatek: hdmi: report jack plugged state from bridge enable/disable

[Daniel Golle <daniel@makrotopia.org>]

On Fri, May 08, 2026 at 02:29:29PM +0300, Dmitry Baryshkov wrote:
> On Thu, May 07, 2026 at 02:32:45PM +0100, Daniel Golle wrote:
> > On Thu, May 07, 2026 at 12:51:56PM +0300, Dmitry Baryshkov wrote:
> > > On Wed, Apr 15, 2026 at 04:04:16PM +0100, Daniel Golle wrote:
> > > > Notify hdmi-codec of the current sink plugged state from
> > > > mtk_hdmi_bridge_atomic_enable() and mtk_hdmi_bridge_atomic_disable()
> > > > via mtk_hdmi_update_plugged_status(). This matches the pattern used
> > > > by dw-hdmi, which invokes handle_plugged_change() from the bridge
> > > > enable and disable paths so that ASoC jack state stays in sync with
> > > > the actual sink presence across atomic commit cycles, and not only
> > > > on CEC HPD transitions.
> > > > 
> > > > Userspace audio daemons (e.g. pipewire) rely on the jack state to
> > > > route streams, restore per-sink volume levels, and recover the last
> > > > used device after a reconnect. Without this, those transitions are
> > > > missed whenever the sink change is driven by a mode set rather than
> > > > by a bare HPD event.
> > > 
> > > I can only hope to see mtk_hdmi to migrate to DRM_BRIDGE_OP_HDMI and
> > > DRM_BRIDGE_OP_HDMI_AUDIO...
> > > 
> > > I think the correct timing was discussed several times and the overall
> > > conclusion was that the correct time is when the actual HDMI cable is
> > > being plugged / unplugged. See the discussion around [1] and the
> > > captured response of Mark Brown.
> > 
> > Thank you for bringing this to my attention. I'll follow up on it.
> > Meanwhile, can (independent) patch 1/2 already be merged, or at least
> > get reviewed?
> 
> 
> The discussion that I pointed to suggests that the patch is incorrect.

I understand that patch 2/2 is incorrect, but (the independent fix in)
patch 1/2 as well?