Re: [PATCH v2] phy: fsl-imx8mq-usb: add control register regmap

[Frank Li <Frank.li@nxp.com>]

On Tue, May 12, 2026 at 06:12:12PM +0800, Xu Yang wrote:
> The CR port is a simple 16-bit data/address parallel port that is
> provided for on-chip access to the control registers inside the
> USB 3.0 femtoPHY. Add control register regmap and export these
> registers by debugfs to help PHY's diagnostic.
>
> Signed-off-by: Xu Yang <xu.yang_2@nxp.com>
>
> ---
> Changes in v2:
>  - no changes

Do you means "resend" because not change in v2?

Reviewed-by: Frank Li <Frank.Li@nxp.com>

> ---
>  drivers/phy/freescale/phy-fsl-imx8mq-usb.c | 19 ++++++++++++++++++-
>  1 file changed, 18 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/phy/freescale/phy-fsl-imx8mq-usb.c b/drivers/phy/freescale/phy-fsl-imx8mq-usb.c
> index b05d80e849a1..958d114b0c83 100644
> --- a/drivers/phy/freescale/phy-fsl-imx8mq-usb.c
> +++ b/drivers/phy/freescale/phy-fsl-imx8mq-usb.c
> @@ -1,5 +1,5 @@
>  // SPDX-License-Identifier: GPL-2.0+
> -/* Copyright (c) 2017 NXP. */
> +/* Copyright 2017-2026 NXP. */
>
>  #include <linux/bitfield.h>
>  #include <linux/clk.h>
> @@ -9,6 +9,7 @@
>  #include <linux/of.h>
>  #include <linux/phy/phy.h>
>  #include <linux/platform_device.h>
> +#include <linux/regmap.h>
>  #include <linux/regulator/consumer.h>
>  #include <linux/usb/typec_mux.h>
>
> @@ -55,6 +56,8 @@
>  #define PHY_CTRL6_ALT_CLK_EN		BIT(1)
>  #define PHY_CTRL6_ALT_CLK_SEL		BIT(0)
>
> +#define PHY_CRCTL			0x30
> +
>  #define PHY_TUNE_DEFAULT		0xffffffff
>
>  #define TCA_CLK_RST			0x00
> @@ -118,6 +121,7 @@ struct imx8mq_usb_phy {
>  	void __iomem *base;
>  	struct regulator *vbus;
>  	struct tca_blk *tca;
> +	struct regmap *cr_regmap;
>  	u32 pcs_tx_swing_full;
>  	u32 pcs_tx_deemph_3p5db;
>  	u32 tx_vref_tune;
> @@ -685,6 +689,14 @@ static const struct of_device_id imx8mq_usb_phy_of_match[] = {
>  };
>  MODULE_DEVICE_TABLE(of, imx8mq_usb_phy_of_match);
>
> +static const struct regmap_config imx_cr_regmap_config = {
> +	.name = "cr",
> +	.reg_bits = 32,
> +	.val_bits = 32,
> +	.reg_stride = 4,
> +	.max_register = 0x7,
> +};
> +
>  static int imx8mq_usb_phy_probe(struct platform_device *pdev)
>  {
>  	struct phy_provider *phy_provider;
> @@ -713,6 +725,11 @@ static int imx8mq_usb_phy_probe(struct platform_device *pdev)
>  	if (IS_ERR(imx_phy->base))
>  		return PTR_ERR(imx_phy->base);
>
> +	imx_phy->cr_regmap = devm_regmap_init_mmio(dev, imx_phy->base + PHY_CRCTL,
> +						   &imx_cr_regmap_config);
> +	if (IS_ERR(imx_phy->cr_regmap))
> +		return PTR_ERR(imx_phy->cr_regmap);
> +
>  	phy_ops = of_device_get_match_data(dev);
>  	if (!phy_ops)
>  		return -EINVAL;
> --
> 2.34.1
>