[linux-sunxi] Re: [PATCH] ARM: sun8i: h2+: add support for Banana Pi M2 Zero board

[icenowy@aosc.io (Icenowy Zheng)]

? 2017-11-02 23:50?Maxime Ripard ???
> On Thu, Nov 02, 2017 at 05:07:30PM +0800, Icenowy Zheng wrote:
>> > > +&mmc0 {
>> > > +	pinctrl-names = "default";
>> > > +	pinctrl-0 = <&mmc0_pins_a>;
>> > > +	vmmc-supply = <&reg_vcc3v3>;
>> > > +	bus-width = <4>;
>> > > +	/*
>> > > +	 * In different revisions the board have different card detect
>> > > +	 * configuration.
>> > > +	 */
>> >
>> > Which ones?
>> 
>> In the sample batch (1.2V fixed voltage) the card detect is normal
>> (PF6 low as inserted), however in the final batch (1.1V/1.3V
>> switchable) it's inverted at PF6 (high as inserted).
> 
> Then just use the final version's.
> 
>> > > +&usbphy {
>> > > +	usb0_id_det-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
>> > > +	/* USB OTG VBUS is directly connected to 5V without any regulators
>> > > */
>> >
>> > So it cannot operate in OTG, but it's host only?
>> 
>> It can operate in OTG -- you can power the board via the OTG port,
>> as the VBUS is not gated from 5V at all, so 5V power at VBUS will
>> power up the board. Yes, it's a bit unsafe, but the board designer
>> did it.
> 
> What will provide the 5v in the first place then if a USB device is
> connected to the micro-USB connector?

There're two micro-USB connectors, one is power-only and another is
OTG. The Vbus of these two connectors are connected together, so
the external USB device will be powered just by the power input
from the power-only USB port.

> 
> Maxime