Re: [PATCH v2 17/18] arm64: dts: ti: k3-v3link: Add overlay for IMX219+UB953 serializer

["Kumar, Udit" <u-kumar1@ti.com>]

On 7/13/2026 5:04 PM, Yemike Abhilash Chandra wrote:
> From: Jianzhong Xu <xuj@ti.com>
> 
> Arducam V3Link camera solution is shipped with an UB953 serializer
> and an IMX219 sensor[1]. Add an overlay for interfacing the UB953
> serilaizer and IMX219 sensor with the RX0 port on the UB960 deserializer.
> 
> This overlay can be used to interface an IMX219 sensor on any platform
> that supports the V3Link fusion board.
> 
> [1]: https://docs.arducam.com/V3Link-Camera-Solution/V3Link-Camera-Solution-on-TI-Platform/Introduction/
> 
> Signed-off-by: Jianzhong Xu <xuj@ti.com>
> Signed-off-by: Yemike Abhilash Chandra <y-abhilashchandra@ti.com>
> ---
> Changelog:
> Changes in v2:
> - Don't replacing generic V3Link fusion board DTB targets instead append new build
>   targets for v3link + IMX219 (sashiko)
> - Add status = "okay" property in port 0 of deserializer ports (sashiko)
> - Add port-specific suffixes to avoid naming collisions (sashiko)
> 



>  arch/arm64/boot/dts/ti/Makefile               |  19 +++
>  .../boot/dts/ti/k3-v3link-imx219-0-0.dtso     | 128 ++++++++++++++++++
>  2 files changed, 147 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/ti/k3-v3link-imx219-0-0.dtso
> 
> [..]> +// SPDX-License-Identifier: GPL-2.0
> +/*
> + * IMX219 Camera Module for V3-Link d-ch Adapter Board
> + * https://docs.arducam.com/V3Link-Camera-Solution/V3Link-Camera-Solution-on-TI-Platform/Introduction/
> + *
> + * Copyright (c) 2024 Texas Instruments Incorporated - http://www.ti.com/

Copyright 2026, with this change
Reviewed-by: Udit Kumar <u-kumar1@ti.com>

> + */
> +
> +/dts-v1/;
> +/plugin/;
> +
> [..]