linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: jkrzyszt@tis.icnet.pl (Janusz Krzysztofik)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v2 0/7] ARM: OMAP1: ams-delta: replace custom I/O with GPIO
Date: Tue, 20 Dec 2011 00:08:50 +0100	[thread overview]
Message-ID: <cover.1324331816.git.jkrzyszt@tis.icnet.pl> (raw)
In-Reply-To: <1323634328-856-1-git-send-email-jkrzyszt@tis.icnet.pl>

The Amstrad Delta board has two extra output ports used for driving
input lines of different on-board devices. Those ports are now
controlled with custom functions, provided by the board arch code and
used by several device drivers.

The idea behind the series is to replace those custom I/O functions
with gpiolib API. This way, existing drivers can be made less platform
dependent, and some of them perhaps even superseded with generic GPIO
based drivers after the board platform device descriptions are
converted. Moreover, should a new driver for the on-board Smart Card
controller ever be created, it could be designed as a generic GPIO
based driver, not a custom one.

Changes against initial version:
* the initial patch, which tried to move the gpio-generic driver
  initialization up to the postcore_initcall level, replaced with an
  alternative solution, moving the on-board devices initialization down
  to late_initcall; thanks to Tony Lindgren who suggested this solution,
* dropped patches introducing changes to the modem and ASoC device
  handling; those will be addressed in a separate patch series,
* final cleanups also dropped until those remaining devices are updated,
* the serio driver now takes care of one more GPIO pin which, even if
  not used, belongs to the device interface and affects its functioning,
* misc code and changelog cosmetic cleanups,
* rebased on top of 3.2-rc6.


Thanks to those who reviewed the initial submission and responded with
their comments or Acks.

Janusz


Janusz Krzysztofik (7):
  ARM: OMAP1: ams-delta: register latch dependent devices later
  ARM: OMAP1: ams-delta: convert latches to basic_mmio_gpio
  ARM: OMAP1: ams-delta: supersede custom led device by leds-gpio
  LED: drop leds-ams-delta driver
  MTD: NAND: ams-delta: use GPIO instead of custom I/O
  omapfb: lcd_ams_delta: drive control lines over GPIO
  input: serio: ams-delta: toggle keyboard power over GPIO

 arch/arm/mach-omap1/Kconfig                       |    2 +
 arch/arm/mach-omap1/board-ams-delta.c             |  226 +++++++++++++++++----
 arch/arm/plat-omap/include/plat/board-ams-delta.h |   48 ++---
 drivers/input/serio/ams_delta_serio.c             |   51 +++--
 drivers/leds/Kconfig                              |    7 -
 drivers/leds/Makefile                             |    1 -
 drivers/leds/leds-ams-delta.c                     |  137 -------------
 drivers/mtd/nand/ams-delta.c                      |   74 +++++--
 drivers/video/omap/lcd_ams_delta.c                |   27 ++-
 sound/soc/omap/ams-delta.c                        |    4 +
 10 files changed, 318 insertions(+), 259 deletions(-)
 delete mode 100644 drivers/leds/leds-ams-delta.c

-- 
1.7.3.4

  parent reply	other threads:[~2011-12-19 23:08 UTC|newest]

Thread overview: 63+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2011-12-11 20:11 [PATCH 00/10] ARM: OMAP1: ams-delta: replace custom I/O with GPIO Janusz Krzysztofik
2011-12-11 20:11 ` [PATCH 01/10] GPIO: gpio-generic: Move initialization up to postcore Janusz Krzysztofik
2011-12-12 18:04   ` Tony Lindgren
2011-12-12 23:05     ` Janusz Krzysztofik
2011-12-12 23:15       ` Tony Lindgren
2011-12-12 23:44         ` Janusz Krzysztofik
2011-12-12 23:55           ` Tony Lindgren
2011-12-13  0:15             ` Janusz Krzysztofik
2011-12-14 13:10             ` Janusz Krzysztofik
2011-12-14 18:21               ` Tony Lindgren
2011-12-14 20:07                 ` Janusz Krzysztofik
2011-12-14 22:10                   ` Tony Lindgren
2011-12-14 11:13   ` Janusz Krzysztofik
2011-12-11 20:12 ` [PATCH 02/10] ARM: OMAP1: ams-delta: Convert latches to basic_mmio_gpio Janusz Krzysztofik
2011-12-11 20:12 ` [PATCH 03/10] ARM: OMAP1: ams-delta: Supersede custom led device by leds-gpio Janusz Krzysztofik
2011-12-11 20:12 ` [PATCH 04/10] LED: Drop leds-ams-delta driver Janusz Krzysztofik
2011-12-11 20:12 ` [PATCH 05/10] MTD: NAND: ams-delta: Use GPIO instead of custom I/O Janusz Krzysztofik
2011-12-11 20:12 ` [PATCH 06/10] ARM: OMAP1: ams-delta: Use GPIO API in modem setup Janusz Krzysztofik
2011-12-11 20:12 ` [PATCH 07/10] ASoC: OMAP: ams-delta: Drive modem/codec pins over GPIO API Janusz Krzysztofik
2011-12-12  4:29   ` Mark Brown
2011-12-21 18:33   ` Liam Girdwood
2011-12-21 22:14     ` Janusz Krzysztofik
2011-12-22  9:25       ` Girdwood, Liam
2011-12-11 20:12 ` [PATCH 08/10] omapfb: lcd_ams_delta: Drive control lines over GPIO Janusz Krzysztofik
2011-12-12 11:24   ` Tomi Valkeinen
2011-12-11 20:12 ` [PATCH 09/10] input: serio: ams-delta: Toggle keyboard power " Janusz Krzysztofik
2011-12-12  8:18   ` Dmitry Torokhov
2011-12-11 20:12 ` [PATCH 10/10] ARM: OMAP1: ams-delta: Drop custom I/O functions Janusz Krzysztofik
2011-12-12  5:00 ` [PATCH 00/10] ARM: OMAP1: ams-delta: replace custom I/O with GPIO Jonathan McDowell
2011-12-19 23:08 ` Janusz Krzysztofik [this message]
2011-12-19 23:08 ` [PATCH v2 2/7] ARM: OMAP1: ams-delta: convert latches to basic_mmio_gpio Janusz Krzysztofik
2011-12-20  0:06   ` Tony Lindgren
2011-12-20  0:59     ` Janusz Krzysztofik
2011-12-20  1:04       ` Tony Lindgren
2011-12-20  1:18         ` Janusz Krzysztofik
2011-12-20  2:13           ` Tony Lindgren
2011-12-20  2:24         ` [PATCH v2 2/7 v2] " Janusz Krzysztofik
2011-12-19 23:08 ` [PATCH v2 3/7] ARM: OMAP1: ams-delta: supersede custom led device by leds-gpio Janusz Krzysztofik
2011-12-19 23:08 ` [PATCH v2 4/7] LED: drop leds-ams-delta driver Janusz Krzysztofik
2011-12-19 23:08 ` [PATCH v2 5/7] MTD: NAND: ams-delta: use GPIO instead of custom I/O Janusz Krzysztofik
2011-12-21 19:12   ` Tony Lindgren
2011-12-21 19:45     ` Janusz Krzysztofik
2011-12-21 20:56   ` Artem Bityutskiy
2011-12-19 23:08 ` [PATCH v2 6/7] omapfb: lcd_ams_delta: drive control lines over GPIO Janusz Krzysztofik
2011-12-19 23:08 ` [PATCH v2 7/7] input: serio: ams-delta: toggle keyboard power " Janusz Krzysztofik
2011-12-20 22:10   ` [PATCH] " Janusz Krzysztofik
2011-12-21 19:09     ` Tony Lindgren
2011-12-21 19:55       ` Janusz Krzysztofik
2011-12-22 17:45         ` Dmitry Torokhov
2011-12-22 18:06           ` Tony Lindgren
     [not found] ` <83e934adfc691b347534edb7788a67ab2e6bd7e1.1324331816.git.jkrzyszt@tis.icnet.pl>
2011-12-19 23:28   ` [PATCH v2 1/7][RESEND] ARM: OMAP1: ams-delta: register latch dependent devices later Janusz Krzysztofik
2011-12-20 18:06     ` Tony Lindgren
2011-12-20 20:34       ` Janusz Krzysztofik
2011-12-20 20:57         ` Tony Lindgren
2011-12-20 20:40     ` Russell King - ARM Linux
2011-12-20 20:51       ` [alsa-devel] " Janusz Krzysztofik
2011-12-20 21:54     ` [PATCH v2 1/7 v2] " Janusz Krzysztofik
2011-12-21 19:08       ` Tony Lindgren
2011-12-21 19:51         ` Janusz Krzysztofik
2011-12-21 20:07           ` Tony Lindgren
2011-12-22 10:39             ` Janusz Krzysztofik
2011-12-22 11:08               ` Jarkko Nikula
2011-12-22 11:10                 ` Mark Brown

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=cover.1324331816.git.jkrzyszt@tis.icnet.pl \
    --to=jkrzyszt@tis.icnet.pl \
    --cc=linux-arm-kernel@lists.infradead.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).