From mboxrd@z Thu Jan 1 00:00:00 1970 From: rbyshko@gmail.com (Roman Byshko) Date: Mon, 10 Nov 2014 19:55:05 +0100 Subject: [PATCH v2 0/5] ARM: sunxi: Add support for USB OTG PHY Message-ID: To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi, There is already support for two USB phys, which are used for USB host controllers on Allwinner SoC aka sunxi. This patch series add support for the USB OTG phy (aka phy0). The code has been tested on Allwinner A20 aka sun7i (Cubietruck). Best regards, Roman Byshko Changes since v1: * Improved comment about 45 Ohm resistor calibration * Added Signed-off-by to all patches Roman Byshko (5): phy: sun4i: add support for USB phy0 ARM: dtsi: sunxi: add common VBUS regulator ARM: sun7i: dtsi: add support for usbphy0 ARM: dts: sun7i: Cubietruck: override regulator pin ARM: dts: sun7i: Cubietruck: add power supply regulator for USB OTG VBUS arch/arm/boot/dts/sun7i-a20-cubietruck.dts | 14 ++++++++++++++ arch/arm/boot/dts/sun7i-a20.dtsi | 4 ++-- arch/arm/boot/dts/sunxi-common-regulators.dtsi | 19 +++++++++++++++++++ drivers/phy/phy-sun4i-usb.c | 9 ++++++--- 4 files changed, 41 insertions(+), 5 deletions(-) -- 2.1.2