Re: [PATCH 0/4] wifi: unwind failed interface setup and recovery

[Jeff Johnson <jeff.johnson@oss.qualcomm.com>]

On 10/27/2026 10:03 PM, Jiale Yao wrote:
> Several wireless interface setup and reset recovery paths publish host
> pointers or create firmware state before later operations which can fail.
> Their error paths either retain pointers to vifs that mac80211 will free
> or continue after firmware interface restoration has failed.
> 
> Clear the published ath10k and iwlwifi pointers on add failure. Check the
> mt7921 and mt7925 firmware restore results, remove partial state and stop
> configuring the affected interface. Each patch fixes an independent
> driver path and can be applied separately.
> 
> Jiale Yao (4):
>   wifi: ath10k: clear monitor interface after add failure
>   wifi: iwlwifi: mvm: clear P2P device pointer on add failure
>   wifi: mt76: mt7921: unwind interface restore failures
>   wifi: mt76: mt7925: unwind link restore failures
> 
>  drivers/net/wireless/ath/ath10k/mac.c         |  1 +
>  .../wireless/intel/iwlwifi/mvm/mld-mac80211.c |  5 +++-
>  .../net/wireless/mediatek/mt76/mt7921/mac.c   | 16 +++++++++---
>  .../net/wireless/mediatek/mt76/mt7925/mac.c   | 26 ++++++++++++++++---
>  4 files changed, 41 insertions(+), 7 deletions(-)
> 

You are sending patches that fall into 3 different maintainer trees in one series.

It is much easier for us maintainers if you split your patches by maintainer.

/jeff