From mboxrd@z Thu Jan 1 00:00:00 1970 From: javier@osg.samsung.com (Javier Martinez Canillas) Date: Thu, 5 May 2016 15:56:06 -0400 Subject: [RFC v2 10/13] usb: hub: Power sequence the ports on activation In-Reply-To: <1462451666-17945-11-git-send-email-k.kozlowski@samsung.com> References: <1462451666-17945-1-git-send-email-k.kozlowski@samsung.com> <1462451666-17945-11-git-send-email-k.kozlowski@samsung.com> Message-ID: To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hello Krzysztof, On 05/05/2016 08:34 AM, Krzysztof Kozlowski wrote: > The autodetection of attached USB device might not work on certain > boards where the power is delivered externally. These devices also might > require a hard reset. Use pwrseq for that in USB hub. > > Signed-off-by: Krzysztof Kozlowski > --- Patch looks good to me. So after fixing the bisectability issue pointed out by Alan Stern: Reviewed-by: Javier Martinez Canillas Best regards, -- Javier Martinez Canillas Open Source Group Samsung Research America