adding pxa3xx_nand_flash to platform data

[haojian.zhuang@gmail.com (Haojian Zhuang)]

On Wed, May 5, 2010 at 4:56 AM, Eric Miao <eric.y.miao@gmail.com> wrote:
> On Wed, May 5, 2010 at 4:56 PM, Eric Miao <eric.y.miao@gmail.com> wrote:
>> On Wed, May 5, 2010 at 3:58 PM, Siddarth Gore <gores@marvell.com> wrote:
>>> Hello Eric,
>>>
>>> Currently I need to enable the deprecated MTD_NAND_PXA3xx_BUILTIN
>>> support for Aspenite DB board (pxa168). I have a patch ready to add
>>> pxa3xx_nand_flash in aspenite.c but I was wondering about the cmdset
>>> field in it.
>>> Looks like it is the same for all boards (depending upon the page size).
>>> So should I add it to the board specific setup file or remove it from
>>> pxa3xx_nand_platform_data (and put it in say, pxa3xx_nand_info)?
>>>
>>> If there are boards which require a different cmdset then we have to go
>>> with first option, if not, we can use option two and save some code
>>> duplication.
>>>
>>
>> There are normally two sets of commands, yet the code derived from some
>> previous work that there were several subtle different command sets.
>>

We already formated the patches of removing the duplication. Now it's
put into mailist. Try these patches.

Thanks
Haojian