From: Tatyana Brokhman <tlinder@codeaurora.org>
To: linux-usb@vger.kernel.org
Cc: linux-arm-msm@vger.kernel.org,
Tatyana Brokhman <tlinder@codeaurora.org>,
Greg Kroah-Hartman <gregkh@suse.de>,
Matthew Wilcox <willy@linux.intel.com>,
Sarah Sharp <sarah.a.sharp@linux.intel.com>,
linux-kernel@vger.kernel.org
Subject: [PATCH v5] usb: usb3.0 ch9 definitions
Date: Sat, 9 Oct 2010 16:46:12 +0200 [thread overview]
Message-ID: <1286635573-30035-1-git-send-email-tlinder@codeaurora.org> (raw)
Adding SuperSpeed usb definitions as defined by ch9 of the USB3.0 spec.
This patch is a preparation for adding SuperSpeed support to the gadget
framework.
Signed-off-by: Tatyana Brokhman<tlinder@codeaurora.org>
---
include/linux/usb/ch9.h | 58 ++++++++++++++++++++++++++++++++++++++++++++++-
1 files changed, 57 insertions(+), 1 deletions(-)
diff --git a/include/linux/usb/ch9.h b/include/linux/usb/ch9.h
index da2ed77..fc5506f 100644
--- a/include/linux/usb/ch9.h
+++ b/include/linux/usb/ch9.h
@@ -123,8 +123,23 @@
#define USB_DEVICE_A_ALT_HNP_SUPPORT 5 /* (otg) other RH port does */
#define USB_DEVICE_DEBUG_MODE 6 /* (special devices only) */
+/*
+ * New Feature Selectors as added by USB 3.0
+ * See USB 3.0 spec Table 9-6
+ */
+#define USB_DEVICE_U1_ENABLE 48 /* dev may initiate U1 transition */
+#define USB_DEVICE_U2_ENABLE 49 /* dev may initiate U2 transition */
+#define USB_DEVICE_LTM_ENABLE 50 /* dev may send LTM */
+#define USB_INTRF_FUNC_SUSPEND 0 /* function suspend */
+
+#define USB_INTR_FUNC_SUSPEND_OPT_MASK 0xFF00
+
#define USB_ENDPOINT_HALT 0 /* IN/OUT will STALL */
+/* Bit array elements as returned by the USB_REQ_GET_STATUS request. */
+#define USB_DEV_STAT_U1_ENABLED 2 /* transition into U1 state */
+#define USB_DEV_STAT_U2_ENABLED 3 /* transition into U2 state */
+#define USB_DEV_STAT_LTM_ENABLED 4 /* Latency tolerance messages */
/**
* struct usb_ctrlrequest - SETUP data for a USB device control request
@@ -675,6 +690,7 @@ struct usb_bos_descriptor {
__u8 bNumDeviceCaps;
} __attribute__((packed));
+#define USB_DT_BOS_SIZE 5
/*-------------------------------------------------------------------------*/
/* USB_DT_DEVICE_CAPABILITY: grouped with BOS */
@@ -712,16 +728,56 @@ struct usb_wireless_cap_descriptor { /* Ultra Wide Band */
__u8 bReserved;
} __attribute__((packed));
+/* USB 2.0 Extension descriptor */
#define USB_CAP_TYPE_EXT 2
struct usb_ext_cap_descriptor { /* Link Power Management */
__u8 bLength;
__u8 bDescriptorType;
__u8 bDevCapabilityType;
- __u8 bmAttributes;
+ __le32 bmAttributes;
#define USB_LPM_SUPPORT (1 << 1) /* supports LPM */
} __attribute__((packed));
+#define USB_DT_USB_EXT_CAP_SIZE 7
+
+/*
+ * SuperSpeed USB Capability descriptor: Defines the set of SuperSpeed USB
+ * specific device level capabilities
+ */
+#define USB_SS_CAP_TYPE 3
+struct usb_ss_cap_descriptor { /* Link Power Management */
+ __u8 bLength;
+ __u8 bDescriptorType;
+ __u8 bDevCapabilityType;
+ __u8 bmAttributes;
+#define USB_LTM_SUPPORT (1 << 1) /* supports LTM */
+ __le16 wSpeedSupported;
+#define USB_LOW_SPEED_OPERATION (1) /* Low speed operation */
+#define USB_FULL_SPEED_OPERATION (1 << 1) /* Full speed operation */
+#define USB_HIGH_SPEED_OPERATION (1 << 2) /* High speed operation */
+#define USB_5GBPS_OPERATION (1 << 3) /* Operation at 5Gbps */
+ __u8 bFunctionalitySupport;
+ __u8 bU1devExitLat;
+ __le16 bU2DevExitLat;
+} __attribute__((packed));
+
+#define USB_DT_USB_SS_CAP_SIZE 10
+
+/*
+ * Container ID Capability descriptor: Defines the instance unique ID used to
+ * identify the instance across all operating modes
+ */
+#define CONTAINER_ID_TYPE 4
+struct usb_ss_container_id_descriptor {
+ __u8 bLength;
+ __u8 bDescriptorType;
+ __u8 bDevCapabilityType;
+ __u8 bReserved;
+ __u8 ContainerID[16]; /* 128-bit number */
+} __attribute__((packed));
+
+#define USB_DT_USB_SS_CONTN_ID_SIZE 20
/*-------------------------------------------------------------------------*/
/* USB_DT_WIRELESS_ENDPOINT_COMP: companion descriptor associated with
--
1.6.3.3
--
Sent by an consultant of the Qualcomm Inovation Center, Inc.
The Qualcomm Inovation Center, Inc.is a member of the Code Aurora Forum.
next reply other threads:[~2010-10-09 14:46 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-10-09 14:46 Tatyana Brokhman [this message]
2010-10-10 8:10 ` [PATCH v5] usb: usb3.0 ch9 definitions Matthew Wilcox
2010-10-10 9:49 ` tlinder
2010-10-20 6:48 ` tlinder
2010-10-10 10:32 ` Sergei Shtylyov
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1286635573-30035-1-git-send-email-tlinder@codeaurora.org \
--to=tlinder@codeaurora.org \
--cc=gregkh@suse.de \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-usb@vger.kernel.org \
--cc=sarah.a.sharp@linux.intel.com \
--cc=willy@linux.intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).