[PATCH V2 7/7] USB: OTG: msm: Clear in_lpm flag before enabling the IRQ in resume

[Pavankumar Kondeti <pkondeti@codeaurora.org>]

The current code is clearing in_lpm flag after enabling the IRQ.
If IRQ comes immediately before in_lpm flag is set, it thinks that
hardware is in low power mode and disables the IRQ.  Fix this by
clearing in_lpm flag before enabling the IRQ.

Signed-off-by: Pavankumar Kondeti <pkondeti@codeaurora.org>
---
 drivers/usb/otg/msm_otg.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/usb/otg/msm_otg.c b/drivers/usb/otg/msm_otg.c
index 2965986..f58b7da 100644
--- a/drivers/usb/otg/msm_otg.c
+++ b/drivers/usb/otg/msm_otg.c
@@ -389,14 +389,14 @@ skip_phy_resume:
 	if (bus)
 		set_bit(HCD_FLAG_HW_ACCESSIBLE, &(bus_to_hcd(bus))->flags);
 
+	atomic_set(&motg->in_lpm, 0);
+
 	if (motg->async_int) {
 		motg->async_int = 0;
 		pm_runtime_put(otg->dev);
 		enable_irq(motg->irq);
 	}
 
-	atomic_set(&motg->in_lpm, 0);
-
 	dev_info(otg->dev, "USB exited from low power mode\n");
 
 	return 0;
-- 
Sent by a consultant of the Qualcomm Innovation Center, Inc.
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum.