From: "Ivan T. Ivanov" <iivanov@mm-sol.com>
To: balbi@ti.com
Cc: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>,
Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
linux-usb@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-arm-msm@vger.kernel.org
Subject: Re: [PATCH v8 02/20] usb: phy: msm: Remove __init macro from driver probe method
Date: Mon, 28 Apr 2014 20:52:48 +0300 [thread overview]
Message-ID: <1398707568.23146.0.camel@violet> (raw)
In-Reply-To: <20140428170357.GP30292@saruman.home>
On Mon, 2014-04-28 at 12:03 -0500, Felipe Balbi wrote:
> On Mon, Apr 28, 2014 at 09:00:43PM +0400, Sergei Shtylyov wrote:
> > Hello.
> >
> > On 04/28/2014 05:34 PM, Ivan T. Ivanov wrote:
> >
> > >From: "Ivan T. Ivanov" <iivanov@mm-sol.com>
> >
> > >This fixes following:
> >
> > >WARNING: drivers/usb/phy/built-in.o(.data+0x68): Section mismatch in reference from the variable msm_otg_driver to the function .init.text:msm_otg_probe()
> > >The variable msm_otg_driver references
> > >the function __init msm_otg_probe()
> >
> > Hm, this warning shouldn't occur before patch #4, no?
>
> good catch, this could probably be merged there.
True. Should I resend it?
Regards,
Ivan
next prev parent reply other threads:[~2014-04-28 19:11 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-04-28 13:34 [PATCH v8 00/20] usb: phy: msm: Fixes, cleanups and DT support Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 01/20] usb: phy: msm: Make driver selectable on ARCH_QCOM Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 02/20] usb: phy: msm: Remove __init macro from driver probe method Ivan T. Ivanov
[not found] ` <535E893B.7050609@cogentembedded.com>
[not found] ` <20140428170357.GP30292@saruman.home>
2014-04-28 17:52 ` Ivan T. Ivanov [this message]
2014-04-28 17:54 ` Felipe Balbi
2014-04-28 17:57 ` Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 04/20] usb: phy: msm: Enable deferred driver probing Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 05/20] usb: phy: msm: Migrate to Managed Device Resource allocation Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 06/20] usb: phy: msm: Remove unnecessarily check for valid regulators Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 07/20] usb: phy: msm: Fix checkpatch.pl warnings Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 08/20] usb: phy: msm: Replace custom enum usb_mode_type with enum usb_dr_mode Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 09/20] usb: phy: msm: Remove unused pclk_src_name Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 10/20] usb: phy: msm: Remove HSUSB prefix from regulator names Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 11/20] usb: phy: msm: Properly check result from platform_get_irq() Ivan T. Ivanov
[not found] ` <1398692063-11372-1-git-send-email-iivanov-NEYub+7Iv8PQT0dZR+AlfA@public.gmane.org>
2014-04-28 13:34 ` [PATCH v8 03/20] usb: phy: msm: Move global regulators variables to driver state Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 12/20] usb: phy: msm: Add device tree support and binding information Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 19/20] usb: phy: msm: Vote for corner of VDD CX instead of voltage of VDD CX Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 13/20] usb: phy: msm: Use reset framework for LINK and PHY resets Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 14/20] usb: phy: msm: Add support for secondary PHY control Ivan T. Ivanov
2014-04-30 16:22 ` Felipe Balbi
2014-04-28 13:34 ` [PATCH v8 15/20] usb: phy: msm: Correct USB PHY Reset sequence for newer platform Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 16/20] usb: phy: msm: Fix PTS definitions for MSM USB controller Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 17/20] usb: phy: msm: Select secondary PHY via TCSR Ivan T. Ivanov
2014-04-30 16:23 ` Felipe Balbi
2014-05-03 6:45 ` Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 18/20] usb: phy: msm: Handle disconnect events Ivan T. Ivanov
2014-04-28 13:34 ` [PATCH v8 20/20] usb: phy: msm: Use usb_add_phy_dev() to register device Ivan T. Ivanov
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1398707568.23146.0.camel@violet \
--to=iivanov@mm-sol.com \
--cc=balbi@ti.com \
--cc=gregkh@linuxfoundation.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-usb@vger.kernel.org \
--cc=sergei.shtylyov@cogentembedded.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).