[PATCH/RFC V2 08/16] scsi: ufs: introduce well known logical unit in ufs

[Dolev Raviv <draviv@codeaurora.org>]

From: Subhash Jadavani <subhashj@codeaurora.org>

UFS device may have standard LUs and LUN id could be from 0x00 to 0x7F.
UFS device specification use "Peripheral Device Addressing Format"
(SCSI SAM-5) for standard LUs.

UFS device may also have the Well Known LUs (also referred as W-LU) which
again could be from 0x00 to 0x7F. For W-LUs, UFS device specification only
allows the "Extended Addressing Format" (SCSI SAM-5) which means the W-LUNs
would start from 0xC100 onwards.

This means max. LUN number reported from UFS device could be 0xC17F hence
this patch advertise the "max_lun" as 0xC17F which will allow SCSI mid
layer to detect the W-LUs as well.

But once the W-LUs are detected, UFSHCD driver may get the commands with
SCSI LUN id upto 0xC17F but UPIU LUN id field is only 8-bit wide so it
requires the mapping of SCSI LUN id to UPIU LUN id. This patch also add
support for this mapping.

Signed-off-by: Subhash Jadavani <subhashj@codeaurora.org>
Signed-off-by: Dolev Raviv <draviv@codeaurora.org>
Signed-off-by: Sujit Reddy Thumma <sthumma@codeaurora.org>

diff --git a/drivers/scsi/ufs/ufs.h b/drivers/scsi/ufs/ufs.h
index b0e1f62..bcc3a7f 100644
--- a/drivers/scsi/ufs/ufs.h
+++ b/drivers/scsi/ufs/ufs.h
@@ -49,9 +49,28 @@
 #define UPIU_HEADER_DWORD(byte3, byte2, byte1, byte0)\
 			cpu_to_be32((byte3 << 24) | (byte2 << 16) |\
 			 (byte1 << 8) | (byte0))
-
+/*
+ * UFS device may have standard LUs and LUN id could be from 0x00 to
+ * 0x7F. Standard LUs use "Peripheral Device Addressing Format".
+ * UFS device may also have the Well Known LUs (also referred as W-LU)
+ * which again could be from 0x00 to 0x7F. For W-LUs, device only use
+ * the "Extended Addressing Format" which means the W-LUNs would be
+ * from 0xc100 (SCSI_W_LUN_BASE) onwards.
+ * This means max. LUN number reported from UFS device could be 0xC17F.
+ */
+#define UFS_UPIU_MAX_UNIT_NUM_ID	0x7F
+#define UFS_MAX_LUNS		(SCSI_W_LUN_BASE + UFS_UPIU_MAX_UNIT_NUM_ID)
+#define UFS_UPIU_WLUN_ID	(1 << 7)
 #define UFS_UPIU_MAX_GENERAL_LUN	8
 
+/* Well known logical unit id in LUN field of UPIU */
+enum {
+	UFS_UPIU_REPORT_LUNS_WLUN	= 0x81,
+	UFS_UPIU_UFS_DEVICE_WLUN	= 0xD0,
+	UFS_UPIU_BOOT_WLUN		= 0xB0,
+	UFS_UPIU_RPMB_WLUN		= 0xC4,
+};
+
 /*
  * UFS Protocol Information Unit related definitions
  */
diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
index a851323..876d210 100644
--- a/drivers/scsi/ufs/ufshcd.c
+++ b/drivers/scsi/ufs/ufshcd.c
@@ -100,7 +100,6 @@ static u32 ufs_query_desc_max_size[] = {
 enum {
 	UFSHCD_MAX_CHANNEL	= 0,
 	UFSHCD_MAX_ID		= 1,
-	UFSHCD_MAX_LUNS		= 8,
 	UFSHCD_CMD_PER_LUN	= 32,
 	UFSHCD_CAN_QUEUE	= 32,
 };
@@ -902,6 +901,21 @@ static int ufshcd_compose_upiu(struct ufs_hba *hba, struct ufshcd_lrb *lrbp)
 }
 
 /**
+ * ufshcd_scsi_to_upiu_lun - maps scsi LUN to UPIU LUN
+ * @scsi_lun: scsi LUN id
+ *
+ * Returns UPIU LUN id
+ */
+static inline u8 ufshcd_scsi_to_upiu_lun(unsigned int scsi_lun)
+{
+	if (scsi_is_wlun(scsi_lun))
+		return (scsi_lun & UFS_UPIU_MAX_UNIT_NUM_ID)
+			| UFS_UPIU_WLUN_ID;
+	else
+		return scsi_lun & UFS_UPIU_MAX_UNIT_NUM_ID;
+}
+
+/**
  * ufshcd_queuecommand - main entry point for SCSI requests
  * @cmd: command from SCSI Midlayer
  * @done: call back function
@@ -959,7 +973,7 @@ static int ufshcd_queuecommand(struct Scsi_Host *host, struct scsi_cmnd *cmd)
 	lrbp->sense_bufflen = SCSI_SENSE_BUFFERSIZE;
 	lrbp->sense_buffer = cmd->sense_buffer;
 	lrbp->task_tag = tag;
-	lrbp->lun = cmd->device->lun;
+	lrbp->lun = ufshcd_scsi_to_upiu_lun(cmd->device->lun);
 	lrbp->intr_cmd = false;
 	lrbp->command_type = UTP_CMD_TYPE_SCSI;
 
@@ -1513,7 +1527,7 @@ static inline int ufshcd_read_unit_desc_param(struct ufs_hba *hba,
 	 * Unit descriptors are only available for general purpose LUs (LUN id
 	 * from 0 to 7) and RPMB Well known LU.
 	 */
-	if (lun >= UFS_UPIU_MAX_GENERAL_LUN)
+	if (lun != UFS_UPIU_RPMB_WLUN && (lun >= UFS_UPIU_MAX_GENERAL_LUN))
 		return -EOPNOTSUPP;
 
 	return ufshcd_read_desc_param(hba, QUERY_DESC_IDN_UNIT, lun,
@@ -2144,6 +2158,44 @@ static int ufshcd_verify_dev_init(struct ufs_hba *hba)
 }
 
 /**
+ * ufshcd_set_queue_depth - set lun queue depth
+ * @sdev: pointer to SCSI device
+ *
+ * Read bLUQueueDepth value and activate scsi tagged command
+ * queueing. For WLUN, queue depth is set to 1. For best-effort
+ * cases (bLUQueueDepth = 0) the queue depth is set to a maximum
+ * value that host can queue.
+ */
+static void ufshcd_set_queue_depth(struct scsi_device *sdev)
+{
+	int ret = 0;
+	u8 lun_qdepth;
+	struct ufs_hba *hba;
+
+	hba = shost_priv(sdev->host);
+
+	lun_qdepth = hba->nutrs;
+	ret = ufshcd_read_unit_desc_param(hba,
+					  ufshcd_scsi_to_upiu_lun(sdev->lun),
+					  UNIT_DESC_PARAM_LU_Q_DEPTH,
+					  &lun_qdepth,
+					  sizeof(lun_qdepth));
+
+	/* Some WLUN doesn't support unit descriptor */
+	if (ret == -EOPNOTSUPP)
+		lun_qdepth = 1;
+	else if (!lun_qdepth)
+		/* eventually, we can figure out the real queue depth */
+		lun_qdepth = hba->nutrs;
+	else
+		lun_qdepth = min_t(int, lun_qdepth, hba->nutrs);
+
+	dev_dbg(hba->dev, "%s: activate tcq with queue depth %d\n",
+			__func__, lun_qdepth);
+	scsi_activate_tcq(sdev, lun_qdepth);
+}
+
+/**
  * ufshcd_slave_alloc - handle initial SCSI device configurations
  * @sdev: pointer to SCSI device
  *
@@ -2152,8 +2204,6 @@ static int ufshcd_verify_dev_init(struct ufs_hba *hba)
 static int ufshcd_slave_alloc(struct scsi_device *sdev)
 {
 	struct ufs_hba *hba;
-	u8 lun_qdepth;
-	int ret;
 
 	hba = shost_priv(sdev->host);
 	sdev->tagged_supported = 1;
@@ -2168,20 +2218,8 @@ static int ufshcd_slave_alloc(struct scsi_device *sdev)
 	/* REPORT SUPPORTED OPERATION CODES is not supported */
 	sdev->no_report_opcodes = 1;
 
-	ret = ufshcd_read_unit_desc_param(hba,
-					  sdev->lun,
-					  UNIT_DESC_PARAM_LU_Q_DEPTH,
-					  &lun_qdepth,
-					  sizeof(lun_qdepth));
-	if (!ret || !lun_qdepth)
-		/* eventually, we can figure out the real queue depth */
-		lun_qdepth = hba->nutrs;
-	else
-		lun_qdepth = min_t(int, lun_qdepth, hba->nutrs);
 
-	dev_dbg(hba->dev, "%s: activate tcq with queue depth %d\n",
-			__func__, lun_qdepth);
-	scsi_activate_tcq(sdev, lun_qdepth);
+	ufshcd_set_queue_depth(sdev);
 
 	return 0;
 }
@@ -2244,6 +2282,9 @@ static void ufshcd_slave_destroy(struct scsi_device *sdev)
 
 	hba = shost_priv(sdev->host);
 	scsi_deactivate_tcq(sdev, hba->nutrs);
+	/* Drop the reference as it won't be needed anymore */
+	if (ufshcd_scsi_to_upiu_lun(sdev->lun) == UFS_UPIU_UFS_DEVICE_WLUN)
+		hba->sdev_ufs_device = NULL;
 }
 
 /**
@@ -2961,7 +3002,10 @@ static int ufshcd_issue_tm_cmd(struct ufs_hba *hba, int lun_id, int task_id,
 					      lun_id, task_tag);
 	task_req_upiup->header.dword_1 =
 		UPIU_HEADER_DWORD(0, tm_function, 0, 0);
-
+	/*
+	 * The host shall provide the same value for LUN field in the basic
+	 * header and for Input Parameter.
+	 */
 	task_req_upiup->input_param1 = cpu_to_be32(lun_id);
 	task_req_upiup->input_param2 = cpu_to_be32(task_id);
 
@@ -3980,10 +4024,11 @@ int ufshcd_init(struct ufs_hba *hba, void __iomem *mmio_base, unsigned int irq)
 	host->can_queue = hba->nutrs;
 	host->cmd_per_lun = hba->nutrs;
 	host->max_id = UFSHCD_MAX_ID;
-	host->max_lun = UFSHCD_MAX_LUNS;
+	host->max_lun = UFS_MAX_LUNS;
 	host->max_channel = UFSHCD_MAX_CHANNEL;
 	host->unique_id = host->host_no;
 	host->max_cmd_len = MAX_CDB_SIZE;
+	host->report_wlus = 1;
 
 	/* Initailize wait queue for task management */
 	init_waitqueue_head(&hba->tm_wq);
diff --git a/drivers/scsi/ufs/ufshcd.h b/drivers/scsi/ufs/ufshcd.h
index 8365ad4..9b5f77f 100644
--- a/drivers/scsi/ufs/ufshcd.h
+++ b/drivers/scsi/ufs/ufshcd.h
@@ -124,7 +124,7 @@ struct ufshcd_lrb {
 
 	int command_type;
 	int task_tag;
-	unsigned int lun;
+	u8 lun; /* UPIU LUN id field is only 8-bit wide */
 	bool intr_cmd;
 };
 
@@ -266,6 +266,11 @@ struct ufs_hba {
 
 	struct Scsi_Host *host;
 	struct device *dev;
+	/*
+	 * This field is to keep a reference to "scsi_device" corresponding to
+	 * "UFS device" W-LU.
+	 */
+	struct scsi_device *sdev_ufs_device;
 
 	struct ufshcd_lrb *lrb;
 	unsigned long lrb_in_use;
-- 
1.8.5.2
-- 
QUALCOMM ISRAEL, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation