From: Ritesh Harjani <riteshh@codeaurora.org>
To: adrian.hunter@intel.com
Cc: ulf.hansson@linaro.org, linux-mmc@vger.kernel.org,
shawn.lin@rock-chips.com, linux-arm-msm@vger.kernel.org,
georgi.djakov@linaro.org, alex.lemberg@sandisk.com,
mateusz.nowak@intel.com, Yuliy.Izrailov@sandisk.com,
asutoshd@codeaurora.org, david.griego@linaro.org,
stummala@codeaurora.org, venkatg@codeaurora.org,
pramod.gurav@linaro.org, bjorn.andersson@linaro.org,
Ritesh Harjani <riteshh@codeaurora.org>
Subject: [PATCH v4 1/9] mmc: sdhci-msm: Change poor style writel/readl of registers
Date: Wed, 24 Aug 2016 15:33:36 +0530 [thread overview]
Message-ID: <1472033024-14890-2-git-send-email-riteshh@codeaurora.org> (raw)
In-Reply-To: <1472033024-14890-1-git-send-email-riteshh@codeaurora.org>
This patch changes the poor style of writel/readl registers
into more readable format. Also to avoid mixed style format
of readl/writel in sdhci-msm driver.
Signed-off-by: Ritesh Harjani <riteshh@codeaurora.org>
Acked-by: Adrian Hunter <adrian.hunter@intel.com>
---
drivers/mmc/host/sdhci-msm.c | 54 ++++++++++++++++++++++++++------------------
1 file changed, 32 insertions(+), 22 deletions(-)
diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
index 8ef44a2a..42f42aa 100644
--- a/drivers/mmc/host/sdhci-msm.c
+++ b/drivers/mmc/host/sdhci-msm.c
@@ -137,8 +137,9 @@ static int msm_config_cm_dll_phase(struct sdhci_host *host, u8 phase)
writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Set CK_OUT_EN bit of DLL_CONFIG register to 1. */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_CK_OUT_EN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_CK_OUT_EN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Wait until CK_OUT_EN bit of DLL_CONFIG register becomes '1' */
rc = msm_dll_poll_ck_out_en(host, 1);
@@ -305,6 +306,7 @@ static int msm_init_cm_dll(struct sdhci_host *host)
struct mmc_host *mmc = host->mmc;
int wait_cnt = 50;
unsigned long flags;
+ u32 config = 0;
spin_lock_irqsave(&host->lock, flags);
@@ -313,33 +315,40 @@ static int msm_init_cm_dll(struct sdhci_host *host)
* tuning is in progress. Keeping PWRSAVE ON may
* turn off the clock.
*/
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_VENDOR_SPEC)
- & ~CORE_CLK_PWRSAVE), host->ioaddr + CORE_VENDOR_SPEC);
+ config = readl_relaxed(host->ioaddr + CORE_VENDOR_SPEC);
+ config &= ~CORE_CLK_PWRSAVE;
+ writel_relaxed(config, host->ioaddr + CORE_VENDOR_SPEC);
/* Write 1 to DLL_RST bit of DLL_CONFIG register */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_DLL_RST), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_DLL_RST;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Write 1 to DLL_PDN bit of DLL_CONFIG register */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_DLL_PDN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_DLL_PDN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
msm_cm_dll_set_freq(host);
/* Write 0 to DLL_RST bit of DLL_CONFIG register */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- & ~CORE_DLL_RST), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config &= ~CORE_DLL_RST;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Write 0 to DLL_PDN bit of DLL_CONFIG register */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- & ~CORE_DLL_PDN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config &= ~CORE_DLL_PDN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Set DLL_EN bit to 1. */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_DLL_EN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_DLL_EN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Set CK_OUT_EN bit to 1. */
- writel_relaxed((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG)
- | CORE_CK_OUT_EN), host->ioaddr + CORE_DLL_CONFIG);
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_CK_OUT_EN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
/* Wait until DLL_LOCK bit of DLL_STATUS register becomes '1' */
while (!(readl_relaxed(host->ioaddr + CORE_DLL_STATUS) &
@@ -536,7 +545,7 @@ static int sdhci_msm_probe(struct platform_device *pdev)
struct resource *core_memres;
int ret;
u16 host_version, core_minor;
- u32 core_version, caps;
+ u32 core_version, config;
u8 core_major;
host = sdhci_pltfm_init(pdev, &sdhci_msm_pdata, sizeof(*msm_host));
@@ -605,8 +614,9 @@ static int sdhci_msm_probe(struct platform_device *pdev)
}
/* Reset the core and Enable SDHC mode */
- writel_relaxed(readl_relaxed(msm_host->core_mem + CORE_POWER) |
- CORE_SW_RST, msm_host->core_mem + CORE_POWER);
+ config = readl_relaxed(msm_host->core_mem + CORE_POWER);
+ config |= CORE_SW_RST;
+ writel_relaxed(config, msm_host->core_mem + CORE_POWER);
/* SW reset can take upto 10HCLK + 15MCLK cycles. (min 40us) */
usleep_range(1000, 5000);
@@ -636,9 +646,9 @@ static int sdhci_msm_probe(struct platform_device *pdev)
* controller versions and must be explicitly enabled.
*/
if (core_major >= 1 && core_minor != 0x11 && core_minor != 0x12) {
- caps = readl_relaxed(host->ioaddr + SDHCI_CAPABILITIES);
- caps |= SDHCI_CAN_VDD_300 | SDHCI_CAN_DO_8BIT;
- writel_relaxed(caps, host->ioaddr +
+ config = readl_relaxed(host->ioaddr + SDHCI_CAPABILITIES);
+ config |= SDHCI_CAN_VDD_300 | SDHCI_CAN_DO_8BIT;
+ writel_relaxed(config, host->ioaddr +
CORE_VENDOR_SPEC_CAPABILITIES0);
}
--
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project.
next prev parent reply other threads:[~2016-08-24 10:03 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-08-24 10:03 [PATCH v4 0/9] mmc: sdhci-msm: Add clk-rates and DDR support Ritesh Harjani
2016-08-24 10:03 ` Ritesh Harjani [this message]
2016-08-24 10:03 ` [PATCH v4 2/9] mmc: sdhci-msm: Update DLL reset sequence Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 3/9] mmc: sdhci-msm: add pltfm_data support to get clk-rates from DT Ritesh Harjani
2016-08-25 22:27 ` Stephen Boyd
2016-08-30 14:12 ` Ritesh Harjani
[not found] ` <1a44bb54-d88c-737d-7fb1-e7c3597ac03b-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2016-09-07 16:14 ` Stephen Boyd
2016-09-12 6:17 ` Ritesh Harjani
2016-10-04 9:33 ` Ritesh Harjani
2016-09-12 7:33 ` Arnd Bergmann
2016-09-27 5:06 ` Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 4/9] ARM: dts: qcom: Add clk-rates to sdhc1 & sdhc2 Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 5/9] mmc: sdhci-msm: Add get_min_clock() and get_max_clock() callback Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 6/9] mmc: sdhci-msm: Enable few quirks Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 7/9] mmc: sdhci-msm: Implement set_clock callback for sdhci-msm Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 8/9] mmc: sdhci-msm: Add clock changes for DDR mode Ritesh Harjani
2016-08-29 13:17 ` Adrian Hunter
2016-08-30 14:16 ` Ritesh Harjani
2016-08-24 10:03 ` [PATCH v4 9/9] arm64: dts: qcom: msm8916: Add ddr support to sdhc1 Ritesh Harjani
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1472033024-14890-2-git-send-email-riteshh@codeaurora.org \
--to=riteshh@codeaurora.org \
--cc=Yuliy.Izrailov@sandisk.com \
--cc=adrian.hunter@intel.com \
--cc=alex.lemberg@sandisk.com \
--cc=asutoshd@codeaurora.org \
--cc=bjorn.andersson@linaro.org \
--cc=david.griego@linaro.org \
--cc=georgi.djakov@linaro.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-mmc@vger.kernel.org \
--cc=mateusz.nowak@intel.com \
--cc=pramod.gurav@linaro.org \
--cc=shawn.lin@rock-chips.com \
--cc=stummala@codeaurora.org \
--cc=ulf.hansson@linaro.org \
--cc=venkatg@codeaurora.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).