From mboxrd@z Thu Jan 1 00:00:00 1970 From: Abhishek Sahu Subject: [PATCH v3 05/16] mtd: rawnand: qcom: remove dt property nand-ecc-step-size Date: Fri, 25 May 2018 17:51:33 +0530 Message-ID: <1527250904-21988-6-git-send-email-absahu@codeaurora.org> References: <1527250904-21988-1-git-send-email-absahu@codeaurora.org> Return-path: In-Reply-To: <1527250904-21988-1-git-send-email-absahu@codeaurora.org> Sender: linux-kernel-owner@vger.kernel.org To: Boris Brezillon Cc: David Woodhouse , Brian Norris , Marek Vasut , Richard Weinberger , Cyrille Pitchen , Miquel Raynal , linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org, linux-mtd@lists.infradead.org, Andy Gross , Archit Taneja , Abhishek Sahu List-Id: linux-arm-msm@vger.kernel.org QCOM NAND controller supports only one step size (512) so nand-ecc-step-size DT property is redundant. This property can be removed and ecc step size can be assigned with 512 value. Signed-off-by: Abhishek Sahu --- * Changes from v2: NEW CHANGE 1. Removed the custom logic and used the helper fuction. drivers/mtd/nand/raw/qcom_nandc.c | 11 ++--------- 1 file changed, 2 insertions(+), 9 deletions(-) diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c index b554fb6..b538390 100644 --- a/drivers/mtd/nand/raw/qcom_nandc.c +++ b/drivers/mtd/nand/raw/qcom_nandc.c @@ -2325,15 +2325,8 @@ static int qcom_nand_host_setup(struct qcom_nand_host *host) bool wide_bus; int ecc_mode = 1; - /* - * the controller requires each step consists of 512 bytes of data. - * bail out if DT has populated a wrong step size. - */ - if (ecc->size != NANDC_STEP_SIZE) { - dev_err(nandc->dev, "invalid ecc size\n"); - return -EINVAL; - } - + /* controller only supports 512 bytes of data in each step */ + ecc->size = NANDC_STEP_SIZE; wide_bus = chip->options & NAND_BUSWIDTH_16 ? true : false; if (ecc->strength >= 8) { -- QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation