[PATCH v3 4/8] scsi: ufs-qcom: Adjust bus bandwidth voting and unvoting

[PATCH v3 4/8] scsi: ufs-qcom: Adjust bus bandwidth voting and unvoting

[Can Guo]

The bus bandwidth voting is required to be done before the bus clocks
are enabled, and the unvoting is required to be done only after the bus
clocks are disabled.

Signed-off-by: Can Guo <cang@codeaurora.org>
---
 drivers/scsi/ufs/ufs-qcom.c | 57 +++++++++++++++++++++++++++++++--------------
 1 file changed, 39 insertions(+), 18 deletions(-)

diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
index c69c29a1c..85d7c17 100644
--- a/drivers/scsi/ufs/ufs-qcom.c
+++ b/drivers/scsi/ufs/ufs-qcom.c
@@ -38,7 +38,6 @@ enum {
 
 static struct ufs_qcom_host *ufs_qcom_hosts[MAX_UFS_QCOM_HOSTS];
 
-static int ufs_qcom_set_bus_vote(struct ufs_qcom_host *host, int vote);
 static void ufs_qcom_get_default_testbus_cfg(struct ufs_qcom_host *host);
 static int ufs_qcom_set_dme_vs_core_clk_ctrl_clear_div(struct ufs_hba *hba,
 						       u32 clk_cycles);
@@ -674,7 +673,7 @@ static void ufs_qcom_get_speed_mode(struct ufs_pa_layer_attr *p, char *result)
 	}
 }
 
-static int ufs_qcom_set_bus_vote(struct ufs_qcom_host *host, int vote)
+static int __ufs_qcom_set_bus_vote(struct ufs_qcom_host *host, int vote)
 {
 	int err = 0;
 
@@ -705,7 +704,7 @@ static int ufs_qcom_update_bus_bw_vote(struct ufs_qcom_host *host)
 
 	vote = ufs_qcom_get_bus_vote(host, mode);
 	if (vote >= 0)
-		err = ufs_qcom_set_bus_vote(host, vote);
+		err = __ufs_qcom_set_bus_vote(host, vote);
 	else
 		err = vote;
 
@@ -716,6 +715,35 @@ static int ufs_qcom_update_bus_bw_vote(struct ufs_qcom_host *host)
 	return err;
 }
 
+static int ufs_qcom_set_bus_vote(struct ufs_hba *hba, bool on)
+{
+	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
+	int vote, err;
+
+	/*
+	 * In case ufs_qcom_init() is not yet done, simply ignore.
+	 * This ufs_qcom_set_bus_vote() shall be called from
+	 * ufs_qcom_init() after init is done.
+	 */
+	if (!host)
+		return 0;
+
+	if (on) {
+		vote = host->bus_vote.saved_vote;
+		if (vote == host->bus_vote.min_bw_vote)
+			ufs_qcom_update_bus_bw_vote(host);
+	} else {
+		vote = host->bus_vote.min_bw_vote;
+	}
+
+	err = __ufs_qcom_set_bus_vote(host, vote);
+	if (err)
+		dev_err(hba->dev, "%s: set bus vote failed %d\n",
+				 __func__, err);
+
+	return err;
+}
+
 static ssize_t
 show_ufs_to_mem_max_bus_bw(struct device *dev, struct device_attribute *attr,
 			char *buf)
@@ -792,7 +820,7 @@ static int ufs_qcom_update_bus_bw_vote(struct ufs_qcom_host *host)
 	return 0;
 }
 
-static int ufs_qcom_set_bus_vote(struct ufs_qcom_host *host, int vote)
+static int ufs_qcom_set_bus_vote(struct ufs_hba *host, bool on)
 {
 	return 0;
 }
@@ -1030,8 +1058,7 @@ static int ufs_qcom_setup_clocks(struct ufs_hba *hba, bool on,
 				 enum ufs_notify_change_status status)
 {
 	struct ufs_qcom_host *host = ufshcd_get_variant(hba);
-	int err;
-	int vote = 0;
+	int err = 0;
 
 	/*
 	 * In case ufs_qcom_init() is not yet done, simply ignore.
@@ -1041,28 +1068,21 @@ static int ufs_qcom_setup_clocks(struct ufs_hba *hba, bool on,
 	if (!host)
 		return 0;
 
-	if (on && (status == POST_CHANGE)) {
+	if (on && (status == PRE_CHANGE)) {
+		err = ufs_qcom_set_bus_vote(hba, true);
+	} else if (on && (status == POST_CHANGE)) {
 		/* enable the device ref clock for HS mode*/
 		if (ufshcd_is_hs_mode(&hba->pwr_info))
 			ufs_qcom_dev_ref_clk_ctrl(host, true);
-		vote = host->bus_vote.saved_vote;
-		if (vote == host->bus_vote.min_bw_vote)
-			ufs_qcom_update_bus_bw_vote(host);
-
 	} else if (!on && (status == PRE_CHANGE)) {
 		if (!ufs_qcom_is_link_active(hba)) {
 			/* disable device ref_clk */
 			ufs_qcom_dev_ref_clk_ctrl(host, false);
 		}
-
-		vote = host->bus_vote.min_bw_vote;
+	} else if (!on && (status == POST_CHANGE)) {
+		err = ufs_qcom_set_bus_vote(hba, false);
 	}
 
-	err = ufs_qcom_set_bus_vote(host, vote);
-	if (err)
-		dev_err(hba->dev, "%s: set bus vote failed %d\n",
-				__func__, err);
-
 	return err;
 }
 
@@ -1238,6 +1258,7 @@ static int ufs_qcom_init(struct ufs_hba *hba)
 	ufs_qcom_set_caps(hba);
 	ufs_qcom_advertise_quirks(hba);
 
+	ufs_qcom_set_bus_vote(hba, true);
 	ufs_qcom_setup_clocks(hba, true, POST_CHANGE);
 
 	if (hba->dev->id < MAX_UFS_QCOM_HOSTS)
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

[PATCH v3 7/8] scsi: ufs-qcom: Delay specific time before gate ref clk

[Can Guo]

After enter hibern8, as UFS JEDEC ver 3.0 requires, a specific gating wait
time is required before disable the device reference clock. If it is not
specified, use the old delay.

Signed-off-by: Can Guo <cang@codeaurora.org>
---
 drivers/scsi/ufs/ufs-qcom.c | 13 ++++++++++---
 1 file changed, 10 insertions(+), 3 deletions(-)

diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
index 85d7c17..3b5b2d9 100644
--- a/drivers/scsi/ufs/ufs-qcom.c
+++ b/drivers/scsi/ufs/ufs-qcom.c
@@ -833,6 +833,8 @@ static int ufs_qcom_bus_register(struct ufs_qcom_host *host)
 
 static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
 {
+	unsigned long gating_wait;
+
 	if (host->dev_ref_clk_ctrl_mmio &&
 	    (enable ^ host->is_dev_ref_clk_enabled)) {
 		u32 temp = readl_relaxed(host->dev_ref_clk_ctrl_mmio);
@@ -845,11 +847,16 @@ static void ufs_qcom_dev_ref_clk_ctrl(struct ufs_qcom_host *host, bool enable)
 		/*
 		 * If we are here to disable this clock it might be immediately
 		 * after entering into hibern8 in which case we need to make
-		 * sure that device ref_clk is active at least 1us after the
+		 * sure that device ref_clk is active for specific time after
 		 * hibern8 enter.
 		 */
-		if (!enable)
-			udelay(1);
+		if (!enable) {
+			gating_wait = host->hba->dev_info.clk_gating_wait_us;
+			if (!gating_wait)
+				udelay(1);
+			else
+				usleep_range(gating_wait, gating_wait + 10);
+		}
 
 		writel_relaxed(temp, host->dev_ref_clk_ctrl_mmio);
 
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project