Re: [PATCH 0/2] arm64: dts: qcom: switch RB1 and RB2 platforms to i2c2-gpio

["Rob Herring (Arm)" <robh@kernel.org>]

On Tue, 04 Jun 2024 13:14:57 +0300, Dmitry Baryshkov wrote:
> On the Qualcomm RB1 and RB2 platforms the I2C bus connected to the
> LT9611UXC bridge under some circumstances can go into a state when all
> transfers timeout. This causes both issues with fetching of EDID and
> with updating of the bridge's firmware.
> 
> While we are debugging the issue, switch corresponding I2C bus to use
> i2c-gpio driver. While using i2c-gpio no communication issues are
> observed.
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
> ---
> Dmitry Baryshkov (2):
>       arm64: dts: qcom: qrb2210-rb1: switch I2C2 to i2c-gpio
>       arm64: dts: qcom: qrb4210-rb2: switch I2C2 to i2c-gpio
> 
>  arch/arm64/boot/dts/qcom/qrb2210-rb1.dts | 13 ++++++++++++-
>  arch/arm64/boot/dts/qcom/qrb4210-rb2.dts | 13 ++++++++++++-
>  2 files changed, 24 insertions(+), 2 deletions(-)
> ---
> base-commit: 0e1980c40b6edfa68b6acf926bab22448a6e40c9
> change-id: 20240604-rb12-i2c2g-pio-f6035fa8e022
> 
> Best regards,
> --
> Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
> 
> 
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


New warnings running 'make CHECK_DTBS=y qcom/qrb2210-rb1.dtb qcom/qrb4210-rb2.dtb' for 20240604-rb12-i2c2g-pio-v1-0-f323907179d9@linaro.org:

arch/arm64/boot/dts/qcom/qrb2210-rb1.dtb: /: i2c2-gpio: {'compatible': ['i2c-gpio'], 'sda-gpios': [[25, 6, 0]], 'scl-gpios': [[25, 7, 0]], '#address-cells': [[1]], '#size-cells': [[0]], 'status': ['okay'], 'clock-frequency': [[400000]], 'hdmi-bridge@2b': {'compatible': ['lontium,lt9611uxc'], 'reg': [[43]], 'interrupts-extended': [[25, 46, 2]], 'reset-gpios': [[25, 41, 0]], 'vdd-supply': [[107]], 'vcc-supply': [[108]], 'pinctrl-0': [[109, 110]], 'pinctrl-names': ['default'], '#sound-dai-cells': [[1]], 'ports': {'#address-cells': [[1]], '#size-cells': [[0]], 'port@0': {'reg': [[0]], 'endpoint': {'remote-endpoint': [[111]], 'phandle': [[92]]}}, 'port@2': {'reg': [[2]], 'endpoint': {'remote-endpoint': [[112]], 'phandle': [[106]]}}}}} is not of type 'array'
	from schema $id: http://devicetree.org/schemas/gpio/gpio-consumer.yaml#
arch/arm64/boot/dts/qcom/qrb4210-rb2.dtb: /: i2c2-gpio: {'compatible': ['i2c-gpio'], 'sda-gpios': [[43, 6, 0]], 'scl-gpios': [[43, 7, 0]], '#address-cells': [[1]], '#size-cells': [[0]], 'status': ['okay'], 'clock-frequency': [[400000]], 'hdmi-bridge@2b': {'compatible': ['lontium,lt9611uxc'], 'reg': [[43]], 'interrupts-extended': [[43, 46, 2]], 'reset-gpios': [[43, 41, 0]], 'vdd-supply': [[178]], 'vcc-supply': [[179]], 'pinctrl-0': [[180, 181]], 'pinctrl-names': ['default'], '#sound-dai-cells': [[1]], 'ports': {'#address-cells': [[1]], '#size-cells': [[0]], 'port@0': {'reg': [[0]], 'endpoint': {'remote-endpoint': [[182]], 'phandle': [[127]]}}, 'port@2': {'reg': [[2]], 'endpoint': {'remote-endpoint': [[183]], 'phandle': [[177]]}}}}} is not of type 'array'
	from schema $id: http://devicetree.org/schemas/gpio/gpio-consumer.yaml#
arch/arm64/boot/dts/qcom/qrb2210-rb1.dtb: i2c2-gpio: $nodename:0: 'i2c2-gpio' does not match '^i2c(@.*|-[0-9a-z]+)?$'
	from schema $id: http://devicetree.org/schemas/i2c/i2c-gpio.yaml#
arch/arm64/boot/dts/qcom/qrb2210-rb1.dtb: i2c2-gpio: Unevaluated properties are not allowed ('#address-cells', '#size-cells', 'clock-frequency', 'hdmi-bridge@2b' were unexpected)
	from schema $id: http://devicetree.org/schemas/i2c/i2c-gpio.yaml#
arch/arm64/boot/dts/qcom/qrb4210-rb2.dtb: i2c2-gpio: $nodename:0: 'i2c2-gpio' does not match '^i2c(@.*|-[0-9a-z]+)?$'
	from schema $id: http://devicetree.org/schemas/i2c/i2c-gpio.yaml#
arch/arm64/boot/dts/qcom/qrb4210-rb2.dtb: i2c2-gpio: Unevaluated properties are not allowed ('#address-cells', '#size-cells', 'clock-frequency', 'hdmi-bridge@2b' were unexpected)
	from schema $id: http://devicetree.org/schemas/i2c/i2c-gpio.yaml#