Re: [PATCH v4 0/3] usb: chipidea: msm: Clean and fix glue layer driver

[Peter Chen <peter.chen@freescale.com>]

On Mon, Apr 28, 2014 at 05:03:35PM +0300, Ivan T. Ivanov wrote:
> On Fri, 2014-04-25 at 03:10 +0000, Peter Chen wrote:
> >  
> > > 
> > > On Thu, 2014-04-24 at 08:38 +0800, Peter Chen wrote:
> > > > On Wed, Apr 23, 2014 at 03:28:01PM +0300, Ivan T. Ivanov wrote:
> > > > > From: "Ivan T. Ivanov" <iivanov@mm-sol.com>
> > > > >
> > > > > This series intend to fix driver, which was broken for a while.
> > > > > It is used to create peripheral role device, which in coordination
> > > > > with phy-usb-msm driver could provide USB2.0 gadget support for
> > > > > Qualcomm targets.
> > > > >
> > > > > Changes since version 3.
> > > > >
> > > > >  - Fix typo in devicetree description file.
> > > > >
> > > > > Previews version can be found here:
> > > >
> > > > Since in your phy's patchset, you also access portsc which is in
> > > > chipidea register region, it is not a standard way.
> > > > In case, you will change something at chipidea driver in future when
> > > > you re-work your next revision phy's patchset, I do not send this
> > > > patchset to Greg right now.
> > > >
> > > 
> > > Did you see problems with _this_ particular patch set? There is no direct
> > > dependency between PHY patches and these changes.
> > > 
> >  
> > I have not seen problems for this patch set, if you make sure the current
> > phy operation (eg, "phy_type) at chipidea core does not affect you,
> > I am glad to accept this.
> 
> You mean phy_mode? Peripheral functionality is tested on top of
> current linus/master and it looks fine.
> 

Applied, thanks

-- 

Best Regards,
Peter Chen