Linux ARM-MSM sub-architecture
 help / color / mirror / Atom feed
From: Rob Herring <robh@kernel.org>
To: Archit Taneja <architt@codeaurora.org>
Cc: linux-arm-msm@vger.kernel.org, dri-devel@lists.freedesktop.org,
	devicetree@vger.kernel.org
Subject: Re: [PATCH v3 12/12] dt-bindings: msm/dsi: Add DSIv2 documentation
Date: Fri, 4 Dec 2015 08:46:26 -0600	[thread overview]
Message-ID: <20151204144626.GA16243@rob-hp-laptop> (raw)
In-Reply-To: <1448964010-18207-13-git-send-email-architt@codeaurora.org>

On Tue, Dec 01, 2015 at 03:30:10PM +0530, Archit Taneja wrote:
> Add additional property info needed for DSIv2 DT.
> 
> Cc: devicetree@vger.kernel.org
> Cc: Rob Herring <robh@kernel.org>
> 
> Signed-off-by: Archit Taneja <architt@codeaurora.org>

Acked-by: Rob Herring <robh@kernel.org>

> ---
>  Documentation/devicetree/bindings/display/msm/dsi.txt | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/display/msm/dsi.txt b/Documentation/devicetree/bindings/display/msm/dsi.txt
> index e097955..e7423be 100644
> --- a/Documentation/devicetree/bindings/display/msm/dsi.txt
> +++ b/Documentation/devicetree/bindings/display/msm/dsi.txt
> @@ -21,10 +21,13 @@ Required properties:
>    * "byte_clk"
>    * "pixel_clk"
>    * "core_clk"
> +  For DSIv2, we need an additional clock:
> +   * "src_clk"
>  - vdd-supply: phandle to vdd regulator device node
>  - vddio-supply: phandle to vdd-io regulator device node
>  - vdda-supply: phandle to vdda regulator device node
>  - qcom,dsi-phy: phandle to DSI PHY device node
> +- syscon-sfpb: A phandle to mmss_sfpb syscon node (only for DSIv2)
>  
>  Optional properties:
>  - panel@0: Node of panel connected to this DSI controller.
> @@ -51,6 +54,7 @@ Required properties:
>    * "qcom,dsi-phy-28nm-hpm"
>    * "qcom,dsi-phy-28nm-lp"
>    * "qcom,dsi-phy-20nm"
> +  * "qcom,dsi-phy-28nm-8960"
>  - reg: Physical base address and length of the registers of PLL, PHY and PHY
>    regulator
>  - reg-names: The names of register regions. The following regions are required:
> -- 
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> hosted by The Linux Foundation
> 
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/dri-devel

      reply	other threads:[~2015-12-04 14:46 UTC|newest]

Thread overview: 52+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-10-14 12:58 [PATCH 00/12] drm/msm/dsi: Add support for DSI on MSM8960/APQ8064 Archit Taneja
2015-10-14 12:58 ` [PATCH 01/12] drm/msm/dsi: Update generated header for 8960 Archit Taneja
2015-10-14 12:58 ` [PATCH 02/12] drm/msm/dsi: Add support for 28nm PHY on 8960 Archit Taneja
2015-10-14 12:58 ` [PATCH 03/12] drm/msm/dsi: Add DSI PLL for 28nm 8960 PHY Archit Taneja
2015-10-14 20:35   ` Stephen Boyd
2015-10-16 13:08     ` Archit Taneja
2015-10-16 18:28       ` Stephen Boyd
2015-10-14 12:58 ` [PATCH 04/12] drm/msm/dsi: Use a better way to figure out DSI version Archit Taneja
2015-10-14 12:58 ` [PATCH 05/12] drm/msm/dsi: Delay dsi_clk_init Archit Taneja
2015-10-14 12:58 ` [PATCH 06/12] drm/msm/dsi: Parse bus clocks from a list Archit Taneja
2015-10-14 12:58 ` [PATCH 07/12] drm/msm/dsi: Set up link clocks for DSIv2 Archit Taneja
2015-10-14 12:59 ` [PATCH 08/12] drm/msm/dsi: Add dsi_cfg for APQ8064 Archit Taneja
2015-10-14 12:59 ` [PATCH 09/12] drm/msm/dsi: Don't use iommu for command TX buffer for DSIv2 Archit Taneja
2015-10-14 12:59 ` [PATCH 10/12] drm/msm/dsi: SFPB: Update generated headers Archit Taneja
2015-10-14 12:59 ` [PATCH 11/12] drm/msm/dsi: Enable MMSS SPFB port via syscon Archit Taneja
2015-10-14 12:59 ` [PATCH 12/12] dt-bindings: Add DSIv2 documentation Archit Taneja
2015-11-18 10:55 ` [PATCH v2 00/10] drm/msm/dsi: Add support for DSI on MSM8960/APQ8064 Archit Taneja
2015-11-18 10:55   ` [PATCH v2 01/10] drm/msm/dsi: Add support for 28nm PHY on 8960 Archit Taneja
2015-11-18 10:55   ` [PATCH v2 02/10] drm/msm/dsi: Add DSI PLL for 28nm 8960 PHY Archit Taneja
2015-11-18 10:55   ` [PATCH v2 03/10] drm/msm/dsi: Use a better way to figure out DSI version Archit Taneja
2015-11-18 10:55   ` [PATCH v2 04/10] drm/msm/dsi: Delay dsi_clk_init Archit Taneja
2015-11-18 10:55   ` [PATCH v2 05/10] drm/msm/dsi: Parse bus clocks from a list Archit Taneja
2015-11-18 10:55   ` [PATCH v2 06/10] drm/msm/dsi: Set up link clocks for DSIv2 Archit Taneja
2015-11-18 10:55   ` [PATCH v2 07/10] drm/msm/dsi: Add dsi_cfg for APQ8064 Archit Taneja
2015-11-18 10:55   ` [PATCH v2 08/10] drm/msm/dsi: Don't use iommu for command TX buffer for DSIv2 Archit Taneja
2015-11-18 10:55   ` [PATCH v2 09/10] drm/msm/dsi: Enable MMSS SPFB port via syscon Archit Taneja
2015-11-18 10:55   ` [PATCH v2 10/10] dt-bindings: Add DSIv2 documentation Archit Taneja
2015-11-18 13:18     ` Rob Herring
2015-11-18 15:24       ` Archit Taneja
     [not found]         ` <564C981F.3040907-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2015-11-20 19:59           ` Rob Herring
2015-11-23  6:13             ` Archit Taneja
2015-12-02  8:20               ` Stephen Boyd
2015-12-02  8:34                 ` Stephen Boyd
2015-12-07  6:51                   ` Archit Taneja
2015-12-02  9:56                 ` Archit Taneja
2015-12-03  7:16                   ` Stephen Boyd
2015-12-03 11:11                     ` Archit Taneja
2015-12-01  9:59   ` [PATCH v3 00/12] drm/msm/dsi: Add support for DSI on MSM8960/APQ8064 Archit Taneja
2015-12-01  9:59     ` [PATCH v3 01/12] drm/msm/dsi: Don't get byte/pixel source clocks from DT Archit Taneja
2015-12-01 10:00     ` [PATCH v3 02/12] drm/msm/dsi: Add support for 28nm PHY on 8960 Archit Taneja
2015-12-01 10:00     ` [PATCH v3 03/12] drm/msm/dsi: Add DSI PLL for 28nm 8960 PHY Archit Taneja
2015-12-01 10:00     ` [PATCH v3 04/12] drm/msm/dsi: Use a better way to figure out DSI version Archit Taneja
2015-12-01 10:00     ` [PATCH v3 05/12] drm/msm/dsi: Delay dsi_clk_init Archit Taneja
2015-12-01 10:00     ` [PATCH v3 06/12] drm/msm/dsi: Parse bus clocks from a list Archit Taneja
2015-12-01 10:00     ` [PATCH v3 07/12] drm/msm/dsi: Set up link clocks for DSIv2 Archit Taneja
2015-12-01 10:00     ` [PATCH v3 08/12] drm/msm/dsi: Add dsi_cfg for APQ8064 Archit Taneja
2015-12-01 10:00     ` [PATCH v3 09/12] drm/msm/dsi: Don't use iommu for command TX buffer for DSIv2 Archit Taneja
2015-12-01 10:00     ` [PATCH v3 10/12] drm/msm/dsi: Enable MMSS SPFB port via syscon Archit Taneja
2015-12-01 10:00     ` [PATCH v3 11/12] dt-bindings: msm/dsi: Fix the order in which clocks are listed Archit Taneja
2015-12-04 14:45       ` Rob Herring
2015-12-01 10:00     ` [PATCH v3 12/12] dt-bindings: msm/dsi: Add DSIv2 documentation Archit Taneja
2015-12-04 14:46       ` Rob Herring [this message]

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20151204144626.GA16243@rob-hp-laptop \
    --to=robh@kernel.org \
    --cc=architt@codeaurora.org \
    --cc=devicetree@vger.kernel.org \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=linux-arm-msm@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body. 
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox