Re: [PATCH v2 08/11] thermal: tsens: Check if the IP is correctly enabled by firmware

[Bjorn Andersson <bjorn.andersson@linaro.org>]

On Thu 30 Aug 12:23 PDT 2018, Amit Kucheria wrote:

> On Tue, Aug 28, 2018 at 7:08 PM, Amit Kucheria <amit.kucheria@linaro.org> wrote:
> > The SROT registers are initialised by the secure firmware at boot. We
> > don't have write access to the registers. Check if the block is enabled
> > before continuing.
> >
> > Signed-off-by: Amit Kucheria <amit.kucheria@linaro.org>
> > Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
> > ---
> >  drivers/thermal/qcom/tsens-common.c | 17 +++++++++++++++++
> >  1 file changed, 17 insertions(+)
> >
> > diff --git a/drivers/thermal/qcom/tsens-common.c b/drivers/thermal/qcom/tsens-common.c
> > index 0b8a793f15f4..d250b757d1f0 100644
> > --- a/drivers/thermal/qcom/tsens-common.c
> > +++ b/drivers/thermal/qcom/tsens-common.c
> > @@ -12,6 +12,11 @@
> >  #include <linux/regmap.h>
> >  #include "tsens.h"
> >
> > +/* SROT */
> > +#define CTRL_OFFSET            0x4
> 
> This OFFSET is not constant across the TSENS family and breaks atleast
> one platform in the test below. I have a patch to fix this for all
> platforms, will post it after a bit more testing.
> 

Afaict the other 10 patches can be merged independently of this patch.

So please make the minor updates and resend them as a separate series,
with the acks/reviews, to make it easier for Eduardo to just pick them.

Regards,
Bjorn

> 
> > +#define TSENS_EN               BIT(0)
> > +
> > +/* TM */
> >  #define STATUS_OFFSET          0x30
> >  #define SN_ADDR_OFFSET         0x4
> >  #define SN_ST_TEMP_MASK                0x3ff
> > @@ -119,6 +124,8 @@ int __init init_common(struct tsens_device *tmdev)
> >  {
> >         void __iomem *tm_base, *srot_base;
> >         struct resource *res;
> > +       u32 code;
> > +       int ret;
> >         struct platform_device *op = of_find_device_by_node(tmdev->dev->of_node);
> >
> >         if (!op)
> > @@ -151,5 +158,15 @@ int __init init_common(struct tsens_device *tmdev)
> >         if (IS_ERR(tmdev->tm_map))
> >                 return PTR_ERR(tmdev->tm_map);
> >
> > +       if (tmdev->srot_map) {
> > +               ret = regmap_read(tmdev->srot_map, CTRL_OFFSET, &code);
> > +               if (ret)
> > +                       return ret;
> > +               if (!(code & TSENS_EN)) {
> > +                       dev_err(tmdev->dev, "tsens device is not enabled\n");
> > +                       return -ENODEV;
> > +               }
> > +       }
> > +
> >         return 0;
> >  }
> > --
> > 2.17.1
> >