Re: [PATCH v3 3/6] mhi: pci_generic: Add SDX24 based modem support

[Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>]

On Fri, Mar 05, 2021 at 08:16:45PM +0100, Loic Poulain wrote:
> Add generic info for SDX24 based modems. Also add the FIREHOSE channels
> used by the flash-programmer firmware loaded in EDL mode.
> 
> Signed-off-by: Loic Poulain <loic.poulain@linaro.org>
> Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>

Applied to mhi-next!

Thanks,
Mani

> ---
>  v2: no change
>  v3: no change
> 
>  drivers/bus/mhi/pci_generic.c | 10 ++++++++++
>  1 file changed, 10 insertions(+)
> 
> diff --git a/drivers/bus/mhi/pci_generic.c b/drivers/bus/mhi/pci_generic.c
> index 45d0cf2..c274e65 100644
> --- a/drivers/bus/mhi/pci_generic.c
> +++ b/drivers/bus/mhi/pci_generic.c
> @@ -212,6 +212,14 @@ static const struct mhi_pci_dev_info mhi_qcom_sdx55_info = {
>  	.dma_data_width = 32
>  };
>  
> +static const struct mhi_pci_dev_info mhi_qcom_sdx24_info = {
> +	.name = "qcom-sdx24",
> +	.edl = "qcom/prog_firehose_sdx24.mbn",
> +	.config = &modem_qcom_v1_mhiv_config,
> +	.bar_num = MHI_PCI_DEFAULT_BAR_NUM,
> +	.dma_data_width = 32
> +};
> +
>  static const struct mhi_channel_config mhi_quectel_em1xx_channels[] = {
>  	MHI_CHANNEL_CONFIG_UL(0, "NMEA", 32, 0),
>  	MHI_CHANNEL_CONFIG_DL(1, "NMEA", 32, 0),
> @@ -254,6 +262,8 @@ static const struct mhi_pci_dev_info mhi_quectel_em1xx_info = {
>  static const struct pci_device_id mhi_pci_id_table[] = {
>  	{ PCI_DEVICE(PCI_VENDOR_ID_QCOM, 0x0306),
>  		.driver_data = (kernel_ulong_t) &mhi_qcom_sdx55_info },
> +	{ PCI_DEVICE(PCI_VENDOR_ID_QCOM, 0x0304),
> +		.driver_data = (kernel_ulong_t) &mhi_qcom_sdx24_info },
>  	{ PCI_DEVICE(0x1eac, 0x1001), /* EM120R-GL (sdx24) */
>  		.driver_data = (kernel_ulong_t) &mhi_quectel_em1xx_info },
>  	{ PCI_DEVICE(0x1eac, 0x1002), /* EM160R-GL (sdx24) */
> -- 
> 2.7.4
>