[PATCH 11/20] phy: qcom-qmp-ufs: clean up ready polling

[Johan Hovold <johan+linaro@kernel.org>]

Clean up the PHY ready polling by dropping the mask variables which are
no longer needed since the QMP driver split.

Signed-off-by: Johan Hovold <johan+linaro@kernel.org>
---
 drivers/phy/qualcomm/phy-qcom-qmp-ufs.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)

diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-ufs.c b/drivers/phy/qualcomm/phy-qcom-qmp-ufs.c
index 1c7d8fc9b94a..8380904cf26c 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp-ufs.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp-ufs.c
@@ -908,7 +908,7 @@ static int qmp_ufs_power_on(struct phy *phy)
 	void __iomem *rx = qphy->rx;
 	void __iomem *pcs = qphy->pcs;
 	void __iomem *status;
-	unsigned int mask, val, ready;
+	unsigned int val;
 	int ret;
 
 	qmp_ufs_serdes_init(qphy);
@@ -937,10 +937,7 @@ static int qmp_ufs_power_on(struct phy *phy)
 	qphy_setbits(pcs, cfg->regs[QPHY_START_CTRL], cfg->start_ctrl);
 
 	status = pcs + cfg->regs[QPHY_PCS_READY_STATUS];
-	mask = PCS_READY;
-	ready = PCS_READY;
-
-	ret = readl_poll_timeout(status, val, (val & mask) == ready, 10,
+	ret = readl_poll_timeout(status, val, (val & PCS_READY), 10,
 				 PHY_INIT_COMPLETE_TIMEOUT);
 	if (ret) {
 		dev_err(qmp->dev, "phy initialization timed-out\n");
-- 
2.35.1