[PATCH RFC 6/8] media: qcom: camss: csiphy-3ph: Use sdm845 C-PHY configuration sequence

[David Heidelberg via B4 Relay <devnull+david.ixit.cz@kernel.org>]

From: David Heidelberg <david@ixit.cz>

Enable the 3-phase (3PH) lane configuration introduced earlier when
C-PHY mode is requested on the SDM845 platform. This ensures the proper
initialization sequence is used for C-PHY operation.

Signed-off-by: David Heidelberg <david@ixit.cz>
---
 drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c b/drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c
index c2adbde6b4e0d..03f5c4676e89a 100644
--- a/drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c
+++ b/drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c
@@ -1103,8 +1103,14 @@ static void csiphy_lanes_enable(struct csiphy_device *csiphy,
 
 	switch (csiphy->camss->res->version) {
 	case CAMSS_845:
-		regs->lane_regs = &lane_regs_sdm845[0];
-		regs->lane_array_size = ARRAY_SIZE(lane_regs_sdm845);
+		if (c->cphy) {
+			regs->lane_regs = &lane_regs_sdm845_3ph[0];
+			regs->lane_array_size = ARRAY_SIZE(lane_regs_sdm845_3ph);
+
+		} else {
+			regs->lane_regs = &lane_regs_sdm845[0];
+			regs->lane_array_size = ARRAY_SIZE(lane_regs_sdm845);
+		}
 		break;
 	case CAMSS_2290:
 		regs->lane_regs = &lane_regs_qcm2290[0];

-- 
2.51.0