Linux ARM-MSM sub-architecture
 help / color / mirror / Atom feed
From: Joonhoe Kim <26rote@gmail.com>
To: Yongxing Mou <yongxing.mou@oss.qualcomm.com>
Cc: Rob Clark <robin.clark@oss.qualcomm.com>,
	Dmitry Baryshkov <lumag@kernel.org>,
	Abhinav Kumar <abhinav.kumar@linux.dev>,
	Sean Paul <sean@poorly.run>,
	Marijn Suijten <marijn.suijten@somainline.org>,
	David Airlie <airlied@gmail.com>, Simona Vetter <simona@ffwll.ch>,
	Jessica Zhang <jesszhan0024@gmail.com>,
	linux-arm-msm@vger.kernel.org, dri-devel@lists.freedesktop.org,
	freedreno@lists.freedesktop.org, linux-kernel@vger.kernel.org,
	Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>,
	Abel Vesa <abel.vesa@oss.qualcomm.com>
Subject: Re: [PATCH v9 00/29] drm/msm/dp: Add MST support for MSM chipsets
Date: Thu, 19 Nov 2026 20:54:05 +0900	[thread overview]
Message-ID: <20261119115405.162-1-26rote@gmail.com> (raw)
In-Reply-To: <20261119-msm-dp-mst-v9-0-ca61be4edfc3@oss.qualcomm.com>

On Thu, 19 Nov 2026, Yongxing Mou wrote:
> Add support for Multi-stream transport for MSM chipsets that allow
> a single instance of DP controller to send multiple streams.

Hi Yongxing,

On v7 I reported that s2idle hangs on resume with MST active, and you
said I could send the fix. I will not have time to follow it up as a
separate patch, so here it is for you to take into the series if it is
useful.

The series never calls drm_dp_mst_topology_mgr_suspend() or
drm_dp_mst_topology_mgr_resume(). While MST is active the link is kept
up after the last stream is disabled, so system suspend powers the
controller down with link_ready still set; on resume the first stream
enable skips link training, and the payload table write hangs retrying
AUX over a link that is down.

The fix suspends the topology manager and takes the link down before the
controller is suspended, and on resume initializes the PHY again and
resumes the topology manager (turning MST off with a hotplug event if
the branch device is gone). The version on top of v7 of this series is
here:

https://github.com/joonhoekim/tb323fu-linux/blob/0e73bc96d65386bee31cc003f2e76a2e9623f631/kernel/patches/0202-drm-msm-dp-suspend-and-resume-the-MST-topology-acros.patch

With it, a Lenovo Y700 Gen 5 (TB323FU, Kaanapali) with two displays on
an MST hub resumed from s2idle 3 times out of 3. On v9,
msm_dp_display_unprepare() should move into the patch's
msm_dp_mst_suspend() and run under mst_lock, as
msm_dp_mst_stream_post_disable() holds that lock when it calls it. If
post_disable starts taking the link down after the last stream
(Sashiko's comment on 18/29), only the topology manager suspend/resume
part is still needed. Feel free to take it under your own name or keep
my authorship.

Thanks,
Joonhoe Kim

      parent reply	other threads:[~2026-11-19 11:54 UTC|newest]

Thread overview: 31+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-11-19  8:24 [PATCH v9 00/29] drm/msm/dp: Add MST support for MSM chipsets Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 01/29] drm/msm/dp: skip sink requests while the mainlink clocks are off Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 02/29] drm/msm/dp: add support to send ACT packets for MST Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 03/29] drm/msm/dp: add support to enable MST in mainlink control Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 04/29] drm/msm/dp: no need to update tu calculation for mst Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 05/29] drm/msm/dp: always program MST_FIFO_CONSTANT_FILL for MST use cases Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 06/29] drm/msm/dp: add support for sending VCPF packets in DP controller Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 07/29] drm/msm/dp: add support for MST channel slot allocation Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 08/29] drm/msm/dp: replace power_on with active_stream_mask Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 09/29] drm/msm/dp: factor out _helper variants of bridge ops accepting a panel Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 10/29] drm/msm/dp: add link_ready to manage link-level operations Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 11/29] drm/msm/dp: add msm_dp_display_get_panel() to initialize DP panel Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 12/29] drm/msm/dp: introduce dp_mst_drm module Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 13/29] drm/msm/dp: add MST connector creation and topology callbacks Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 14/29] drm/msm/dpu: pass msm_display_info to dpu_encoder_get_intf() Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 15/29] drm/msm/dpu: use stream_id to select MST interfaces Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 16/29] drm/msm/dpu: add per-stream MST encoders Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 17/29] drm/msm/dp: move link capabilities to dp_link Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 18/29] drm/msm/dp: add atomic stream handling for MST Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 19/29] drm/bridge_connector: suppress hotplug for IRQ_HPD without status changes Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 20/29] drm/bridge_connector: avoid detect-based HPD notifications for DisplayPort Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 21/29] drm/msm/dp: add HPD callback for dp MST Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 22/29] drm/msm/dp: wire MST helpers into atomic check and commit paths Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 23/29] drm/msm/dp: mark the SST bridge disconnected when mst is active Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 24/29] drm/msm/dp: enable MST on capable sinks Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 25/29] drm/msm/dp: mark the SST bridge disconnected when an MST-capable sink is present Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 26/29] drm/msm/dp: wake threaded handler for HPD IRQs Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 27/29] drm/msm/dp: ignore IRQ HPD latched together with an unplug Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 28/29] drm/msm/dp: select MST stream bpp during atomic check Yongxing Mou
2026-11-19  8:24 ` [PATCH v9 29/29] soc: qcom: pmic-glink-altmode: skip retimer reset on DP IRQ Yongxing Mou
2026-11-19 11:54 ` Joonhoe Kim [this message]

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20261119115405.162-1-26rote@gmail.com \
    --to=26rote@gmail.com \
    --cc=abel.vesa@oss.qualcomm.com \
    --cc=abhinav.kumar@linux.dev \
    --cc=airlied@gmail.com \
    --cc=dmitry.baryshkov@oss.qualcomm.com \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=freedreno@lists.freedesktop.org \
    --cc=jesszhan0024@gmail.com \
    --cc=linux-arm-msm@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=lumag@kernel.org \
    --cc=marijn.suijten@somainline.org \
    --cc=robin.clark@oss.qualcomm.com \
    --cc=sean@poorly.run \
    --cc=simona@ffwll.ch \
    --cc=yongxing.mou@oss.qualcomm.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox