Re: [PATCH v4 9/9] arm64: dts: qcom: sa8775p-ride: enable the BT UART port

[Konrad Dybcio <konrad.dybcio@linaro.org>]

On 8.03.2023 11:40, Bartosz Golaszewski wrote:
> From: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
> 
> Enable the high-speed UART port connected to the Bluetooth controller on
> the sa8775p-adp development board.
> 
> Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
> ---
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>

Konrad
>  arch/arm64/boot/dts/qcom/sa8775p-ride.dts | 33 +++++++++++++++++++++++
>  1 file changed, 33 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/sa8775p-ride.dts b/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
> index cba7c8116141..1020dfd21da2 100644
> --- a/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
> +++ b/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
> @@ -14,6 +14,7 @@ / {
>  	aliases {
>  		serial0 = &uart10;
>  		serial1 = &uart12;
> +		serial2 = &uart17;
>  		i2c18 = &i2c18;
>  		spi16 = &spi16;
>  	};
> @@ -93,6 +94,32 @@ qup_uart12_rx: qup-uart12-rx-pins {
>  			bias-pull-down;
>  		};
>  	};
> +
> +	qup_uart17_default: qup-uart17-state {
> +		qup_uart17_cts: qup-uart17-cts-pins {
> +			pins = "gpio91";
> +			function = "qup2_se3";
> +			bias-disable;
> +		};
> +
> +		qup_uart17_rts: qup0-uart17-rts-pins {
> +			pins = "gpio92";
> +			function = "qup2_se3";
> +			bias-pull-down;
> +		};
> +
> +		qup_uart17_tx: qup0-uart17-tx-pins {
> +			pins = "gpio93";
> +			function = "qup2_se3";
> +			bias-pull-up;
> +		};
> +
> +		qup_uart17_rx: qup0-uart17-rx-pins {
> +			pins = "gpio94";
> +			function = "qup2_se3";
> +			bias-pull-down;
> +		};
> +	};
>  };
>  
>  &uart10 {
> @@ -108,6 +135,12 @@ &uart12 {
>  	status = "okay";
>  };
>  
> +&uart17 {
> +	pinctrl-0 = <&qup_uart17_default>;
> +	pinctrl-names = "default";
> +	status = "okay";
> +};
> +
>  &xo_board_clk {
>  	clock-frequency = <38400000>;
>  };